Assessments - , GPA: ( )

Instruções de Operação InStep, Modelo 10K

Fabricante : InStep
Arquivo Tamanho: 591.3 kb
Arquivo Nome : 1b67d2d8-5c23-41ea-b021-974d2d4a2901.pdf

Língua de Ensino:

O documento está colocado, por favor, espere

Baixe o seu Fechar

O documento está colocado, por favor, espere

Baixe o seu Fechar

In the event you notice the stroller veering to one direction, loosen front axle Q/R lever, point the front wheel in the opposite direction the stroller is veering, and retighten the Q/R lever. If you need help making this adjustment, please call our Customer Service department for assistance. Note: If it is necessary to remove the front wheel, you will find it easier to open the brake Q/R lever by taking pressure off the cable. This is achieved by squeezing the brake pads with one hand while rotating the lever backward (toward the seat) (Figure E). WARNING: Always be sure to reengage the brake by rotating the Q/R lever forward (toward the front wheel) before using the stroller. Step 4. Front Fender Assembly Insert the #8 – 11/2" screws into the holes located on the front support between the front forks. Align the 2 holes on the bottom side of the fender with the screws and tighten with a Phillips screwdriver. Note: The Double Models have 4 screws. Step 5. Canopy Positioning The canopy has adjustable positions. Pull the canopy down to the desired position. Step 6. Attaching Wrist Strap Place strap on top of handle bar. The wrist strap has different sized loops. The large loop will go on your wrist, the small loop will be on handlebar. Slide end with large loop through the small loop, then grasp the end with the large loop and pull strap to tighten on handlebar. WARNING: Whenever child is in stroller always use the wrist strap. Before you remove the wrist strap from your wrist make sure you first engage the rear brakes. Use Instructions To close/fold stroller: WARNING: Always remove child from stroller before folding. Pull the back of the seats forward. It will be easier to fold if the seats are not in the recline position. Remove locking pin from side latch on the stroller frame (Double Models have 2 locking pins). Using one hand on each lever, pull the levers from the lower bar. The stroller will automatically begin to fold, the front wheel will fold under frame and the handle will fold backwards (Figure F). 4 To open stroller: Grasp handle with one hand and pull up on the front fork with your other hand. Lock both plastic latches onto the lower frame, insert locking pin into hole in latch and frame, lock the pin in place by slipping the wire loop over the end of the locking pin (Figure G). On Double Models repeat for other side. To engage rear brakes: Step lightly on the levers next to the rear wheels until the cogs of the brakes engage the cogs of the wheel. Repeat on other side. To release brake, lift levers using your toe until cogs disengage (Figure H). To operate front caliper brake: The front brake operates the same as a bicycle hand brake. Squeeze lever located on handlebar to engage front brake. Release lever to disengage. PROPER USE OF SEAT BELTS & SHOULDER STRAPS: WARNING: Avoid serious injury from falling or sliding out. Always use seatbelt. 1. Place child in seat. Make sure T-shield is between the child’s legs. 2. When child is seated, place shoulder straps over the child’s shoulders. 3. Slide waist straps through lower loops of shoulder straps, bring lap belt ends together and clip into place around child’s waist. Adjust waist and shoulder straps for snug fit (Figure I). To recline seat: To fully recline, unhook buckle on back of the seat (Figure J). To place seat in upright position, push seat forward and reconnect buckle located on back of seat. To adjust the recline position, adjust the slide on the strap. WARNING: Child may slip into leg openings and strangle. Never u...