Assessments - 4, GPA: 4.3
(
)
)
|
Facilidade de uso
Preparation Make sure the clock is set correctly. 1 Press one of the function buttons to select a source. 2 Press TIMER repeatedly until appears on the display. Time and audio source name flash alternately. 3 Within 6 seconds, turn MULTI JOG to designate the timer-on time, then press ENTER or a. Turning MULTI JOG changes both the hour and the minute. f or g is also available in place of MULTI JOG. Holding these buttons down will vary the time rapidly. 4 Within 4 seconds, turn MULTI JOG to select the duration for the timer-activated period. The duration can be set between 5 and 240 minutes in 5- minute steps. f or g is also available in place of MULTI JOG. The duration will be automatically set after 4 seconds. It will also be set if ENTER or a is pressed within 4 seconds after step 4. TIMER SETTING THE SLEEP TIMER The unit can be turned off automatically at a specified time. Use the remote control. 1 Press SLEEP. 2 Within 4 seconds, press f DOWN or g UP to specify the time until the power is turned off. The time changes between 5 and 240 minutes in 5-minute steps. MULTI JOG is also available in place of f or g. To check the time remaining until the power is turned off Press SLEEP once. The remaining time is displayed for 4 seconds. To cancel the sleep timer Press SLEEP twice so that “SLEEP oFF” appears on the display. Specified time KARAOKE TIMER 5 Adjust the volume. The source sound will play at the volume level set in this step when the power is turned on by the timer. If the volume level is set to 21 or higher, however, it will automatically be set to 20 when the power is turned on. 6 Prepare the source. To listen to a CD, load the disc to be played first on tray 1. To listen to a tape, insert the tape into deck 1 or 2. To listen to the radio, select the band and tune in to a station. 7 Press POWER to turn off the power. When the timer-on time is reached, the unit turns on and begins play with the selected source. You can change the source that was selected in step 1 by pressing one of the function buttons before pressing ENTER or ain step 3. To check the timer setting Press TIMER. The timer-on time, the selected source, and the duration for the timer-activated period will be displayed for 4 seconds. To change any of the previous setting Carry out from step 1. However, if you do not change the timer-on time, in step 3 just press ENTER twice and continue from step 4. To cancel the timer standby mode temporarily Press TIMER repeatedly so that disappears. To restore the timer standby mode, press again to display . Using the unit while the timer is set You can use the unit normally after setting the timer. Before turning off the power, carry out steps 5 and 6. • Timer playback and timer recording will not begin unless the power is turned off. • Connected equipment cannot be turned on and off by the built- in timer of this unit. Use an external timer. TIMER RECORDING Timer recording is applicable for TUNER and VIDEO/AUX/5.1CH (with an external timer) sources only. Press either TUNER/BAND or VIDEO/AUX/5.1CH to select a source, then press TIMER repeatedly until REC appears on the display. Within 6 seconds, carry out the steps of “SETTING THE TIMER” from step 3 and insert the tape to be recorded on into deck 2 after step 6. • If the timer recording is done with the economizing mode (page 7) set to “ECO ON” or “ECO AUTO” and the power turns off, the dimmer mode will be set to dimmest and the volume level will be 0 (minimum level) the next time the power is turned on. • You cannot use the timer function to record from a CD or tape. • You can check the timer setting by pressing TIMER even while the power is off. In this case, if you press ENTER or awithin 4 seconds after pressing TIMER, you can enter the timer setting mode and change the previous setting. 26 ENGLISH OTHER FEATURES DEMO (Demonstration) OTHER FEATURES DEMO (Demonstration) You can enjoy two kinds of DEMO modes on this unit. One is demo, the other one is game demo. In the demo mode, colorful illumination demonstrates in the display. In the game demo mode, you can play a game. To switch the two modes to each other, press POWER while pressing DEMO when the power is off. To play the game Demo 1 Press DEMO whether the unit is turned on or off, and whether the clock has been set or not. 2 Press d ddddd. Three numbers on the display start to run. 3 Press sonce. The number on the left side stops. 4 Press stwice to stop the remaining two numbers. Scoring: 20 points are given to start the game. If all the numbers are equal, 50 points are added to the score. If not equal, one point is subtracted. If the gained points reach 9999, you win. If the gained points fall to 0, you lose. To cancel the game Demo Press DEMO. To reset the game Demo Press DEMO twice. To change the probability of equalizing the three numbers Press for grepeatedly to select one of the three probability levels when playing the game Demo. The tray number indicator in the display changes between ...