Assessments - 4, GPA: 4.3
(
)
)
|
Facilidade de uso
\ KHz, 120 Vac line) 65 W RMS into 8 or 4 ohms (Bias must be reduced to measure) FREQUENCY RESPONSE: +0. -2 dB 50 Hz to 20 kHz @ 50 W RMS into 8 ohms HUM & NOISE: Greater than 83 dB below rated power HUM BALANCE CONTROL: Adjust for minimum hum @ max gain POWER CONSUMPTION: 200 Watts, 50/60 Hz. 120 Vac (Domestic) PREAMP SECTION: 3- 12AX7S. 1 - 12AT7 The following specs are measured <§> 1 kHz with the controls preset as follows: Low & High EQ @ 10, Mid EQ @ 0, Presence @ 0 Ultra & Crunch Posts @ 10. Master Reverb @ 0 (Nominal levels are with Pre Gains @ 5) (Minimum levels are with Pre Gains @ 10) PREAMP HIGH GAIN INPUT: Impedance: Very high Z. 470K ohm ULTRA CHANNEL: (default channel) Nominal Input Level: - 62 dBV, 0.5 mV RMS Minimum Input Level: - 80 dBV. 0.1 mV RMS CRUNCH CHANNEL: (toolswitch selected) Nominal Input Level: -62 dBV. 0.8 mV RMS Minimum Input Level: -74 dBV. 0.2 mV RMS CLEAN CHANNEL: (footswltch selected) Nominal Input Level: -20 cBV, 100 mV RMS Minimum Input Level: -42 dBV, 8 mV RMS Maximum Input Level: 0 dBV, 1.0 V RMS PREAMP LOW GAIN INPUT: (-6 dB Pad) Impedance: High Z. 44K ohms All levels are increased by + 6 dB EFFECTS SEND: Load Impedance: 47K ohms or greater Nominal Output: -20 dBV, 100 mV RMS EFFECTS RETURN: Impedance: Very high Z, 470K ohm Designed Level: - 20 dBV. 100 mV RMS PREAMP OUTPUT: Load Impedance: 47K ohms or greater Nominal Output: +10 dBV, 3 V RMS REMOTE FOOTSWITCH: Special 3 button unit with LED indicators (supplied) SYSTEM HUM & NOISE @ NOMINAL LEVEL: (Clean channel) (20 Hz to 20 kHz unweighted) Greater than 75 dB beiow rated power (Special notse gain circuitry for ultra & crunch) EQUALIZATION: Custom Low. Mid & High passive type EQ for dean channel Special thick EQ act-vaied for ultra & crunch channels PRESENCE: ♦6 dB <§> 5 kHz PUSH BRIGHT: ♦6 gB <§> 2 kHz TRIUMPH 120 POWER AMPLIFIER SECTION: 4- 6L6GC‘s with 12AX7 driver RATED POWER & LOAD: 120 W RMS into 8 or 4 ohms POWER @ CLIPPING: (Typically <§> 5% THD, 1 kHz, 120 Vac line) 130 W RMS into 8 or 4 ohms (Bias must be reduced to measure) FREQUENCY RESPONSE: +0, -2 dB 50 Hz to 20 kHz @ 100 W RMS into 8 ohms HUM & NOISE: Greater than 83 dB below rated power HUM BALANCE CONTROL: Adjust for minimum hum <2> max gain POWER CONSUMPTION: 400 Wans. 50/60 Hz, 120 Vac (Domestic) PREAMP SECTION: 3- 12AX7S, 1 - 12AT7 The following specs are measured @ 1 kHz with the controls preset as follows: Low & High EQ <§> 10. Mid EQ @ 0. Presence @ 0 Uitra & Crunch Posts @ 10. Master Reverb o (Nominal levels are with Pre Gains @ 5) (Minimum levels are with Pre Gains @ 10} PREAMP HIGH GAIN INPUT: Impedance: Very high Z. 470K ohm ULTRA CHANNEL: (default channel) Nominal Input Level: - 62 dBV, 0.5 mV RMS Minimum Input Level: - 80 dBV, 0.1 mV RMS CRUNCH CHANNEL: (footswitch selected) Nominal Input Level: -62 dBV. 0.8 mV RMS Minimum Input Level: -74 dBV. 0.2 mV RMS CLEAN CHANNEL: (footwitch selected) Nominal Input Level. -20 dBV. 100 mV RMS Minimum Input Level: -¿2 dBV, 8 mV RMS Maximum Input Levei: 0 dBV. 1.0 V RMS PREAMP LOW GAIN INPUT: (-6 dB Pad) Impedance: High Z, 44K ohms All levels are increased by + 6 dB EFFECTS SEND: Load Impedance: 47K ohms or greater Nominal Output: -20 dBV. 100 mV RMS EFFECTS RETURN: Impedance: Very high Z. 470K ohm Designed Level: - 20 dBV. 100 mV RMS PREAMP OUTPUT: Load Impedance: 47K ohms or greater Nominal Output: +10 dBV, 3 V RMS REMOTE FOOTSWITCH: Special 3 button unit with LED indicators (supplied) SYSTEM HUM & NOISE @ NOMINAL LEVEL: (Clean channel) (20 Hz to 20 kHz unweighted) Greater thar. 78 dB below rated power (Special noise gain circuitry for ultra & crunch) EQUALIZATION: Custom Low, Mid & High passive type EQ for clean channel Special thick EQ activated for ultra & crunch channels PRESENCE: +6 dB @ 5 kHz PUSH BRIGHT: +6 dB @ 2 kHz THIS LIMITED WARRANTY VALID ONLY WHEN PURCHASED AND REGISTERED IN THE UNITED STATES OR CANADA. ALL EXPORTED PRODUCTS ARE SUBJECT TO WARRANTY AND SERVICES TO BE SPECIFIED AND PROVIDED BY THE AUTHORIZED DISTRIBUTOR FOR EACH COUNTRY. Ces clauses de garantie ne sont vaiables qu’aux Etats-Unis et au Canada. Dans tous les autres pays, les clauses de garantie et de maintenance sont flxees par le distrlbuteur national et assuree par lul seion la legislation en vigueur. Diese Garantie 1st nur in den USA and Kanada gultig. Alle Export-Produkte slnd der Garantie und dem Service des Importeurs des jewelllgen Landes unterworlen. Esta garantía es valida solamente cuando el producto es comprado en E.U. continentales o en Canada. Todos los productos que sean comprados en el extranjero, están sujetos a las garantías y servicio que cada distribuidor autorizado determine y ofrezca en los diferentes paises. ONE-YEAR LIMITED WARRANTY/REMEDY PEAVEY ELECTRONICS CORPORATION ("PEAVEY") warrants this product. EXCEPT for covers, footswitches. patchcords, tubes and meters, to be free from defects in material and workmanship for a period of on...