Assessments - 2, GPA: 5
(
)
)
|
Facilidade de uso
•To prevent the enclosure from warping or discoloring, do not place the speaker where it will be exposed to direct sunlight or excessive humidity. • Do not place the following objects on the speaker: Glass, china, etc. If glass etc. falls by vibrations and breaks, it may cause personal injury. A burning candle etc. If the candle falls by vibrations, it may cause fire and personal injury. A vessel with water in it If the vessel falls by vibrations and water spills, it may cause damage to the speaker, and/or you may get an electric shock. • Do not place the speaker where foreign objects such as water drips might fall. It might cause a fire, damage to the speaker, and/or personal injury. • Do not place the speaker where it is liable to be knocked over or struck by falling objects. Stable placement will also ensure better sound performance. • Placing the speaker on the same shelf or rack as the turntable can result in feedback. • Any time you note distortion, reduce the volume control on your amplifier to a lower setting. Never allow your amplifier to be driven into “clipping”. Otherwise the speaker may be damaged. • When using an amplifier with a rated output power higher than the nominal input power of the speaker, care should be taken never to exceed the speaker’s maximum input. • Do not attempt to clean the speaker with chemical solvents as this might damage the finish. Use a clean, dry cloth. • Do not attempt to modify or fix the speaker. Contact qualified YAMAHA service personnel when any service is needed. The cabinet should never be opened for any reasons. • Secure placement or installation is the owner’s responsibility. YAMAHA shall not be liable for any accident caused by improper placement or installation of the speaker. DeutschFrancais EspanolEnglish Supplied Accessories Fastener x 4 E-1 PLACING THE SPEAKER Place the speaker on TV whose top is flat or on the floor under the TV or inside the TV rack so that it is stabilized. When placing the speaker on top of the TV, to prevent the speaker from falling down, put the provided fasteners at four points on the bottom of the speaker and the top of the TV. surround back Notes • Do not place the speaker on top of the TV whose area is • Thoroughly wipe clean the surface where the fastener is to be smaller than the bottom area of the speaker. If placed, applied. Note that adhesive strength is weakened if the surface is the speaker may drop out causing an injury to you. dirty, oily or wet and that this may cause the center speaker to drop. • Do not place the speaker on top of the TV with an • This speaker features a magnetically shielded design, but inclination. there is still a chance that placing it too close to a TV set • Do not touch the adhesive surface after peeling off might impair picture color or create a buzzing noise. Should the seal as this will weaken its adhesive strength. this happen, move the speaker away from the TV set. Front L NS-C325 Center Front R surround Subwoofer 1 2 Fastener CONNECTIONS TO YOUR AMPLIFIER Before making connections, make sure that the amplifier is switched off. ¦CONNECTIONS • Connect the screw-type input terminals at the rear of the speaker to the speaker output terminals of the amplifier (or receiver) with the speaker cable. • Connect the (+) terminals on the amplifier (or receiver) and the speaker using one side of the cable. Connect the (–) terminals on both components using the other side of the cable. • Connect the speaker to the center terminals of your amplifier, making sure not to reverse the polarity (+, –). If the speaker is connected with reversed polarity, the sound will be unnatural and lack bass. How to connect: 1 Loosen the knob. 2 Remove the insulation coating at the extremity of each speaker cable by twisting the coating off. 3 Insert the bare wire. 4 Tighten the knob and secure the cables. Test the firmness of the connection by pulling lightly on the cables at the terminal. Note: Amplifier or Do not let the bare speaker wires touch each other as this Receiver could damage the speaker or the amplifier, or both of them. + – – CENTER + NS-C325 Tighten Black (–) Red (+) Loosen REMOVING THE FRONT COVER When using a banana plug The front cover is fastened to the enclosure at four points and can be removed if desired. To remove the cover, hold on to both sides and slowly pull straight away from the speaker. To reattach, line up the four holes on the inner surface of the cover with the four corresponding pegs on the speaker and push gently. Note: When the cover is removed, take care not to touch thespeaker units with your hands or to exert excessiveforce with tools. 3 2 1 Remove the cover by pulling it toward you. 2 Tighten the terminal knob. 3 Simply insert the banana plug into the terminal. Banana plug 1 SPECIFICATIONS Type .............. 2-way acoustic suspension speaker system Magnetic shielding type Driver ...................................... 10 cm (4”) cone woofer x 2 3 cm (1”) dome tweeter Impedance .....