Assessments - 0, GPA: 0
(
)
)
|
por este dispositivo também tem outras instruções :
Facilidade de uso
Setting the speakers using the optional speaker stands (F) For greater flexibility in the positioning of the speakers, use the optional WS-FV11 or WS-WV10D speaker stand (available only in certain countries). To hang the front, center and surround speakers with a hook (not supplied) on the wall (G) You are responsible for the proper selection and use of mounting hardware that you purchase at hardware stores, and for the proper and safe mounting of the speakers. Tip The height of the front speakers should be adjusted to about the center of the TV screen (H). Setting the amplifi er When connecting to an amplifier with internal multi channel decoders (Dolby Digital, DTS**, etc.), you should use the setup menus for the amplifier to specify the parameters of your speaker system. See the table below for the proper settings. For details on the setting procedure, refer to the manual that was provided with your amplifi er. Speaker setup For Set to Front speakers SMALL Center speaker SMALL Surround speakers SMALL Subwoofer ON (or YES) If you use the amplifier with adjustable crossover frequency, it is recommended to select 150 Hz (or close to this fi gure) as the crossover frequency for your front, center and surround speakers. ** “DTS” and “DTS Digital Surround” are registered trademarks of Digital Theater Sys tems, Inc. Listening to the sound (I) First, turn down the volume on the amplifi er. The volume should be set to minimum before you begin playing the program source. 1 Turn on the amplifier and select the program source. 2 Press POWER on the subwoofer. The POWER indicator on the subwoofer lights up green. 3 Play the program source. Note (Singaporean model only) Protection circuit is contained in the satellite speakers. If the speakers are overdriven for certain minutes, the protection circuit will automatically reduce the sound volume. In the case, stop the program source for 2-3 minutes. Before playing the source again, turn down the volume level of the amplifi er. Adjusting the subwoofer (I) Rotate LEVEL to adjust the volume. Set the volume level to best suit your pref er ence according to the program source. Notes • Some amplifier functions for enhancing the sound may cause distortion in the subwoofer. If such distortion occurs, turn off those functions. • To enjoy high-quality sound, do not turn the subwoofer volume too high. F G Hook Crochet WS-FV11 WS-WV10D (for front, center and surround speakers) (pour les enceintes avant, centrale et a effet surround) Troubleshooting Should you encounter a problem with your speaker system, check the following list and take the indicated measures. If the problem persists, consult your nearest Sony dealer. There is no sound from the speaker system. • Make sure all the connections have been correctly made. • Make sure the volume on the amplifier has been turned up properly. • Make sure the program source selector on the amplifier is set to the proper source. • Check if headphones are connected. If they are, disconnect them. There is distortion in the subwoofer sound output. • Check if any sound-enhancing functions have been activated on the amplifier. If they have, turn them off. There is hum or noise in the speaker output. • Make sure all the connections have been correctly made. • Make sure none of the audio components are positioned too close to the TV set. The sound has suddenly stopped. • Make sure all the connections have been correctly made. Contact between bare speaker wires at the speaker terminals may cause a short circuit. Specifi cations SS-MS155 (front, center and surround speakers) Speaker system Full range, magnetically shielded Speaker units 7 cm, cone type Enclosure type Closed type Rated impedance 8 ohms Power handling capacity Maximum input power: 100 W Sensitivity level 83 dB (1 W, 1 m) Frequency range 120 Hz - 20,000 Hz Dimensions (w/h/d) Approx. 91 . 96 . 102 mm, including front grille Mass Approx. 650 g each SA-WMS155 (subwoofer) Speaker system Active subwoofer, magnetically shielded Speaker unit Woofer: 16 cm, cone type Enclosure type Bass refl ex Reproduction frequency range 32 Hz - 200 Hz Continuous RMS power output 55 W (4 ohms, 100 Hz, 10 % THD) Input LINE IN (input pin jack) General Power requirements 220 - 240 V AC, 50/60 Hz Power consumptions 45 W Dimensions (w/h/d) Singaporean model: Approx. 210 . 355 . 335 mm Other models: Approx. 210 . 355 . 330 mm Mass Approx. 8 kg Supplied accessories Foot pads (20) Audio connecting cord (1) Speaker connecting cords, 10 m (2) Speaker connecting cords, 3.5 m (3) Design and specifications are subject to change without notice. Francais AVERTISSEMENT Pour eviter tout risque d’incendie ou d’electrocution, ne pas exposer cet appareil a la pluie ou a l’humidite. Pour prevenir tout risque d’incendie, ne couvrez pas les orifi ces d’aeration de l’appareil avec des journaux, nappes, rideaux, etc., et ne placez pas de bougies allumees sur l’appareil. Pour prevenir tout risque d’incendie ou d’electrocution, ne pose...