Assessments - 3, GPA: 3
(
)
)
|
Facilidade de uso
Please refer to them when you A AC-D302 DC 3 V STEREO RADIO CASSETTE PLAYER RADIORREPRODUCTOR DE CASSETTE ESTEREOFONICO OPERATING INSTRUCTIONS INSTRUCCIONES DE MANEJO MODE D’EMPLOI 8B-HR7-901-01 010301AYO-OX Printed in Hong Kong B 1 2 R6 (AA) . 2 3 contact your AIWA dealer in case of difficulty. Model No. Serial No. HS-RX418 Highlighted letters and numbers in the text of this manual correspond to the illustrations. PRECAUTIONS To maintain good performance Do not use the unit in places which are extremely hot, cold, dusty or humid. In particular, do not keep the unit: • in a high humidity area such as a bathroom • near a heater • in an area exposed to direct sunlight (e.g., inside a parked car, where it can become extremely hot) Note on listening with the headphones • Listen at moderate volumes to avoid hearing damage. • Do not wear the headphones while driving or cycling. It may create a traffic hazard. • You should use extreme caution or temporarily discontinue use in potentially hazardous situations, such as walking, jogging, etc. • Wear them properly; L is left, R is right. Cassette tapes • Take up any slack in the tape with a pencil or similar tool before use. Slack tape may break or jam in the mechanism. > A • 100-minute or longer tapes are extremely thin and easily deformed or damaged. They are not recommended. USING ON DRY CELL BATTERIES > B Open the battery compartment and insert two size AA (R6) dry cell batteries with the 0and 9marks correctly aligned. Battery life (EIAJ 0.2 mW using alkaline batteries LR6) Playback Approx. 30 hours Battery replacement Replace the batteries with new ones when the OPE/BATT indicator becomes dim during playback. If the unit remains in use after the OPE/BATT indicator becomes dim, “beep” is heard several times and operation stops. To maintain preset data • When replacing the batteries, the unit will retain the preset station frequencies for about 5 minutes. To prevent the erasure of the memories, replace the batteries within 5 minutes. • If non remote control headphones are used, unplug the headphones before taking out the batteries. Note on dry cell batteries • Make sure that the 0and 9marks are correctly aligned. • Do not mix different types of batteries, or an old battery with a new one. • To prevent the risk of electrolyte leakage or explosions, never recharge the batteries, apply heat to them, or take them apart. • When not using the batteries, remove them to prevent needless battery wear. • If liquid leaks from the batteries, wipe thoroughly to remove. USING ON AC HOUSE CURRENT > C Contact your nearest Aiwa service personnel and purchase an AC adaptor Aiwa AC-D302. Connect the AC adaptor. 1 to DC 3 V jack 2 to a wall outlet HOLD SWITCH > D When operating with the main unit, release HOLD on the main unit. > a When operating with the remote control, release HOLD on the remote control. > b When not using the unit, set both HOLD to the hold position. > c Accidentally pressed buttons will not function. If buttons on the main unit are pressed when the HOLD switch is set to the HOLD position, “hold” flashes in the display. PLAYBACK > E • Use only Type I (normal) tapes. • Connect the supplied headphones to the remote control, then connect the remote control to the \jack on the main unit. 1 Release HOLD. 2 Insert a cassette. D D Turn OPEN in direction of the arrow to open the cassette holder, and insert a cassette. a Front side b Reverse side 3 Press the dbutton. Playback starts from the front side. The OPE/BATT indicator lights up. 4 Adj st the vol HOLD HOLD E 5 S-BASS 1 4 2 3 FF REW +5 PHRASE 4 Playback starts from the front side. The OPE/BATT indicator lights up. 4 Adjust the volume. Basic operation Press the following buttons. To fast forward the FF button To rewind the REW button To stop the sbutton on the main unit the sRADIO OFF button on the remote conrol To change the playback side the dbutton during playback • If you press the FF or REW button during playback, playback starts automatically when the end of the tape is reached. Note After you press a button, if “beep” is heard several times and then operation does not start, check to see that the batteries do not wear out. Super bass Press the 5 S-BASS button to emphasize the low frequencies. display. Press the button again to resume the normal sound. the display. appears in the disappears from To repeat a 5-second phrase Press the +5 PHRASE button during playback. The tape is rewound to a point approximately *5 seconds before the point where the button was pressed and playback resumes automatically. * The time may vary according to the playback point of the tape when the button is pressed. Tape direction memory The playback side does not change when the tape stops. The next time jlbutton is pressed, playback starts on the same side. However, playback starts from the front side of the tape after: • The cassette holder is opened. • The dry cell batteries are removed. Caution Do not force the cassette holder to op...