Assessments - 4, GPA: 4.3
(
)
)
|
Facilidade de uso
Check suction piping and valve glands on any suction gate valves. b. Secure lid on pump strainer pot and make sure lid gasket is in place. c. Check water level to make sure skimmer is not drawing air. 2. Pump will not prime--not enough water. - Remedy: a. Make sure suction lines, pump strainer, and pump volute are full of water. b. Make sure valve on suction line is working and open, (some systems do not have valves). c. Check water level to make sure water is available through skimmer. 3. Pump strainer clogged. - Remedy: a. Clean pump strainer pot. 4. Pump strainer gasket defective. - Remedy: a. Replace gasket. B. Reduced Capacity and/or Head. 1. Air pockets or leaks in suction line. - Remedy: a. See item A.1. of this section, above. 2. Clogged impeller. Remedy: a. Turn off electrical power to the pump. b. Remove the clamp that holds the volute to the seal plate. c. Slide the motor and seal plate away from the volute. d. Clean debris from impeller. If debris cannot be removed, complete the following steps. (1) Remove left hand thread anti-spin bolt and O-ring. (2) Remove, clean and reinstall impeller. (3) Reinstall anti-spin bolt and O-ring. e. Reinstall wear-ring, diffuser, and O-ring. f. Reinstall motor and seal plate into volute aligning with keyway at top of volute. g. Reinstall clamp around seal plate and volute and tighten securely. 3. Pump strainer clogged. - Remedy: a. Clean suction trap. Rev. D 6-5-01 7 P/N 071109 P/N 071109 8 Rev. D 6-5-01 A. Replacement Parts. Item Part Model Description No. No. No. Item Part Model Description No. No. No. SECTION VI. TECHNICAL DATA. 1 357150 CLAMP POT (Black) 1 357199 CLAMP POT (Almond) 2 07-0795 P08080 COVER LEXAN AQ/WFE PUMP 2 357151 COVER LEXAN WFE PUMP 3 350013 O-RING WFE COVER 4 07-0387 P01325 BASKET AQ & WFE 5 07-0430 P02812 BOLT 3/8 16 X 1.15 HEX HD s/s, 4 req. 6 07-2184 P35011 Wsh. 3/8 s/s X 13/16 O.D. 6 7 07-0431 P02813 BOLT 3/8 - 16 X 1/75 HX HD s/s, 2 req. 8 07-1403 P23696 NUT 3/8 - 16 HEX. hd., 2 req. 9 357102 GASKET SEAL PLATE WFE PUMP 10 350015 VOLUTE WFE PUMP & POT 10a 357157 VOLUTE (CSA/CUL ONLY) CANADA 11 07-1444 P24262 O-RING PARKER #2-238 WFE PUMP 12 07-1660 P26951 SET SCREW #4-40 X 1-1/8 WFE, 2 req. 13 07-2928 S05633 DIFFUSER assy. WFE 12/3 HP ONLY 07-2927 S05632 DIFFUSER assy. WFE-3 & 8, 75 HP – 2.5 HP 14 07-1652 P26942 SET SCREW .25 20 X 1 LH PHILLIPS 15 07-5713 WFE PUMP RUBBER Wsh. 16 07-1734 P28323 SEAL PA-7 W/CERAMIC SEAT 16a 07-1728 SEAL A7 s/s PS201 (CSA/CUL) 17 07-0429 P02811 BOLT 3/8-16 X 7/8 s/s HEX hd., 4 req. 18 07-3742 SEAL PLATE WFE - NOT AVAILABLE 07-4564 SEAL PLATE WFE 357173 SEAL PLATE / CUP (CSA/CUL) 19 07-0927 P10311 FOOT WFE - 4 PUMP 19a 357159 FOOT (CANADA ONLY) 20 07-0929 P10313 FOOT INSERT WFE PUMP 20a 357160 FOOT INSERT (CANADA ONLY) 21 07-1657 P26948 SCREW . - 20 X 1 in. HH s/s, 2 req. 22 07-1406 P23802 NUT . - 20 HEX. hd. s/s, 2 req. 23 07-2183 P35010 Wsh. FLAT . X 5/8 , 2 req. 24 07-1131 P19656 KNOB PLUG DRAIN, 2 req. 24a 357161 KNOB, DRAIN (CANADA ONLY) 25 07-4629 GASKET, FLAT Wsh. WFE PMP. DRN., 2 req. ITEM 26, MOTORS 26 07-1313 P21258 .75 HP 60HZ /WFE-2, 3 & 24, 29 Lbs. 07-1314 P21259 1 HP 60HZ /WFE-4 & 26, 33 Lbs. 07-1315 P21260 1.5 HP 60HZ /WFE-6 & 28, 39 Lbs. 07-1316 P21261 2 HP 60HZ /WFE-8 & 30, 40 Lbs. 27 IMPELLER (SEE CHART) 28 357149 VOLUTE REPLACEMENT KIT 28 27 26 HP SIZE STD PART NO. CANADIAN CSA/CUL . WF, WFE-2, -23 073126 357167 . WF, WFE-3, -24 073127 357168 1 WF, WFE-4, -26 073128 357169 1. WF, WFE-6, -28 073129 357170 2 WF, WFE-8, -30 073130 357171 3 WFE-12 073131 357172 27 IMPELLER CHART B. Pump Curves. Single Speed Models Dual Speed Models SAVE THESE INSTRUCTIONS. Rev. D 6-5-01 9 P/N 071109 Pentair Pool Products WhisperFlo™ Circulating Pump Limited Warranty Pentair Pool Products manufactures its WhisperFlo circulating pumps under high standards of workmanship and with high quality materials. Accordingly, Pentair Pool Products expressly warrants those pump models as follows: WARRANTY COVERAGE - All pump component parts actually manufactured by Pentair Pool Products, and the pump’s respective motor is warranted to be free from defects in material and/or workmanship for a period of three (3) years from date of purchase. The obligation of Pentair Pool Products under this warranty will be limited to either repair or replacement of the product, at Pentair Pool Products option. EXCLUSIONS FROM THIS WARRANTY - This warranty does not cover: 1. Any item manufactured by other companies and installed by Pentair Pool Products. Such items may carry warranties offered by the original manufacturer. 2. Problems resulting from oversizing of pump and/or reduction of valve piping size, or from failure to turn pump off before changing the position of the filter valve or any operating valves for the pool and its accessories. 3. Problems resulting from failure to comply with instructions contained in the Owner's Manual. 4. Problems resulting from abuse, misuse, negligence or accident by any party other than Pentair Pool...