Assessments - 0, GPA: 0
(
)
)
|
Facilidade de uso
**“DTS” and “DTS Digital Surround” are registered trademarks of Digital Theater System, Inc. A B B F WS-WV10C (for rear speakers) WS-FV10C WS-TV10C Listening to the sound (H) First, turn down the volume on the amplifier. The volume should be set to minimum before you begin playing the program source. 1 Turn on the amplifier and select the program source. 2 Press POWER on the subwoofer. The ON/STANDBY indicator on the subwoofer lights up green. 3 Play the program source. Power turns on and off automatically — Auto power on/off function (I) When the subwoofer is on (i.e, the ON/STANDBY indicator lights up green) and there is no signal input for a few minutes, the ON/STANDBY indicator changes to red and the subwoofer enters power saving mode. While in this mode a signal is input to the subwoofer, the subwoofer automatically turns on (auto power on/off function). To turn this feature off, slide the POWER SAVE switch on the rear panel to OFF. Note If you turn down the volume level of the amplifier too low, the auto power on/off function may activate, causing the subwoofer to enter power saving mode. Adjusting the subwoofer (H) 1 Set MODE. The bass sound is enhanced in MOVIE mode rather than in MUSIC mode. Select your desired mode according to the following: Source MODE DVD, LD, video cassette MOVIE or other video source SACD, CD, MD, cassette tape MUSIC or other audio source 2 Rotate LEVEL to adjust the volume. Set the volume level to best suit your prefer ence according to the program source. Changing the phase (PHASE) (J) You can change the phase of the subwoofer using the PHASE switch on the rear of the subwoofer. Normally select REVERSE. Slide the PHASE switch to the position that enhances the bass sound (around 120Hz) more. The effect differs depending on the location of the speakers (relative distance from the listening position to the speakers or the subwoofer) and acoustics of your room. Notes • Some amplifier functions for enhancing the sound may cause distortion in the subwoofer. If such distortion occurs, turn off those functions. • To enjoy high-quality sound, do not turn the subwoofer volume too high. • The bass sound is enhanced in MOVIE mode rather than in MUSIC mode. Therefore, if you change the mode to MOVIE while listening to some sources that do not include the bass sound, you may not be able to get the effect. 3 G H POWER SAVE AUTO OFF PHASE REVERSE NORMAL POWER ON / STANDBY LEVEL MODE MIN MAX MOVIE MUSIC ON/STANDBY indicator POWER LEVEL MODE I J Troubleshooting Should you encounter a problem with your speaker system, check the following list and take the indicated measures. If the problem persists, consult your nearest Sony dealer. There is no sound from the speaker system. •Make sure all the connections have been correctly made. •Make sure the volume on the amplifier has been turned up properly. •Make sure the program source selector on the amplifier is set to the proper source. •Check if headphones are connected. If they are, disconnect them. There is distortion in the subwoofer sound output. •Check if any sound-enhancing functions have been activated on the amplifier. If they have, turn them off. •Your amplifier setting may be set wrongly. Confirm the speaker setting of the amplifier. There is hum or noise in the speaker output. •Make sure all the connections have been correctly made. •Make sure none of the audio components are positioned too close to the TV set. The sound has suddenly stopped. •Make sure all the connections have been correctly made. Contact between bare speaker wires at the speaker terminals may cause a short-circuit. Specifications SA-VE835ED For the U.S. model AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: with 3.75 ohm loads both channels driven, from 20 - 200 Hz; rated 200 watts per channel minimum RMS power, with no more than 0.8% total harmonic distortion from 250 milliwatts to rated output. SS-MS835 (front, center, and rear speakers) Speaker system 2 way, magnetically shielded Speaker units Tweeter: 1.9 cm (3/4 in.), dome type Woofer: 5.7 cm (2 1/4 in.) . 2, cone type Enclosure type Bass reflex Rated impedance 8 ohms Power handling capacity Maximum input power: 140 W Sensitivity level 87 dB (1 W, 1 m) Frequency range 120 Hz - 70,000 Hz Dimensions (w/h/d) When attached speaker grilles: Approx. 90 . 182 . 147 mm (3 5/8 . 7 1/4 . 5 7/8 in.) each When attached to supplied speaker stand: Approx. 97 . 220 . 158 5mm (3 7/8 . 8 3/4 . 6 1/4 in.) each, (Front (and rear) speakers) Approx. 182 . 145 . 163 mm (7 1/. 5 3/. 6 1/ 4 4 2 in.), (Center speaker: pointed upwards) Approx. 182 . 123 . 163 mm (7 1/4 . 4 7/8 . 6 1/2 in.), (Center speaker: pointed downwards) Mass When attached speaker grilles: Approx. 1.3 kg (2 lb 14 oz) each When attached to supplied speaker stand: Approx. 1.4 kg (3 lb 1 oz) each, (Front (and rear) speakers) Approx. 1.4 kg (3 lb 1 oz), (Center speaker) SA-WMS835 (subwoofer) Speaker system Active subwoofer, magnetically shielded Spe...