Assessments - 0, GPA: 0
(
)
)
|
Facilidade de uso
Never pull the cord. Connect the AC power cord to: • the AC~ MAINS socket on the unit. • the wall socket. Note • To switch the unit off completely, disconnect the power cord from the power supply socket. EN 6 7 EN Option 2: Battery power Caution •• Risk of explosion! Keep batteries away from heat, sunshine or fire. Never discard batteries in fire. •• Batteries contain chemical substances, so they should be disposed of properly. Note •• Batteries are not supplied with the accessories. 1 Open the battery compartment. 2 Insert 6 batteries (type: R14/ UM2/ C CELL) with correct polarity (+/-) as indicated. 3 Close the battery compartment. AC~MAINS Turn on Switch the source selector to FM, Audio-in, or CD. Turn off Switch the source selector to OFF. Switch to standby mode If the unit is idle for 15 minutes, it switches to standby mode automatically. To exit the standby mode: • Press ; or • Select a source. 4 Play Play disc 1 Switch the source selector to CD. 2 Lift to open the disc compar tment. 3 Inser t a disc with the printed side facing up, then close the disc compar tment. » Play star ts automatically. Playable discs Note • You cannot play CDs encoded with copyright protection technologies. You can play these audio CDs: • CD-Recordables (CD-R) • CD-Rewritables (CD-RW) • MP3-CDs Control play In CD mode, you can control play through the following operations. / Select an audio file; Press and hold to fast-forward or fast-reverse the track during playback, then release to resume play. Skip to the previous or next MP3 album. Pause or resume play. Stop play. MODE [ ]: Play the current track repeatedly. [ ]: Play all tracks repeatedly. [ ] (for MP3 only): Play the current album repeatedly. [ ]: Play tracks randomly. To return to normal play, press MODE repeatedly until the repeat or shuffle icons disappear. VOLUME Adjust volume. Enhance bass To turn dynamic bass boost on or off, slide DBB switch to ON or OFF. Program tracks You can program a maximum of 20 tracks. 1 Press to stop playback. 2 Press PROG to activate the program mode. » [PROG] (program) begins to blink. 3 Press / to select a track number, and then press PROG to confirm. 4 Repeat step 3 to program more tracks. 5 Press to play the programmed tracks. » During play, [PROG] (program) and the preset number are displayed. • To erase the program, press twice. Listen to FM radio Note • Position the antenna as far as possible from TV, VCR or other radiation source. • For optimal reception, fully extend and adjust the position of the antenna. 1 Switch the source selector to FM. 2 Rotate - TUNING + to tune to an FM radio station. EN 8 Play from an external device You can also listen to an external audio device through this unit. 1 Switch the source selector to Audio-in. 2 Connect an audio cable (3.5mm, not supplied) to: • the Audio-in socket on the unit. • the headphone socket on an external device. 3 Play the external device (see the device's user manual). Note • The Audio-in socket is not for headphones. 5 Product information Note • Product information is subject to change without prior notice. Specifications Amplifier Rated Output Power 2 x 1 W RMS Frequency Response 63 -14000 Hz, -3 dB Signal to Noise Ratio Total Harmonic Distor tion <1 % >57 dBA Audio-in Input 650 mV RMS Disc Total Harmonic Distor tion <1% Frequency Response 63 -14000 Hz, -3 dB Signal to Noise Ratio >57 dBA Tuner Tuning Range Total Harmonic Distor tion <3 % FM: 87.5 - 108MHz Signal to Noise Ratio >50 dBA Speakers Speaker Impedance 8 ohm 9 EN General Power supply -AC Power220 - 240V, 50/60 Hz Operation Power Consumption 15 W - Batter y 9 V, 6 x 1.5 V R14/UM2 Standby Power Consumption < 0.5 W Dimensions - Main Unit (WxHxD)261 x 123 x 245 mm Weight - Main Unit 1.1 kg Maintenance Clean the cabinet • Use a soft cloth slightly moistened with a mild detergent solution. Do not use a solution containing alcohol, spirits, ammonia or abrasives. Clean discs • When a disc becomes dir ty, clean it with a cleaning cloth. Wipe the disc from the centre out. • Do not use solvents such as benzene, thinner, commercially available cleaners, or antistatic spray intended for analogue records. Clean the disc lens • After prolonged use, dir t or dust may accumulate at the disc lens.To ensure good play quality, clean the disc lens with Philips CD lens cleaner or any commercially available cleaner. Follow the instructions supplied with cleaner. 6 Troubleshooting Warning • Never remove the casing of this device. To keep the warranty valid, never tr y to repair the system yourself. If you encounter problems when using this device, check the following points before requesting ser vice. If the problem remains unsolved, go to the Philips Web page (t). When you contact Philips, make sure that the device is nearby and the model number and serial number are available. No power • Ensure that the AC power plug of the unit is connected properly. • Ensure that there is power at the AC outlet. • Inser t the b...
Este manual também é adequado para os modelos :CD-players - AZ305W/12 (1.47 mb)