Assessments - 3, GPA: 4
(
)
)
|
Facilidade de uso
V-H screw position (V-22,5° -45° -67.5° -H) is wrong.. Fix the unit securely. Check the V-H screws position. (See page 23.) Set the V-H screw by mounting angle (V,22.5° ,45° ,67.5°, H). Inverted sound (Left/Right connections) The speaker cords or RCA extension cords are inverted. Check the speaker cords or RCA extension cords. Sound distorted sometimes. The compact disc may be defective. Try replacing the disc with another one. The compact disc is dirty. Try to clean the compact disc by following instructions on page 19. The disc magazine is not ejected. The disc magazine may be defective. Contact your nearest authorized dealer. No sound can be heard when CD Play button of CD Changer Control Receiver/Cassette Player is pressed. CD magazine is not inserted correctly. Insert CD magazine again. CX-DP610EUC IC/) System Diagram Various types of speakers are available from your dealer. Select the speakers that suit your CD Changer Unit. □ Basic Example of System Configuration □ Another Example of System Configuration (CD Receiver) Front Right Speaker Front Left Speaker Rear Right Speaker Rear Left Speaker Front Right Speaker Front Left Speaker Rear Right Speaker Rear Left Speaker Sub-woofer Speaker Note: In addition to the above system diagrams, please consult your dealer. 12 CX-DP610EUC Installation □ Precautions If possible, this equipment should be professionally installed. In case of difficulty' please consult with your nearest professional installer. 1. This unit operates only in a 12-volt DC negative ground system. 2. Before performing installation and wiring, remove the negative (-) terminal of the battery. (See Note Below.) Note: Do not disconnect the negative battery terminal in vehicles with trip or navigational computers. All electronic memory settings previously registered will be lost. Take extra care to avoid short circuiting when installing the unit. 3. Insulate all exposed wires to prevent short circuiting. 4. Secure all loose wires after installing the unit. 5. First, connect the extension cord © (supplied) (See page 18) to the CD changer and then, connect the RCA pin connectors and the extension cord 8p DIN connector to the CD/Cassette Receiver. Fi-nally, connect the battery cord to a constant power supply. 6. Please carefully read the operating and installation instructions of any equipment connected to this unit. 7. If the unit doesn’t work after pressing other buttons, press the reset switch. If pressing the reset switch doesn’t restore regular operation, please consult your nearest professional installer. □ Installation Hardware Description Q’ty o Hex. Bolt with Double Washers