Assessments - 4, GPA: 4.3 ( )

Fabricante : Sony Arquivo Tamanho: 2.38 mb Arquivo Nome : Língua de Ensino:

In order to prevent this, detach the front panel (page 8) and clean the connectors with a cotton swab dipped in alcohol. Do not apply too much force. Otherwise, the connectors may be damaged. Main unit 24 Back of the front panel Notes • For safety, turn off the ignition before cleaning the connectors, and remove the key from the ignition switch. • Never touch the connectors directly with your fingers or with any metal device. Replacing the lithium battery Under normal conditions, batteries will last approximately 1 year. (The service life may be shorter, depending on the conditions of use.) When the battery becomes weak, the range of the card remote commander becomes shorter. Replace the battery with a new CR2025 lithium battery. x + side up Removing the unit 1 Remove the front cover o Detach the front panel (page 8). 2 Press the clip inside the front cover with a thin screwdriver. 3 Repeat step 2 for the other side. 2 Remove the unit o Use a thin screwdriver to push in the clip on the left side of the unit, then pull out the left side of the unit until the catch clears the mounting. 2Repeat step o for the right side. 3 Slide the unit out of its mounting. Notes on lithium battery • Keep the lithium battery out of the reach of children. Should the battery be swallowed, immediately consult a doctor. • Wipe the battery with a dry cloth to assure a good contact. • Be sure to observe the correct polarity when installing the battery. • Do not hold the battery with metallic tweezers, otherwise a short-circuit may occur. WARNING Battery may explode if mistreated. Do not recharge, disassemble, or dispose of in fire. 25 Specifications CD Player section General Signal-to-noise ratio 90 dB Outputs Frequency response 10 - 20,000 Hz Wow and flutter Below measurable limit Tuner section FM Inputs Tuning range 87.5 - 108.0 MHz Aerial terminal External aerial connector Tone controls Intermediate frequency 10.7 MHz/450 kHz Usable sensitivity 8 dBf Power requirements Selectivity 75 dB at 400 kHz Signal-to-noise ratio 66 dB (stereo), 72 dB (mono) Dimensions Harmonic distortion at 1 kHz 0.6 % (stereo), Mounting dimensions 0.3 % (mono) Mass Separation 35 dB at 1 kHz Supplied accessories Frequency response MW/LW 30 - 15,000 Hz Tuning range MW: 531 - 1,602 kHz LW: 153 - 279 kHz Optional accessories Aerial terminal External aerial connector Intermediate frequency 10.7 MHz/450 kHz Sensitivity MW: 30 ^V LW: 40 ^V Power amplifier section Optional equipment Outputs Speaker outputs (sure seal connectors) Speaker impedance 4 - 8 ohms Maximum power output 50 W x 4 (at 4 ohms) Audio outputs Power aerial relay control lead Power amplifier control lead Telephone ATT control lead Remote controller imput connector Aerial input connector Bass ±8 dB at 100 Hz Treble ±8 dB at 10 kHz 12 V DC car battery (negative earth ) Approx. 178 x 50 x 177 mm (w/h/d) Approx. 182 x 53 x 161 mm (w/h/d) Approx. 1.2 kg Parts for installation and connections (1 set) Front panel case (1) Rotary commander RM-X4S Card remote commander RM-X114 BUS cable (supplied with an RCA pin cord) RC-61 (1 m), RC-62 (2 m) CD changer (10 discs) CDX-848X, CDX-646 CD changer (6 discs) CDX-T68X, CDX-T67 MD changer (6 discs) MDX-65 Source selector XA-C30 Note This unit cannot be connected to a digital preamplifier or an equalizer. Design and specifications are subject to change without notice. 26 Troubleshooting The following checklist will help you remedy problems you may encounter with your unit. Before going through the checklist below, check the connection and operating procedures. General No sound. • Rotate the volume control dial clockwise to adjust the volume. • Cancel the ATT function. • Set the fader control to the centre position for a 2-speaker system. The contents of the memory have been erased. • The RESET button has been pressed. —— Store again into the memory. • The power cord or battery has been disconnected. • The power connecting cord is not connected properly. No beep sound. The beep sound is cancelled (page 22). Indications disappear from/do not appear in the display. • The clock display disappears if you press (OFF) for 2 seconds. —— Press (OFF) again for 2 seconds to display the clock. • Remove the front panel and clean the connectors. See “Cleaning the connectors” (page 24) for details. Stored stations and correct time are erased. The fuse has blown. Makes noise when the ignition key is in the ON, ACC, or OFF position. The leads are not matched correctly with the car’s accessory power connector. No power is being supplied to the unit. • Check the connection. If everything is in order, check the fuse. • The car does not have an ACC position. —— Press (SOURCE) (or insert a disc) to turn on the unit. The power is continuously supplied to the unit. The car does not have an ACC position. The power aerial does not extend. The power aerial does not have a relay...

Baixe o seu

Para fazer o download, introduza 2 dígitos :