Assessments - 4, GPA: 4.5 ( )

Fabricante : Pioneer Arquivo Tamanho: 836.06 kb Arquivo Nome : Língua de Ensino:

Fotos e especificações  Pioneer  DEH-2220UB

Wrap adhesive tape around wiring that comes Into contact with metal parts to protect the wiring. — Place all cables away from moving parts, such as the gearshift and seat rails. — Place all cables away from hot places, such as near the heater outlet. — Do not connect the yellow cable to the battery by passing It through the hole to the engine compartment. — Cover any disconnected cable connectors with Insulating tape. — Do not shorten any cables. — Never cut the Insulation of the power cable of this unit In orderto share the power with other devices. The current capacity of the cable Is limited. — Use a fuse of the rating prescribed. — Never wire the negative speaker cable directly to ground. — Never band together negative cables of multiple speakers. • When this unit Is on, control signals are sent through the blue/white cable. Connect this cable to the system remote control of an external power amp orthe vehicle's auto-antenna relay control terminal (max. 300 mA 12 V DC). If the vehicle Is eguipped with a glass antenna, connect It to the antenna booster power supply terminal. • Never connect the blue/white cable to the power terminal of an external power amp. Also, never connect It to the powerterminal of the auto antenna. Doing so may result In battery drain or a malfunction. • The black cable Is ground. Ground cables for this unit and other egulpment (especially, high-current products such as power amps) must be wired separately. If they are not, an accidental detachment may result In a fire or malfunction. Connection Diagram (Fig. 1) 1 This product 2 Antenna jack 3 Fuse (10 A) 4 Note: Depending on the kind of vehicle, the function of 2* and 4* may be different. In this case, be sure to connect 1 * to 4* and 3* to 2*. 5 Wired remote Input Hard-wired remote control adaptor can be connected (sold separately). 6 Connect leads of the same color to each other. 7 Yellow (2*) Back-up (or accessory) 8 Yellow (1*) Connect to the constant 12 V supply terminal. 9 Red (4*) Accessory (or back-up) En (Connections j 10 Red (3*) Connect to terminal controlled by Ignition switch (12 V DC). 11 Black (chassis ground) Connect to a clean, paint-free metal location. 12 ISO connector In some vehicles, the ISO connector may be divided Into two. In this case, be sure to connect to both connectors. 13 Speaker leads White: Front left © White/black: Front left © Gray: Front right © Gray/black: Front right © Green: Rear left © Green/black: Rear left © Violet: Rear right © Violet/black: Rear right © 14 Rear output 15 Yellow/black If you use an egulpment with Mute function, wire this lead to the Audio Mute lead on that egulpment. If not, keep the Audio Mute lead free of any connections. 16 Blue/white Connect to system control terminal of the power amp (max. 300 mA 12 V DC). 17 Blue/white (6*) Connect to auto-antenna relay control terminal (max. 300 mA 12 V DC). 18 Blue/white (5*) The pin position of the ISO connector will...

Baixe o seu

Para fazer o download, introduza 2 dígitos :