Assessments - 2, GPA: 3.5
(
)
)
|
Facilidade de uso
NOTE: Brake levers must face rear of stroller. Rear Wheel Assembly Fold Locks Cross Tube ASSEMBLY continued 3 Secure Wheel to Axle as shown: • Push Connector onto Axle with Ribs facing in. • Slide Wheel onto Axle and push into Connector. • Slide Wheel Retainer onto end of Axle. Make sure large end of Wheel Retainer is towards Wheel. Wheel Retainer should snap into groove on end of Axle. • Snap wheel Retainer Cap over Wheel Retainer. • Line up Hub Cap tabs with slots in Wheel and snap Hub Cap in place. Ribs Hub Connector Cap Axle Brake Lever Retainer Bracket Cap CAUTION: • Failure to install retainer cap may cause wheels to come off of stroller. • After wheel assembly is complete, pull on wheels to check that they are locked into place. Wheel Retainer Wheel WARNING Prevent a possible choking hazard, discard axle protectors and polybag which contained rear wheel parts. 4 Attaching Cup Holder and Storage Pouch • Snap one end of cup holder over stroller frame above canopy, rotate down to opposite side and snap in place. • Snap both straps of storage pouch over stroller handle as shown. WARNING • To avoid burns, never put hot liquids in cup holder. • Avoid possible tipping. DO NOT place more than 3 lbs. (1.4 kg) in cup holder and storage pouch combined. Adjusting Handle 1 Twist both handle locks inwards until loose. 2 Grasp center of handle and pull out to desired length. 3 Twist both handle locks outwards until they are tight. DO NOT over tighten handle locks. 1 Set both rear brakes to prevent stroller from moving. 2 Position child’s tray in up position: • Rotate child’s tray over lower edge of seat. • Push child’s tray into slots. • Pull on child’s tray to be sure it is securely locked. 3 Position stroller back support in reclined position: Squeeze both levers on sides of seat back to release. 4 With car seat handle in locked carrying position (upright) insert car seat adapter Tongue into child’s tray Slot. NOTE: • Before attaching car seat, be sure to remove tongue of child’s tray pad by pulling out red button and pulling up on child’s tray pad. • Car seat may be placed in child’s tray slot either rear-facing or forward-facing. 1 LOCKING: Push down on both brake levers. 2 UNLOCKING: Push up on both brake levers. CAR SEAT/STROLLER USE Locking Or Unlocking Rear Wheels 5 Attaching Car Seat Rear-facing Forward-facing Tongue Slot Tongue Slot Smooth Surfaces - Use swivel wheels. Push lever up on front of wheel so that wheels can swivel freely. Rough Surfaces - Use straight wheels. Push lever down on front of wheel. When wheels are straight, they lock in place for straight tracking. Locking Or Unlocking Front Wheel Swivels 5 Attach appropriate snaps to secure car seat to stroller: NOTE: Use of proper snaps provide the snuggest attachment to stroller frame. 6 Pull up on car seat to be sure it is locked in child’s tray. NOTE: Car seat comes with a level indicator which is not applicable when car seat is used in stroller frame. 1 Set both rear brakes to prevent stroller from moving. 2 Be sure handle is locked in upright carrying position. DO NOT lift car seat from child’s tray until you have heard a “click” sound and have checked that handle is locked. 3 Pull Red Button on front of child’s tray out and lift car seat. 4 After removing car seat, insert Tongue of child’s tray pad into child’s tray Slot. CAR SEAT/STROLLER USE continued WARNING Avoid serious injury from falling or sliding out: • Always use harness straps to restrain child, even when sleeping. • Always be sure car seat handle is in locked upright carrying position when lifting or carrying child. • Always make sure car seat is locked into child’s tray before each use. • Always be sure stroller is fully set up and fold locks are engaged before using. • Always be sure brakes are locked when attaching and removing car seat from stroller frame. 6 Removing Car Seat Red Button Slot Tongue Forward-facing Snap Rear-facing Snap STROLLER USE 1 LOCKING: Push down on both brake levers. Insert Tongue of child’s tray pad into child’s tray Slot. Locking Or Unlocking Rear Wheels Closing Child’s Tray Slot Slot Tongue 2 UNLOCKING: Push up on both brake levers. Locking Or Unlocking Front Wheel Swivels Smooth Surfaces - Use swivel wheels. Push lever up on front of wheel so that wheels can swivel freely. Rough Surfaces - Use straight wheels. Push lever down on front of wheel. When wheels are straight, they lock in place for straight tracking. Canopy Positions Canopy has two (2) positions: opened and closed. Car seat and stroller can be used together with both canopies closed. WARNING Prevent serious injury: • Make sure child is clear of any moving parts when you adjust stroller. • DO NOT place parcels on top of canopy. Stroller may be used with Child’s Tray up or down. 1 For up position: • Rotate child’s tray over lower edge of seat. • Push child’s tray into slots. • Pull on child’s tray to be sure it is securely locked. 2 For down position: • Push child’s tray Release Buttons on...