Assessments - 4, GPA: 3.8
(
)
)
|
Facilidade de uso
Maintenance Use only original equipment replacement parts. Other parts may not perform as well, may damage the unit, and may result in injury. In addition, use of other parts may void your warranty. We recommend that you see any Briggs & Stratton Authorized Dealer for all maintenance and service of the engine and engine parts. NOTICE: All the components used to build this engine must remain in place for proper operation. Emissions Control Maintenance, replacement, or repair of the emissions control devices and systems may be performed by any non-road engine repair establishment or individual. However, to obtain “no charge” emissions control service, the work must be performed by a factory authorized dealer. See the Emissions Warranty. Not for Reproduction WARNING Unintentional sparking can result in fire or electric shock. Unintentional start-up can result in entanglement, traumatic amputation, or laceration. Fire hazard Before performing adjustments or repairs: • Disconnect the spark plug wire and keep it away from the spark plug. • Disconnect battery at negative terminal (only engines with electric start.) • Use only correct tools. • Do not tamper with governor spring, links or other parts to increase engine speed. • Replacement parts must be the same and installed in the same position as the original parts. • Do not strike the flywheel with a hammer or hard object because the flywheel may later shatter during operation. When testing for spark: • Use approved spark plug tester. • Do not check for spark with spark plug removed. Maintenance Chart First 5 Hours • Change oil Every8HoursorDaily • Check engine oil level • Clean area around muffler and controls Every 100 Hours or Annually • Clean air filter * • Clean pre-cleaner (if equipped) * • Change engine oil and filter • Replace spark plug • Check muffler and spark arrester • Check valve clearance ** Every 400 Hours or Annually • Change air filter • Replace fuel filter • Clean air cooling system * • Clean oil cooler fins * * In dusty conditions or when airborne debris is present, clean more often. ** Not required unless engine performance problems are noted. Carburetor Adjustment Never make adjustments to the carburetor. The carburetor was set at the factory to operate efficiently under most conditions. However, if adjustments are required, see a Briggs & Stratton Authorized Dealer for service. NOTICE: The manufacturer of the equipment on which this engine is installed specifies the top speed at which the engine will be operated. Do not exceed this speed. How To Replace The Spark Plug -Figure Check the gap (A, Figure 5) with a wire gauge (B). If necessary, reset the gap. Install 5 and tighten the spark plug to the recommended torque. For gap setting or torque, see the Specifications section. Note: In some areas, local law requires using a resistor spark plug to suppress ignition signals. If this engine was originally equipped with a resistor spark plug, use the same type for replacement. BRIGGSandSTRATTON.COM Inspect Muffler And Spark Arrester -Figure 6 How To Service The Air Filter -Figure 11 WARNING Running engines produce heat. Engine parts, especially muffler, become extremely hot. Severe thermal burns can occur on contact. Combustible debris, such as leaves, grass, brush, etc. can catch fire. • Allow muffler, engine cylinder and fins to cool before touching. • Remove accumulated debris from muffler area and cylinder area. • It is a violation of California Public Resource Code, Section 4442, to use or operate the engine on any forest-covered, brush-covered, or grass-covered land unless the exhaust system is equipped with a spark arrester, as defined in Section 4442, maintained in effective working order. Other states or federal jurisdictions may have similar laws. Contact the original equipment manufacturer, retailer, or dealer to obtain a spark arrester designed for the exhaust system installed on this engine. Inspect the muffler (A, Figure 6) for cracks, corrosion, or other damage. Remove the spark arrester (B), if equipped, and inspect for damage or carbon blockage. If replacement parts are required, make sure to use only original equipment replacement parts. WARNING: Replacement parts must be the same and installed in the same position as the original parts or fire could result. How To Change The Oil -Figure 78910 Used oil is a hazardous waste product and must be disposed of properly. Do not discard with household waste. Check with your local authorities, service center, or dealer for safe disposal/recycling facilities. Remove Oil 1. With engine off but still warm, disconnect the spark plug wire (A) and keep it away from the spark plug (Figure 7). 2. Remove the oil drain plug (B, Figure 8). Drain the oil into an approved container. 3. After the oil has drained, install and tighten the oil drain plug. Change The Oil Filter (if equipped) Some models are equipped with oil filter. For replacement intervals, see the Maintenance chart. 1. Drain the oil f...
Este manual também é adequado para os modelos :Dispensadores - VANGUARD 300000 (4.37 mb)
Dispensadores - VANGUARD 350000 (4.37 mb)
Dispensadores - VANGUARD 380000 (4.37 mb)