Be careful to avoid injury from the catch pins on the removal tool. 5 Pull the unit all the way out with your hands, being careful not to drop it. — 17 — English English What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems. General ? The power does not turn ON. . The fuse has blown. . After checking for short circuits in the wires, replace the fuse with one with the same rating. . No ACC position on vehicle ignition. . Connect the same cable to the ignition as the battery cable. ? Nothing happens when the buttons are pressed. . The computer chip in the unit is not functioning normally. . Press the reset button on the unit (page 4). ? There’s a source you can’t switch. . There’s no tape inserted. . Set the media you want to listen to. If there’s no media in this unit, you can't switch to each source. ? There’s a source you can’t switch. . The Disc changer isn’t connected. . Connect the Disc changer. If the Disc changer isn’t connected to it's input terminal, You can't switch to an external disc source. ? The faceplate does not open or close. . The faceplate is incorrectly attached. . Reattach the faceplate correctly, See the section on (page 7). ? The memory is erased when the ignition . The battery wire has not been connected . Connect the wire correctly, referring to the section on . . The ignition and battery wire . Connect the wire correctly, referring to the section . Disc source ? "AVin" is displayed without achieving External disc control mode. . O-N switch is set to "O" side. . Set the switch to "N" side. . Unsupported disc changer is connected. . Connect the supported disc changer. (page 3) ? The specified disc does not play, but another one plays instead. . The specified CD is quite dirty. . Clean the CD. . The CD is upside-down. . Load the CD with the labeled side up. . The disc is loaded in a different slot from that specified. . Eject the disc magazine and check the number for the specified disc. . The disc is severely scratched. . Try another disc instead. ? The specified track will not play. . Random play or magazine random play has been . Turn off random play or magazine random play. ? Track repeat, disc repeat, track scan, and magazine random play start by themselves. . The setting is not canceled. . The settings for these functions or the disc ejected, even if the changed. ? Cannot play CD-R or CD-RW. . Finalization processing is not being conducted for CD-R/CD-RW. . Conduct finalization processing with CD recorder. . A non-compatible CD changer is being used to play the CD-R/CDRW. . Use a CD changer compatible with CD-R/CD-RW to play. ? Track Search can't be done. . For the albums first or last song. . For each album, Track Search can't be done in the backward direction for the first song or in the forward direction for the last song. If the following situations, consult your nearest service center: • Even though the disc changer is connected, the Disc Changer source is not ON, with "AVin" showing in the display during the Changer Mode. • Even though no device (CA-C1AX) is connected, the Auxiliary input is entered when switching modes. — 19 — English English The messages shown below display your systems condition. E-01: No disc magazine has been loaded in the changer. The disc magazine is not completely loaded. . Load the disc magazine properly. E-02: No disc has been loaded in the disc magazine. . Load a disc into the disc magazine. E-0d: LOAd: The protective circuit in the unit activates when the tem...
Este manual também é adequado para os modelos : Unidade - KRC-269 (342.84 kb)
)
