The battery is used to save information regarding the current time and alarm settings in case of AC power interruption. • Set the AUTO/OFF/ON (1) selector to the Off position and plug the power plug into the outlet; the display will start to blink. • To set the current time, press and hold the TIME (6) button, then use the HOUR (10) and MIN (9) buttons to set the current time. SETTING THE PROJECTED TIME • To project the current time onto the wall, point the projector away from itself and into a horizontal position. • Turn on the projector using the PROJECTION ON/OFF (18) button; use the FOCUS (23) dial to achieve a sharp image on the wall. • To set the current time on the projector, press and hold the TIME (20) button, then use the MIN (22) and HOUR (21) buttons to set the current time. NOTE: THE PROJECTION DISTANCE OF THE TIME IN A DARK ROOM IS FROM 0.9 TO 2. 7 m. SETTING THE ALARM TIME • Press and hold the ALARM (5) button; use the HOUR (9) and MIN (10) buttons to set the desired alarm time. WAKING UP TO THE RADIO Set the alarm time as instructed above. Set the AUTO/OFF/ON (1) selector to the On position. Tune the radio to the desired station and adjust the volume. Set the ALARM RADIO/BUZZ (24) selector to RADIO. Set the AUTO/ON/OFF (1) selector to AUTO. The alarm will activate at the pre-set time and will automatically turn off after 1 hour and 59 minutes. WAKING UP TO BUZZER ALARM • Set the alarm time as indicated above. • Rotate the VOLUME/BUZZ (24) dial counterclockwise until it clicks in order to activate the BUZZ alarm mode. • Set the Auto/Off/On (1) selector to Auto. The buzzer alarm will activate at the set alarm time. TURNING OFF THE ALARM • Press the ALARM SET/OFF (5) button to turn off the alarm; the set alarm time remains saved for use the next day. • Set the AUTO/ON/OFF (1) selector to the OFF position to turn off the alarm permanently. SNOOZE MODE • You can temporarily silence the alarm (buzzer or radio) by pressing the Snooze (4) button; the alarm will automatically activate again in 9 minutes. -Q~ 3 3 5 08.qxd 11.03.05 16:44 Page 4 ENGLISH SLEEP MODE • Set the Auto/Off/On (1) selector to the Auto position. • Press the SLEEP (7) button; the radio will activate and the timer will begin counting down from 59 minutes until radio shut-off. • To change the shutoff time, hold down the SLEEP (7) button and use the MIN (10) button to set the desired time from 59 to 1 min. • Press the SNOOZE (4) button to turn off the SLEEP MODE. RADIO • AM band reception uses an internal antenna; when tuning a radio station, turn the radio itself in order to achieve optimal reception. • For best reception in the FM band, make sure that the FM Antenna wire is fully extended. • Set the AUTO/ON/OFF (1) selector to ON. • Set the BAND AM/FM (12) selector to the desired band. • Turn the TUNING (13) dial to set the desired radio station. • Use the VOLUME (11) dial to set the desired volume. • To turn off the radio, set the AUTO/ON/OFF (1) selector to the OFF position. If the radio will not turn off, then the sleep mode is probably activated; otherwise press the SNOOZE (4) button. TECHNICAL CHARACTERISTICS Frequency bands AM 530 - 1600 kHz, FM 64 - 108 Mhz Backup power 9 V 6F-22 battery. Power requirements AC 230V ~ 50 Hz, Power usage 8 Watts The manufacturer reserves the right to make changes to the technical characteristics of this device without prior notice. Service life - no less than three years. GUARANTEE Details regarding guarantee conditions can be obtained from the dealer from whom the appliance was purchased. The bill of sale or receipt must be produced when making any claim under the terms of this guarantee. This product conforms to the EMC-Requirements as laid down by the Council Directive 89/336/EEC and to the Low Voltage Regulation (23/73 EEC) 4 3508.qxd 11.03.05 16:45 Page 5 DEUTSCH UHRENRADIO MIT PROJEKTOR MODELL: VT-3508 1. UMSCHALTER (POWER) AUTO / AN / AUS (AUTO/ON/OFF) 2. LED-INDIKATOR 3. AUTO-BETRIEB-INDIKATOR (AUTO) 4. EINSCHALTEN DER SCHLUMMERFUNKTION /ABSTELLEN DES TIMERS (SNOOZE) 5. EINSTELLEN/ABSTELLEN DES WECKERS (ALARM SET/OFF) 6. EINSTELLEN DER UHRZEIT (SET/OFF TAME) 7. EINSTELLEN DES SLEEP-MODUS (SLEEP) 8. UMSCHALTER (DIMMER) DISPLAYHELLIGKEIT NIEDRIG/HOCH (LOW/HIGH) 9. STUNDENEINSTELLUNG (HOUR) 10.MINUTENEINSTELLUNG (MIN) 11.LAUTSTÄRKENREGELUNG DES RADIOS (VOLUME) 12.BANDUMSCHALTER (BAND AM/FM) 13.RADIOABSTIMMUNG (TUNING) 14.FACH FÜR NOTPEISUNGSBATTERIE 15.FM-ANTENNE 16.NETZSCHNUR 17.ABSTIMUNGSSKALA DES RADIOS 18.PROJEKTOR AN/AUS (PROJETION ON/OFF) 19.PROJEKTOR 20.TASTE DER UHRZEITEINSTELLUNG FÜR DIE PROJEKTIONSUHR (TAME) 21.TASTE FÜR STUNDENEINSTELLUNG (HOUR) 22.TASTE FÜR MINUTENEINSTELLUNG (MIN) 23.FOKUSEINSTELLUNG (FOCUS) 24.UMSCHALTER WECKER RADIO/ SUMMER (ALARM RADIO/BUZZ) WECHSELSTROMNETZSPEISUNG Überzeugen Sie sich vor dem Einschalten davon, dass die Netzstromspannung der Betriebsspannung des Gerätes ents...