Log:
Assessments - 3, GPA: 3.3 ( )

Instruções de Operação Briggs & Stratton, Modelo POWER BUILT 150000

Fabricante : Briggs & Stratton
Arquivo Tamanho: 4.64 mb
Arquivo Nome :
Língua de Ensino: svitenesfrdenlptdafi
Ir para baixar



Facilidade de uso


To remain emissions compliant, high altitude adjustment is required. Operation without this adjustment will cause decreased performance, increased fuel consumption, and increased emissions. See a Briggs & Stratton Authorized Dealer for high altitude adjustment information. Operation of the engine at altitudes below 2,500 feet (762 meters) with the high altitude kit is not recommended. How To Add Fuel -Figure 3 WARNING Gasoline and its vapors are extremely flammable and explosive. Fire or explosion can cause severe burns or death. When Adding Fuel • Turn engine off and let engine cool at least 2 minutes before removing the fuel cap. • Fill fuel tank outdoors or in well-ventilated area. • Do not overfill fuel tank. To allow for expansion of the gasoline, do not fill above the bottom of the fuel tank neck. • Keep gasoline away from sparks, open flames, pilot lights, heat, and other ignition sources. • Check fuel lines, tank, cap, and fittings frequently for cracks or leaks. Replace if necessary • If fuel spills, wait until it evaporates before starting engine. 1. Clean the fuel cap area of dirt and debris. Remove the fuel cap (A) (Figure 3). 2. Fill the fuel tank (B) with gasoline. To allow for expansion of the gasoline, do not fill above the bottom of the fuel tank neck (C). 3. Reinstall the fuel cap. How To Start The Engine -Figure 56 WARNING Rapid retraction of starter cord (kickback) will pull hand and arm toward engine faster than you can let go. Broken bones, fractures, bruises or sprains could result. • When starting engine, pull the starter cord slowly until resistance is felt and then pull rapidly to avoid kickback. WARNING Gasoline and its vapors are extremely flammable and explosive. Fire or explosion can cause severe burns or death. When Starting Engine • Ensure that spark plug, muffler, fuel cap and air cleaner (if equipped) are in place and secured. • Do not crank engine with spark plug removed. • If engine floods, set choke (if equipped) to OPEN/RUN position, move throttle (if equipped) to FAST position and crank until engine starts. en WARNING Engines give off carbon monoxide, an odorless, colorless, poison gas. Breathing carbon monoxide can cause nausea, fainting or death. • Start and run engine outdoors. • Do not start or run engine in enclosed area, even if doors or windows are open. NOTICE: This engine was shipped from Briggs & Stratton without oil. Before you start the engine, make sure you add oil according to the instructions in this manual. If you start the engine without oil, it will be damaged beyond repair and will not be covered under warranty. Note: Equipment may have remote controls. See the equipment manual for location and operation of remote controls. 1. Check the oil level. See the How To Check/Add Oil section. 2. Make sure equipment drive controls, if equipped, are disengaged. 3. Turn the fuel shut-off valve (A), if equipped, to the on position (Figure 5). position. 4. Move the choke control lever (B) to the choke Note: Choke is usually unnecessary when restarting a warm engine. 5. Move the throttle control lever (C), if equipped, to the fast position. Operate the engine with the throttle control lever in the fast position. 6. On engines equipped with a stop switch (D), move the switch to the on position. 7. Rewind Start: Firmly hold the starter cord handle (E). Pull the starter cord handle slowly until resistance is felt, then pull rapidly. Note: If the engine does not start after repeated attempts, go to BRIGGSandSTRATTON.COM or call 1-800-233-3723 (in USA). WARNING: Rapid retraction of the starter cord (kickback) will pull your hand and arm toward the engine faster than you can let go. Broken bones, fractures, bruises or sprains could result. When starting engine, pull the starter cord slowly until resistance is felt and then pull rapidly to avoid kickback. 8. Electric Start: Push in the safety key (F). Momentarily push the start switch (G). When the engine starts, release the switch (Figure 6). Note: If the engine does not start after repeated attempts, go to BRIGGSandSTRATTON.COM or call 1-800-233-3723 (in USA). 9. As the engine warms up, move the choke control (B)tothe run position (Figure 5). How To Stop The Engine -Figure 7 Not for Reproduction WARNING Gasoline and its vapors are extremely flammable and explosive. Fire or explosion can cause severe burns or death. • Do not choke the carburetor to stop engine. However, to obtain “no charge” emissions control service, the work must be performed by a factory authorized dealer. See the Emissions Warranty. WARNING Unintentional sparking can result in fire or electric shock. Unintentional start-up can result in entanglement, traumatic amputation, or laceration. Fire hazard Before performing adjustments or repairs: • Disconnect the spark plug wire and keep it away from the spark plug. • Disconnect battery at negative terminal (only engines with electric start.) • Use only correct tools. • Do not tamper with governor spring, ...

Este manual também é adequado para os modelos :
Vídeo Car - POWER BUILT 120000 (4.64 mb)
Vídeo Car - POWER BUILT 200000 (4.64 mb)
Vídeo Car - POWER BUILT 210000 (4.64 mb)

Escreva a sua própria avaliação do dispositivo



Mensagem
Seu nome :
Introduza os dois dígitos :
capcha





categorias