Log:
Assessments - 4, GPA: 4.5 ( )

Instruções de Operação Everpure, Modelo Drinking Water Test Kit WT1

Fabricante : Everpure
Arquivo Tamanho: 38.93 kb
Arquivo Nome : wt1-instruction-sheet.pdf
Língua de Ensino: en
Ir para baixar



Facilidade de uso


bacteria test instructions 1. Take out the Bacteria Test vial and set upright on a flat surface. 2. Collect water sample or turn on tap to a very slow stream. 3. Carefully twist off cap and fill vial to 1/2 inch below the top (to 5 ml line). DO NOT OVERFILL and DO NOT SPILL the bacterial growth powder in the vial. 4. Replace the cap and twist on tightly. Shake the vial vigorously for 20 seconds. 5. Place the capped vial upright in a warm area (70-90°F) where it cannot be disturbed for 48 hrs. 6. After 48 hrs., observe the color of the liquid without opening the vial: Purple Color: Negative Result (No bacteria were detected) Yellow Color: Positive Result (It is highly likely that potentially harmful bacteria were detected) 7. For positive results, add bleach to the sample before pouring down the toilet, then wash hands carefully. Negative samples may be poured directly into the toilet. Discard vial in the trash. lead / pesticide test instructions The Lead Test can detect dissolved lead at levels below the EPA Action level of 15 parts per billion (ppb). The Pesticide Test detects two of the most common pesticides used in the US at or below the EPA Maximum Contaminant Level (atrazine - 3 ppb, and simazine – 4 ppb). 1. Open Lead / Pesticide packet and take out all contents. The packet contains a test vial, a dropper pipette, two test strips, and a desiccant (to be discarded). 2. Using dropper, place exactly TWO dropper-fuls of water sample into test vial. To pick up sample, tightly squeeze the bulb at the end of the dropper and place the open end into water sample. Release the bulb to pick up sample, then squeeze again to expel sample into vial. 3. Swirl vial gently for several seconds. Place on a flat surface. 4. Place both test strips into the test vial, with arrows pointing DOWN. 5. Wait 10 minutes. Do not disturb strips or vial during this time. Blue lines will appear on the strips. 6. Take the strips out of the vial and read results. Negative: Bottom line (next to number 1) is darker than top line (next to number 2) . If you only see one line next to number 1, the test is negative. 22 22 1111 Positive: Top line (next to number 2) is darker than bottom line (next to number 1), or lines are equally dark. 22 22 1111 7. Note: If no lines appear, or both lines are very light, the test did not run properly and the result is not valid. If a test strip shows a positive result, your water sample may contain lead or pesticides at a toxic level. nitrate / nitrite test instructions 1. Carefully open Nitrate / Nitrite Test packet and take out test strip. ...

Este manual também é adequado para os modelos :
Dispensadores - Drinking Water Test Kit WT1 (38.93 kb)

Escreva a sua própria avaliação do dispositivo



Mensagem
Seu nome :
Introduza os dois dígitos :
capcha





categorias