Assessments - 0, GPA: 0
(
)
)
|
Facilidade de uso
Caution: Do not install a lower version of software than the current version installed on your product. TP Vision cannot be held liable or be made responsible for problems caused by a software downgrade. Update with USB Before you update the software, make sure that you have: · A USB storage device that has at least 256 megabytes of storage space, is FAT or DOS formatted and has its write protection disabled. · Access to a computer with a USB connector and Internet access Navigate to and follow the software update instructions. Automatic update from digital broadcast While the TV is connected to an aerial signal. If Automatic scanning in the Upgrade Options menu is enabled, the TV wakes up at 03:00 and searches broadcast channels for new software upgrades. If new software is found and downloaded successfully, the next time the TV powers up , it will have the new software version. Note: If the TV fails to come on after the upgrade unplug the TV for 2 minutes and plug in again. - 5 Troubleshooting TV will not turn on Make sure the power cord is plugged in securely to wall outlet. The batteries in the remote control may be exhausted. Press the Power button on the TV. Poor picture • Have you selected the correct TV system? • Low signal level can cause picture distortion.Please check antenna access. • Check if you have entered the correct channel frequency if you have done manual tuning. • The picture quality may degrade when two devices are connected to the TV at the same time. In such a case, disconnect one of the devices. No picture • No Picture means that your TV is not receiving a transmission. Have you selected the correct button on the remote control? Try once more. Also make sure the correct input source has been selected. • Is the antenna connected properly? • Is the antenna cable damaged? • Are suitable plugs used to connect the antenna? • If you are in doubt, consult your dealer. No sound • Has the TV been set to mute? To cancel mute, press the “ ” button, or increase the volume level. • Sound is coming from only one speaker. Is the balance set to one extreme? See Sound Menu section. Remote control - does not operate • The batteries may be exhausted. Replace the bateries. Input sources - can not be selected • If you cannot select an input source, it is possible that no device is connected. • Check the AV cables and connections if you have tried to connect a device. Recording unavailable To record a program, connect a USB disk to your TV while the TV is switched off. Then switch on the TV to enable the recording feature. If you cannot record, try switching off the TV and then re-inserting the USB device. USB is too slow If the “USB is too slow” message is displayed on screen at the start of a recording, try restarting the process. If you still get the same error, it is possible that your USB flash drive is not USB 2.0 compatible. Specifications PC input typical display modes The following table is an illustration of some of the typical video display modes. Your TV may not support all resolutions. Your TV supports up to 1920x1080. Index Resolution Frequency 1 640x350p 60 Hz 2 640x400p 60 Hz 3 1024x768 60 Hz 4 1280x768 60 Hz 5 1360x768 60 Hz 6 720x400 60 Hz 7 800x600 56 Hz 8 800x600 60 Hz 9 1024x768 60 Hz 10 1024x768 66 Hz 11 1280x768 60 Hz 12 1360x768 60 Hz 13 1280x1024 60 Hz 14 1280x960 60 Hz 15 1280x1024 60 Hz 16 1400x1050 60 Hz 17 1600x1200 60 Hz 18 1920x1080 60 Hz English - 6 Source Supported Signals Available EXT PAL 50/60 O NTSC 60 O (SCART) RGB 50 O RGB 60 O PAL 50/60 O Side AV NTSC 60 O 480I, 480P 60Hz O 576I, 576P 50Hz O PC/ YPbPr 720P 50Hz,60Hz O 1080I 50Hz,60Hz O 1080P 50Hz,60Hz O 480I 60Hz O 480P 60Hz O HDMI1 576I, 576P 50Hz O 720P O HDMI2 50Hz,60Hz 1080I 50Hz,60Hz O 1080P 24Hz, 25Hz O30Hz, 50Hz, 60Hz AV and HDMI signal compatibility TV Broadcasting PAL B/G D/K K Receiving Channels VHF (BAND I/III) -UHF (BAND U) - HYPERBAND Number of Preset 1000 Channels Channel Indicator On Screen Display RF Aerial Input 75 Ohm (unbalanced) Operating Voltage 220-240V AC, 50Hz. Audio German+Nicam Stereo Audio Output Power 2x8 W (WRMS.) (10% THD) Power Consumption 95 W Weight 9,50 TV Dimensions DxLxH 220 x 898 x 577 (with foot) TV Dimensions DxLxH 41 x 898 x 538 (without foot) Display 39” inch Operation temperature 5.C up to 45.C, 85% humidity and operation max humidity: English - 7 Supported file formats in USB mode Media Extension Format Notes Video Audio Movie dat, mpg, Mpeg1,2 MPEG1/2 Layer 1/2/3, AAC/HEAAC, 1080P@ 30fps 50Mbit/ mpeg AC3/EAC3, LPCM/ADPCM sec dat, mpg, MPEG2 ,H.264, VC1, AVS, MPEG1/2 Layer 1/2/3, AAC/HEAAC, H.264:1080Px2@25fps mpeg MVC AC3/EAC3, LPCM/ADPCM 1080P@ 50fps MVC: 1080P@ 24fps Other: 1080P@ 30fps” 50Mbit/ sec .vob MPEG2 MPEG1/2 Layer 1/2/3, AC3, LPCM 1080P@ 30fps 50Mbit/ sec .mkv MPEG1,2,4, XviD, MPEG1/2 Layer 1/2/3, AAC/HEAAC, H.264:1080Px2@25fps 1080P@ 50fps H.264, AC3/EAC3, LPCM Other:1080P@ 30fps VC1,WMV3, 50Mbit/sec Motion JPEG .mp4 .mov MPEG1/2 Laye...