Assessments - 3, GPA: 4
(
)
)
|
Facilidade de uso
The receivers can operate from 16-24 volts AC or 20-30 volts DC and are normally powered from the gate operator. The relay contact(s) are rated at 5 amps @ 32 volts AC/DC NEC Class 2 circuit. The DRG has a “F” connector for attaching an antenna. The receiver is supplied with a 9-inch local antenna, a three foot 75 ohm coaxial cable, and a bulkhead connector for mounting the antenna outside the gate operator enclosure. STEP 1 Open receiver case. To open case, squeeze sides of case and rotate upward. STEP 2A DRG code setting. To set a code, select any valid combination of ON and OFF positions for the switch keys numbered 1- 8. Use a paper clip to set the eight keys. STEP 2B DRG2 code setting. Select any valid combination of ON and OFF positions for each of the switch keys numbered 1 - 8. Use a different code combination than that used for channel one switch. STEP 3 Transmitter code setting. Locate the coding switch on the transmitter and set the eight keys identical to those on the desired channel of the receiver. Be sure they match exactly. I f using a two or four-channel transmitter, refer to the coding instructions included with the transmitter for proper system coding. STEP 4 Connect receiver relay output. Connect the appropriate channel wires (Ch. 1 - two gray wires), (Ch. 2 - two yellow wires) to the appropriate activation terminals on the gate operator. STEP 5 Connect receiver to power . Connect the red power input wire to the 24V radio power and the black wire to the common terminal on the gate operator. Alternately connect wires to a 16-24 VAC transformer. STEP 6 Mounting the receiver. Use the screws provided to mount the receiver within the operator housing. This provides protection from the elements. Secure case with case screws. STEP 7 Connect antenna. Connect the coaxial cable to the “F” connector on the receiver. Drill a 3/8" hole on the top of the operator housing for the bulkhead connector. Insert the connector and secure it with the nut and lock washer. Connect the cable and antenna to the operator. LINEAR LIMITED WARRANTY This product is warranted to the consumer against defects in material and workmanship for one year from the date of purchase. This warranty applies to first retail buyers of new devices. Warrantor will repair, or at its option, replace, any device it finds that requires service under this warranty, and will return the repaired or replaced device to the consumer at the warrantor’s cost. For warranty service and shipping instructions contact warrantor at the address shown below. Devices must be sent to warrantor for service at owner’s expense. The remedies provided by this warranty are exclusive. Implied warranties under state law are to the one year period of this written warranty. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. In order to be protected by this warranty, save your proof of purchase and send copy with equipment should repair be required. This warranty gives you specific legal rights, and you may also have other...
Este manual também é adequado para os modelos :Portão automático - DRG (136.39 kb)