Assessments - 1, GPA: 4
(
)
)
|
Facilidade de uso
3 EN 2 Your clock radio Congratulations on your purchase, and welcome to Philips! To fully benefit from the support that Philips offers, register your product at What's in the box (Fig. ) a 3 Get started Caution ••Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. Always follow the instructions in this chapter in sequence. Install battery If there is power interruption, the clock memory backup allows your alarm and clock settings to be stored for up to a day. The display backlight will be off. Caution ••Risk of explosion! Keep the battery away from heat, sunshine or fire. Never discard battery in fire. ••The battery contains chemical substances, so it should be disposed of properly. Insert 2 x 1.5V AAA battery (not supplied) with correct polarity (+/-) as illustrated. (Fig. ) b ........ EN Connect power Caution ••Risk of product damage! Make sure that the power voltage corresponds to the voltage printed on the back or underside of the clock radio. ••Risk of electric shock! When you unplug the power adapter, always pull the plug from the socket. Never pull the cord. Note ••The type plate is located at the bottom of the clock radio. (Fig. ) c Set time Note ••You can only set time in standby mode. (Fig. ) 12 sec234dPRESET/ SET TIMEPRESET/ SET TIME HOUR MIN EN 4 Listen to FM radio Note ••Keep the clock radio away from other electronic devices to avoid radio interference. ••For better reception, fully extend and adjust the position of the FM antenna. Tune to FM radio stations (Fig. ) e2 sec2 RADIO ON/OFF1MINTUNING2 secHOURTUNING34- VOLUME + Store FM radio stations manually You can store up to 10 FM radio stations. 1 Tune to an FM radio station. 2 Press and hold PRESET for two seconds. »»The preset number begins to blink. 3 Press TUNING repeatedly to select a number. 4 Press PRESET again to confirm. 5 Repeat steps 1 to 4 to store other stations. Tip ••To remove a pre-stored station, store another station in its place. Select a preset radio station In tuner mode, press PRESET repeatedly to select a preset number. Adjust volume While listening, press - VOLUME + to adjust volume. »»The volume level (1~15) shows in the display. EN 5 Other features Set alarm timer Set alarm Note ••You can only set the alarm in standby mode. ••When alarm sounds, volume rises gradually. You cannot adjust the alarm volume manually. ••Make sure that you have set the clock correctly. Follow the illustration to set the first alarm. (Fig. ) • AL1: set the first alarm. • AL2: set the second alarm. f2 secAL11HOUR2MIN3AL14 Tip ••The clock radio exits alarm setting mode when being idle for 10 seconds. Select alarm source You can select FM radio or buzzer as the alarm source. (Fig. ) »»The corresponding alarm icon lights up. • The AL2 setting is the same as AL1. AL1FMAL1gAL1 Activate/deactivate alarm timer Press AL1 or AL2 repeatedly to activate or deactivate the alarm timer. »»If the alarm timer is deactivated, the alarm indicator turns off. »»The alarm repeats ringing for the next day. Snooze alarm When alarm sounds, press SNOOZE. »»The alarm snoozes and repeats ringing nine minutes later. EN Set sleep timer This clock radio can switch to standby mode automatically after a preset period. (Fig. ) h120 90 60 30 15OFFSLEEP To deactivate the sleep timer: • Press SLEEP repeatedly until [OFF] (off) appears. Adjust brightness Press BRIGHTNESS repeatly to adjust display brightness. iBRIGHTNESS 6 Product information Note ••Product information is subject to change without prior notice. Specifications Amplifier Total Output Power 0.4W RMS Tuner (FM) Tuning range 87.5-108 MHz Tuning grid 50 KHz Sensitivity - Mono, 26 dB S/N Ratio - Stereo, 46 dB S/N Ratio <22 dBf <49.5 dBf Total Harmonic Distortion <2% Signal to Noise Ratio >50 dBA General information AC power (power adapter) Brand name: Philips; Model: AS030-050- EE050; Input: 100-240 V~, 50/60 Hz; 0.15 A; Output: 5.0 V 0.5 A Operation Power Consumption 1.2 W Standby Power Consumption <1 W EN Dimensions: Main Unit (W x H x D) 191 x 103 x 69.5 mm Weight: -Main Unit 0.33 kg 7 Troubleshooting Warning ••Never remove the casing of this apparatus. To keep the warranty valid, never try to repair the system yourself. If you encounter problems when using this apparatus, check the following points before requesting service. If the problem remains unsolved, go to the Philips web site (philips.com/welcome). When you contact Philips, ensure that the apparatus is nearby and the model number and serial number are available. No power ••Ensure that the AC power plug of the unit is connected properly. ••Ensure that there is power at the AC outlet. No sound ••Adjust the volume. No response from the unit ••Disconnect and reconnect the AC power plug, then turn on the unit again. Poor radio reception ••Increase the distance between the unit and your TV or VCR. ••Fully extend the FM antenna. Alarm does ...