Assessments - 5, GPA: 3.8 ( )

Fabricante : Sony Arquivo Tamanho: 1.65 mb Arquivo Nome : Língua de Ensino:

You can emphasize and adjust the bass sound easily with the D-BASS button. Adjusting the bass curve Press (d-bass) repeatedly until the desired bass level (1, 2, or 3) appears in the display. I—B D.BASS 1-► D I-D BA' BASS 2 -D.BASS-OFF b D.BASS 3 : Maintenance Fuse replacement When replacing the fuse, be sure to use one matching the amperage rating stated on the original fuse. If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after replacement, there may be an internal malfunction. In such a case, consult your nearest Sony dealer. To cancel, select "D.BASS-OFF.” Warning Never use a fuse with an amperage rating exceeding the one supplied with the unit as this could damage the unit. Note If the bass sound becomes distorted, select a less effective setting of "D.BASS" or adjust the volume. 25 Cleaning the connectors The unit may not function properly if the connectors between the unit and the front panel are not clean. In order to prevent this, open the front panel by pressing (open) , then detach it and clean the connectors with a cotton swab dipped in alcohol. Do not apply too much force. Otherwise, the connectors may be damaged. 3 Use a thin screwdriver to push in the clip on the left side of the unit, then pull out the left side of the unit until the catch clears the mounting. 4 mm 4 Repeat step 3 for the right side. Back of the front panel Notes • For safety, turn off the engine before cleaning the connectors, and remove the key from the ignition switch. • Never touch the connectors directly with your fingers or with any metal device. Dismounting the unit 5 Slide the unit out of its mounting. After taking off the front panel, press the clip inside the front cover with a thin screwdriver, and gently pry the front cover free. 2 Repeat step 1 for the right side. The front cover is removed. 26 1 Specifications CD player section General Signal-to-noise ratio Frequency response Wow and flutter 90 dB 10 - 20,000 Hz Below measurable limit Tuner section FM Tuning range Aerial terminal Intermediate frequency Usable sensitivity Selectivity Signal-to-noise ratio 87.5 - 108.0 MHz External aerial connector 10.7 MHz/450 kHz 8 dBf 75 dB at 400 kHz 66 dB (stereo), 72 dB (mono) Harmonic distortion at 1 kHz 0.6 % (stereo), 0.3 % (mono) 35 dB at 1 kHz 30 - 15,000 Hz Separation Frequency response MW/LW Tuning range Aerial terminal Intermediate frequency Sensitivity MW: 531 - 1,602 kHz LW: 153 - 279 kHz External aerial connector 10.7 MHz/450 kHz MW: 30 pV LW: 40 pV Power amplifier section Outputs Speaker impedance Maximum power output Speaker outputs (sure seal connectors) 4 - 8 ohms 50 W x 4 (at 4 ohms) Outputs Tone controls Power requirements Dimensions Mounting dimensions Mass Supplied accessories Optional accessories Optional equipment Audio outputs*1 Power aerial relay control lead Power amplifier control lead Telephone ATT control lead*2 Bass ±9 dB at 100 Hz Treble ±9 dB at 10 kHz 12 V DC car battery (negative ground) Approx. 178 x 50 x 183 mm (w/h/d) Approx. 182 x 53 x 162 mm (w/h/d) Approx. 1.2 kg Parts for installation and connections (1 set) Front panel case (1) Rotary commander RM-X4S Card remote commander RM-X91 BUS cable (supplied with an RCA pin cord) RC-61 (1 m), RC-62 (2 m) CD changer (10 discs) CDX-828, CDX-737 MD changer (6 discs) MDX-65 Source selector XA-C30 *1 Equipped with front and rear outputs: CDX-C5000RX/C5000RV/C5000R only Equipped with rear outputs: CDX-C4900R *2 CDX-C5000RX/C5000RV/C5000R only Design and specifications are subject to change without notice. 27 Troubleshooting guide The following checklist will help you remedy the problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures. General Problem Cause/Solution No sound. • Cancel the ATT function. • Set the fader control to the centre position for two-speaker system. • Rotate the dial clockwise to adjust the volume. The contents of the memory • The power cord or battery has been disconnected. have been erased. • The reset button has been pressed. —— Store again into the memory. Indications do not appear in the Remove the front panel and clean the connectors. See display. "Cleaning the connectors” (page 26) for details. No beep sound. • The beep sound is cancelled (page 24). • If you connect an optional amplifier and do not use the built-in amplifier, the beep sound will be deactivated. CD/MD playback Problem Cause/Solution A disc cannot be loaded. • Another CD is already loaded. • The CD is forcibly inserted upside down or in the wrong way. Playback does not begin. Defective MD or dirty CD. A disc is automatically ejected. The ambient temperature exceeds 50°C. CD will not be ejected. You have closed the front panel or pushed the disc forcibly into the unit while the unit was ejecting the disc after you pressed Z. —— Press the reset...

Baixe o seu

Para fazer o download, introduza 2 dígitos :