Assessments - 3, GPA: 3.3
(
)
)
|
Facilidade de uso
The manual enables you to utilize all possible functions in a practical way. Therefore it is necessary to go through this booklet before you make use of your answering machine. Good luck! COPYRIGHT 1995 TOPCOM® 1 2 DESIGN (1.) MICROPHONE (2.) SPEAKER (3.) CASSETTE 3 COMPARTMENT (4.) MESSAGE INDICATOR (LED) 4 (5.) • OUTGOING MESSAGE (OGM) (6.) • PLAY • REWIND 567 (7.) • MEMO • FAST FORWARD (8.) • VOLUME KNOB • ON-OFF (9.) TELEPHONE LINE CORD CONNECTION (10.) ADAPTER LINE CORD CONNECTION 8 9 10 MM Domo M1 Domo M2 11.4. Rewind during the playback of recorded messages 11.5. Fast-forward during the playback of recorded messages 11.6. Memo-recording 12. REMOTE CONTROL 12.1. The topcom domo is switched on 12.2. The topcom domo is switched off 12.3. Interruption of the playback on remote operation 13. IN CASE OF DIFFICULTIES 14. GUARANTEE ENCLOSURE: GUARANTEE CARD 10 11 11 11 12 13 13 13 14 TABLE OF CONTENTS : 1. IMPORTANT SAFETY INSTRUCTIONS 2. INSTALLATION 2.1. Location 2.2. Insert the cassette 2.3. Connection 2.3.1. Connect the adapter 2.3.2. Connect the telephone line cord 2.3.3. Connect your telephone to your TOPCOM DOMO 3. RECORD THE MESSAGE (OGM) 3.1. Record the message on tape 3.2. Check the message 4. INCOMING MESSAGES (ICM) 4.1. Switch your TOPCOM DOMO on 4.2. Switch your TOPCOM DOMO off 5. VOLUME ADJUSTMENT 6. CALL SCREENING OF INCOMING MESSAGES 7. INDICATION OF RECORDED MESSAGES BY MEANS OF THE LED (4) FLASH 8. POWER FAILURE INDICATION 9. VOX CONTROL 10. TAPE FULL INDICATION 11. PLAYBACK OF RECORDED MESSAGES 11.1. Save messages 11.2. Erase messages 11.3. Pause during the playback of recorded messages 3 3 3 4 5 5 6 6 6 6 7 7 8 8 8 8 8 9 9 9 9 10 10 10 Domo Domo DomoDomo IMPORTANT SAFETY INSTRUCTIONS Before using your telephone answering machine take the following safety instructions into account : 1. Read carefully the manual 2. Never place your TOPCOM DOMO on an unstable ground 3. Do not install the device in a moist and dusty environment 4. Do not place the answering machine near a source of heat such as a stove or a radiator 5. Use only a slightly damped cloth for the cleaning 6. Never remove screws or lids to repair the machine yourself. Leave this to the technical department of TOPCOM 7. Pull the plug out of the outlet immediately a. In case the power supply plug or the cord have been damaged b. In case a fluid spilled into the machine c. If the answering machine has been dropped and has severely been damaged 8. Slots and openings in the device are provided for ventilation to protect the machine from overheating. These openings may not be blocked with the installment of the device. 2. INSTALLATION 2.1. LOCATION Place your TOPCOM DOMO on a hard, flat surface as close as possible to a wall telephone modular jack and a power outlet (230v) 2.2. INSERT THE CASSETTE 1. Push the front panel of the cassette compartment upwards. 2. Insert the cassette into the answering machine as follows: • The upper side of the cassette has to lean against the cassette tape holder of the tape deck mechanism. • The reel holes of the cassette have to fit into the playwheel of the tape deck when you push the underside of the cassette downwards into the playwheel mechanism cassette compartment Caution: The cassette has to be placed into the machine with the text on it directed downwards (upside down) Mechanical defaults caused by a wrong insertion of the cassette are not guaranteed. M4M3 DomoDomo DomoDomo • Always pull the plug out of the outlet when you clean, replace or turn the cassette • If the power supply is switched on again, the cassette will check itself. After this check, you have to record your message again. • The cassette needs replacement if: -The messages are not intelligible anymore -The machine rewinds and fast forwards slowly -The tape is broken • Clean the tape mechanism every six months as follows: -Take the cassette out of the answering machine. Clean the heads and the mechanism with a cotton cloth or a swab moistened with isopropyl alcohol. -Let the mechanism dry. Close the lid. -Insert the cassette back into the device. 2.3. CONNECTION 2.3.1. Connect the adapter Important: Before you connect the adapter, the microcassette has to be installed (with the text on the cassette directed downwards). 1. Plug the adapter into the power outlet. 2. Plug the end of the adapter cord in the provided power jack on the left side of your TOPCOM DOMO The led (4) flash will switch on and the device will check on itself. After this selftest the led (4) flash will switch off. There will be a beep every five seconds to indicate that there is no message on the tape. Remark: Use only the adapter which was provided with your device. 2.3.2. Connect the telephone line cord Insert the telephone plug into your net line outlet. 2.3.3. Connect your telephone to your TOPCOM DOMO Insert the plug of your telephone on top of the intermediate outlet of your TOPCOM DOMO. 3. RECORD THE MESSAGE (OGM) Your message is the text the caller will h...