Remove speaker grille and place speaker face down. 2. Locate the speaker wire and pull through the ceiling opening. 3. Connect the speaker wire. BE SURE TO OBSERVE CORRECT POLARITY! 4. Insert the speaker into the opening in the ceiling (or Rough-in Bracket opening) and care- fully tighten each of the four clamping screws, alternating diagonally between each screw position to ensure proper fit. 5. Once the speaker is mounted in the ceiling, twist the baffle to aim the mid-range driver at the list

If you must cross high-voltage lines, always do so at a 90 degree angle to avoid audible hum through the speakers!. Note 3: When pre-wiring for In-wall speakers, it is essential to make direct wire runs from the head-end to each speaker. Do not run speaker wires in series or parallel, and do not “daisy-chain” speakers to common wiring. ©2007 • All rights reserved. © 2007 • All rights reserved. 7 Storm Series In-wall Speakers Pre-Wiring The audio/speaker cable runs should be routed from the head-

75 Watts Cutout Dimensions ................................................................................................. 7-1/8" x 12-1/4" (181mm x 311mm) Outer Frame Dimensions ................................................................................ 8-5/8" x 13-13/16" (218mm x 351mm) Mounting Depth ............................................................................................................................................ 3-5/16” (83mm) Pre-Construction Bracket .......

100 Watts Cutout Dimensions ................................................................................................. 7-1/8" x 12-1/4" (181mm x 311mm) Outer Frame Dimensions ................................................................................ 8-5/8" x 13-13/16" (218mm x 351mm) Mounting Depth ...............................................................................................................................................3-3/4” (94mm) Pre-Construction Bracket .....

Note: A stud-fi nding device may not detect pipes, wiring, or other obstructions located behind the drywall. 2. Use the inside portion of the speaker cutout template (included in packaging) to confi rm speaker placement. 3. Remove templates and drill or carefully punch a pilot hole in the wall. A bent piece of wire or a coat hanger may be use to probe the stud bay for obstructions. If you experience resistance of any kind–STOP! If any obstructions are detected, patch the pilot hole and try again

This application provides the best sound quality, staging, and depth possible in areas with a defi ned listening position. Figure 2.1 shows an example of a stereo listening area. X Figure 2.1 - Stereo Application Home Theater ATON IN-wall Speakers provide unobtrusive, high-quality Home Theater sound when installed in the correct locations. It is critical to identify the primary listening position before installation! See Figure 2.2 for a system design utilizing in-wall speakers with an active su

91dB Frequency Response ........................................................................................................................................34Hz to 20kHz Power Handling ....................................................................................................................................................... 115 Watts Cutout Dimensions ...................................................................................................................................

92dB Frequency Response ........................................................................................................................................34Hz to 20kHz Power Handling ....................................................................................................................................................... 115 Watts Cutout Dimensions ...................................................................................................................................

BK8C A82C System Type ....................................................................................................................................................................... 2-Way Woofer ................................................................................................................................. 8" Injection Molded graphite (IMG) Tweeter ............................................................................................................................

92dB Frequency Response ........................................................................................................................................32Hz to 22kHz Power Handling ....................................................................................................................................................... 125 Watts Cutout Dimensions ...................................................................................................................................