Assessments - 3, GPA: 3.7 ( )

Fabricante : Harbor Freight Tools Arquivo Tamanho: 338.35 kb Arquivo Nome : Língua de Ensino:

SAVE THESE INSTRUCTIONS Work area safety Keep work area clean and well lit. Cluttered or dark areas invite accidents. Personal safety Inspect this Threshold often. Repair or replace if needed. Always wear ANSI-approved safety goggles during installation of this product. Use this Threshold only for intended purpose. Stay alert, watch what you are doing and use common sense when installing. Do not install while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention may result in serious personal injury. Do not overreach. Keep proper footing and balance at all times. Keep out of reach of children. Maintain labels and nameplates. These carry important safety information. If unreadable or missing, contact Harbor Freight Tools for a replacement. The warnings, precautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator. Save these instructions. Unpacking When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. Assembly There is no assembly required for this Garage Threshold. Installation Instructions Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product. FITTING AND INSTALLING THE THRESHOLD Open the garage door and clean the bottom of the door and the area of the garage floor where the door and the floor meet. Make sure there is no moisture or dirt on the surface or you will not get a good bond with the Threshold. Place the Threshold in the opening, centering it between the door tracks on each side of the entrance. The garage door tracks are the channels the door uses as it rolls up and down. The Threshold is made to fit most garage doors so usually no trimming is necessary. If you do have to trim, use a straight edge for a uniform fit when the Threshold is installed. Figure 145° AngleGarage Door (Down) Garage Door ThresholdLower the door onto the Threshold. Place the 45° angle of the Threshold against the inside of the bottom of the door. The 45° angle of the Threshold should be against the inside of the door for a proper seal against moisture. Trace the inside edge of the Threshold then raise the garage door and, using a carpenters pencil (not included), trace the leading edge of the Threshold. With the garage door still in the raised position remove the Threshold. Apply two 1/4” rows of adhesive (not included) between the two lines running parallel the length of the garage door opening. Apply the adhesive lines 3/4” from the front and back edge of the Threshold. Using the adhesive (not included) make a zig-zag line from ...

Baixe o seu

Para fazer o download, introduza 2 dígitos :