Assessments - 2, GPA: 4.5
(
)
)
|
Facilidade de uso
2.) AUX / TUNER-BAND / MONO-ST / EQ / X-BASS Buttons. 3.) CD Door. 4.) DISC 1 Tray. 5.) DISC 2 Tray. 6.) DISC 3 Tray. 7.) MUTE Button. 8.) VOL-DOWN / VOL-UP Buttons. 9.) CD Door OPEN/CLOSE Button. 10.) DISC 3 Indicator & Play Button. 11.) DISC 2 Indicator & Play Button. 12.) DISC 1 Indicator & Play Button. 13.) SKIP + ( ) Button. 14.) PLAY/PAUSE Button. 15.) STOP Button. 16.) SKIP – ( ) Button. 17.) MULTI FUNCTION DISPLAY. 18.) Remote SENSOR. 19.) Pedestal Stand. 20.) PROGRAM Button. 21.) REPEAT Button. 22.) PRESET Button. 23.) RESET Button (Inside Pin Hole). 24.) STANDBY Button. 25.) FM Lead Wire Antenna. 26.) Remote Control Storage. 27.) AUX IN R/L Jacks. 28.) SUFWOOFER Out Jack. 29.) PHONES Jack. 30.) Speaker Terminals. 31.) AC Power Cord. 32.) Back Up Battery Compartment. 16 MS3110_112106.p65 16 22/11/2006, 11:48 OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS • Make sure that you have fully extended the FM antenna wire. • Make sure that you have removed the battery spacer from the remote control handset. • Make sure that you have installed 3 “AA” batteries in the main unit battery back up compartment. • Make sure that the system is connected to an AC outlet that is always “live”. Do not connect the system to an AC outlet controlled by a wall switch. Remove The Dummy CD Transit Protection Cards This system was shipped with a “dummy CD” transit protection card in each of the 3 CD players. These cards were inserted to prevent the CD player mechanisms from moving during shipping and handling. They must be removed and discarded before you can load your own CDs. After connecting the system to your AC outlet, press the STANDBY button to turn the system ‘On’. Then press the OPEN/CLOSE button to open the CD door. Remove the 3 “dummy CDs” and discard them. Press the OPEN/CLOSE button to close the CD door. General Controls Most of the main functions of this system can be operated by the controls on the front panel of the main unit, or by the buttons on the remote control handset. If a specific function can only be operated by the remote handset, or by the front panel controls, this will be clearly indicated in the instructions. When operating this system with the remote control handset make sure that the IR (Infrared) transmitter on the front of the remote handset is pointed at the remote sensor on the front panel of the main unit. The effective operating range of the remote control is approximately 15 feet. Please note that bright sunlight or room lighting may interfere with the remote control operation. If the remote is not operating properly try reducing the brightness of the room or moving closer to the main unit. If this does not solve the problem, it may be time to change the remote control battery. 18 MS3110_112106.p65 18 22/11/2006, 11:48 Volume Controls To increase or decrease the system volume press the VOL DOWN ( – ) or VOL UP (+) buttons on the front panel or the remote control. The Volume Level Indicator will appear on the display when you change the volume level. The level indicator ranges from “0” (Minimum) to “60” (Maximum). The system remembers the volume level when the power is switched ‘Off’ and automatically returns to the same level when the power is switched ‘On’ again. Bass Boost Control (X-BASS) To increase the bass response, press the X-BASS button on the main unit or on the remote control. The XBASS indicator appears in the display. Press again to cancel the X-BASS and return to normal bass response. The XBASS indicator goes ‘off’. Electronic Preset Equalizer (EQ) The preset equalizer allows you to adjust the sound characteristic for the most popular types of music. Press the EQ button on the front panel or the remote control to cycle through the following equalizer settings: FLAT (EQ ‘Off’), POP, ROCK, JAZZ, or DISCO. The appropriate EQ indicator appears in the display to confirm your selection. The system remembers the EQ setting when the power is switched ‘off’ and returns to the same setting when the power is switched ‘on’ again. 19 MS3110_112106.p65 19 22/11/2006, 11:48 FM Mono/Stereo Mode Switch (MONO/ST) If you are listening to a weak or distant FM stereo station you may be able to improve the reception by pressing the MONO/ST Mode button to select the FM Mono mode. The STEREO indicator will go off. The reception will normally improve but the sound will no longer be in stereo. Under normal circumstances this switch should be left in the FM ST Mode. Note: This switch has no effect when playing CDs or listening to external sources connected to the AUX IN jacks. MUTE Button Press the MUTE button on the front panel or the remote control to shut off the speakers temporarily, for example, to answer the telephone. The sound stops and the MUTE indicator appears in the display. Press the MUTE button again to cancel the mute function and restore the sound. The MUTE indicator disappears. The mute function will also be canceled automatically by pressing the VOL DOWN ( – ) or VOL UP (+) buttons ...