Assessments - 3, GPA: 4.3
(
)
)
|
Facilidade de uso
Press PROG again to exit the program facility: the display flashes ‘CONTINUE’ and shows ‘0’. Skip and Search Track Skip track backwards and forwards; Search backwards and forwards (see page 5) TIME Press TIME once to display the remaining time of the currently playing track. Press again to display the time remaining on the disc. Press a third time to turn the text display on. Press TIME again and the display reverts to its original setting, showing the time elapsed for the current track. For CDs with text, pressing TIME once while the disc is loaded but not playing displays the artist’s name. Pressing TIME a second time displays the total number of tracks and the total playing time. DISP (Display) Turns the display on or off. Turning the display off generally produces a slight improvement in sound quality. OPEN Opens and closes the CD tray. Source selection These operate in the same way as the source selector on the front panel of an Arcam integrated amplifier. CD62 6 0–9 keypad This allows direct access to individual tracks on the disc. To select a track, press the corresponding keypad button. For tracks greater than 9, enter the digits in sequence. For example, to play track 15, press and hold 1 until the number on the display moves to the left, then press 5. Playback control Play, Stop and Pause (see page 5). REPEAT To repeat the entire CD or a pre-programmed selection of tracks press REPEAT once: ‘REPEAT’ lights on the display. To repeat a particular track, select that track and then press REPEAT twice so that ‘REPEAT 1’ is shown on the display. If you now select a different track, that track is repeated instead. To cancel the repeat function press REPEAT a third time. A–B This button enables you to repeat any section of music within a track. Whilst the disc is playing, press the A–B button at the start of the section you wish to repeat. ‘REPEAT’ is shown on the display and the letter ‘A–’ flashes. Press the button a second time when you reach the end of the section you wish to repeat. The ‘A–B’ letters stop flashing and remain lit. This section will repeat until you press or or . The forward search button ( ) moves forward within the selected loop. SHUFFLE Press once to shuffle play CD tracks (i.e. play them in a random order). Press again to cancel shuffl e play. MUTE Stops sound to the speaker outputs of certain Arcam amplifiers. VOL (Volume) +/– Adjusts the volume on Arcam remote-controllable amplifiers. Note that the volume (+/–) controls and MUTE button have no effect on the audio output level of the CD players. NOTE: Remember to install the two AAA batteries supplied before trying to use your remote control. Do not place anything in front of the display area on the CD player (where the IR receiver is located), or the remote control may not work. Technical specification Digital to Analogue conversion Physical 24-bit multilevel Delta-Sigma DAC Dimensions W430 x D290 x H84mm Weight 4.6kg nett/6.1kg packe Laser pick-up 3 beam Power consumption 32VA maximum Laser wavelength 780nm Numerical aperture 0.45 Digital output connection 75. co-axial Dynamic range 106dB optical TOSLINKSignal to noise ratio (CCIR) Harmonic distortion (0dB, 1kHz) >100dB <0.005% Supplied accessories Frequency response (±0.5dB) Output level (0dB) Output impedance Minimum recommended load 5Hz–20kHz 2.3Vrms 120. 5k. E&OE Mains lead CR224 remote control 2 x AAA batteries NOTE: All specification values are typical unless otherwise stated. Continual improvement policy Arcam has a policy of continual improvement for its products. This means that designs and specifications are subject to change without notice. Radio interference The CD62 is a digital audio device which has been designed to very high standards of electromagnetic compatibility. The CD player and DAC generate, and can radiate RF (radio frequency) energy. In some cases this can cause interference with FM and AM radio reception. If this is the case, keep the CD player and its connecting cables as far from the tuner and its aerials as possible. Connecting the CD player and the tuner to different mains sockets can also help to reduce interference. EC COUNTRIES -– This product has been designed to comply with directive 89/336/EEC. USA – This product complies with FCC requirements. Laser radiation If an Arcam CD player is operated whilst the outer casing is removed, invisible laser radiation could cause eye damage. CD62 7 Guarantee Worldwide Guarantee This entitles you to have the unit repaired free of charge, during the first two years after purchase, at any authorised Arcam distributor provided that it was originally purchased from an authorised Arcam dealer or distributor. The manufacturer can take no responsibility for defects arising from accident, misuse, abuse, wear and tear, neglect or through unauthorised adjustment and/or repair, neither can they accept responsibility for damage or loss occurring during transit to or from the person claiming under the guarantee. The war...