Assessments - 4, GPA: 4.5
(
)
)
|
Facilidade de uso
3. Never use such chemicals as record sprays, antistatic sprays or fluids, benzine or thinner to clean compact discs. Such chemicals could irreparably damage the disc's plastic surface. 4. Discs should be put back in their cases after use to avoid serious scratches that could cause the sound to skip. 5. Do not expose discs to direct sunlight, high humidity, or high temperatures for extended periods of time. Long exposure to high temperatures can warp the disc. 6. Do not stick paper, labels, or tape on the disc surface. 7. Do not write with any type of pen, pencil, or marker on the disc surface. 8. To minimize fingerprints and smudges on the signal surface, always try to hold the discs by their outer edge and center hole. USE OF THE CD MAGAZINE LOADING DISCS INTO THE MAGAZINE Fig. 1 This CD Changer uses a specially-designed magazine to hold up to 10 compact discs. To load discs into the magazine, grip the tab on the magazine tray into which you will be loading a disc and pull it out gently as shown in Figure 1. Pull out only one tray at a time. Insert a disc into the tray with the label side up (play surface facing down) as shown in Figure 2. Push the tray back into the magazine as shown in Figure 3. Load discs into the remaining 9 trays in a similar manner. REMOVING DISCS FROM THE MAGAZINE Fig. 2 To remove a disc from the magazine, pull out the tray of the disc to be removed, lift out the disc, and push the tray back into the magazine. NOTES: . Avoid touching the playing side of the disc. . Only one disc can be inserted into each tray of the magazine. Do not try to insert more than one disc into each tray as damage to the discs and magazine may occur. . This changer is not designed to play 3" CD-Single discs (8cm). Inserting a 3" disc into the magazine, either with or without a 3" disc adaptor, can damage the changer and the disc. Such Fig. 3 damage will not be covered by the Warranty on this product. . Additional CD magazines are available as accessory item part numberSP11Mfrom your Audiovox dealer, or you may contact us directly at: Attention: Parts Division Audiovox Corporation 150 Marcus Blvd., Hauppauge, NY 11788 and/or 1-800-645-4994 Label side up Play side down MECHANICAL RELEASE ACCESS MECHANICAL RELEASE ACCESS Fig. 4 LOADING THE MAGAZINE INTO THE CHANGER Completely slide the door on the changer to the right as shown in Figure 4. Making sure the top of the magazine is facing upward, gently insert it into the unit until it clicks into place, as shown in Figure 5. Slide the door of the changer fully closed and the unit is ready for operation. REMOVING THE MAGAZINE FROM THE CHANGER The magazine can be removed from the changer using one of two Fig. 5 methods as outlined below in steps a and b. NOTE: Be sure to keep the door on the changer closed at all times when not loading or removing the magazine. Leaving the door open could allow dust, dirt and moisture to enter the changer which could cause the unit to malfunction. a. During normal operation with power applied, slide open the door on the changer and press the eject button as shown in Figure 6. The magazine will eject and can be removed. b. If the magazine will not eject in a normal manner, remove Fig. 6 HOLE (LEFT REAR) power by disconnecting the DIN cable from the changer. 1. Slide open the magazine door. At the lower left rear of the changer, as shown in Figure 6, insert a thin-bladed screwdriver straight into the access hole about 1-1/2 inches until it contacts the release tab. 2. Lightly leverage the blade to the right and the magazine will disengage and be ejected. EJECT BUTTON CD CHANGER OPERATING INSTRUCTIONS This CD Changer is designed to operate through a compatible Audiovox car stereo which incorporates the controls and display functions or through the FM section of any car stereo (requires accessory item CDC-MC1, CDC-MCR2, P-MC3 or P-MCR4 FM Modulator and Controller). Please check with your Audiovox stereo specialist for recommendations of the models that will work with this changer. The specific operating instructions for the changer will be contained within the Owner's Manual of the compatible unit. SPECIFICATIONS: Frequency Response: 5 - 20,000 Hz ±1dB Distortion: 0.008% @ 1kHz Dynamic Range: 95 dB Signal-to-Noise Ratio: 85 dB Channel Separation: 80 dB @ 1kHz Wow & Flutter: below measurable limits Dimensions: 9-5/8" W x 3-3/8" H x 6-7/8" D 245 mm x 85 mm x 174 mm Operating Voltage: 12 Volts DC, negative ground Current Drain: 800mA (Playback/loading/ejecting) Accessories Supplied: 10-disc magazine, P/N SP11M Mounting hardware (1set) Connecting cable (1ea.) 5 TROUBLESHOOTING An error made in operation or during installation of this product may be mistaken for a system malfunction. Please perform the checks described below before contacting your dealer or service facility. Symptom Possible Cause Remedy No power Blown fuse Check fuses in vehicle fuse box and changer system. Replace as necessary with fuse of same type and ...