Assessments - 3, GPA: 3.7
(
)
)
|
Facilidade de uso
Do not cut or remove the third (ground) prong from the power cord under any circumstances. Any questions concerning power and/or grounding should be directed toward a certified electrician or an authorized Avanti Products service center. ? This water dispenser is not recommended for outdoor use. ? Do not locate the dispenser in area where the temperature may fall below freezing (32. F). ? Keep area around dispenser free of dust and dirt. ? Keep the reserve supply of water bottles away from excessive heat and light. ? Never unplug the water cooler, except for maintenance. Height Adjustment ?Unit is provided with four feet extensions, if you wish to make the unit taller, just attach all four parts to the bottom feet by placing them on existing feet and pushing firmly to ensure a tight fit. Unit will be slightly taller. The adjustable foot can still be used for leveling after the extension part is inserted. 8 OPERATION INSTRUCTIONS: Before Using Your Water Dispenser ? Check to be sure the following parts are included: • Instruction manual • 4 extra cup dispenser cabinet plugs • Accessories order form. • 4 height adjustment foot extensions ? Before connecting the appliance to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation. ? The water dispenser is pre-cleaned at the factory but the reservoir and water lines must be flushed with fresh water before use as follows: ? Keep the unit unplugged. ? Fill water tank with tap water full to capacity (more than 3/4 of a gallon). Wait for 5 minutes until water settles. ? Press the hot water faucet until water comes out, then stop. ? Plug the dispenser into the electrical outlet. Both heating and cooling indicator lights on front will light up at first. We are ready to complete the first cycle. In order to do that, wait for the hot water indicator light to go off first (approximately 10 minutes), then wait for the cold water indicator light to go off (another 40 minutes, approximately). ? Unplug the dispenser from the electrical outlet. Proceed to drain the water from the faucets one at a time until no more water remains. (Note: To facilitate this operation, use a large container). ? Then, drain any water left in the tanks by opening the drain plug located on the back, until it drains completely. ? Proceed to close the drain cap. ? Place the 5-gallon bottle of water on the water intake, allow water to stand for approximately one minute. ? Open water faucets to insure water flows from both faucets. ? Plug dispenser into the elec trical outlet. ? Now you are ready to use your water dispenser. NOTE: Your water dispenser has been cleaned and sanitized before leaving the factory, but in case a taste problem develops, place two tablespoons of baking soda and add tap water. Fill water tank again and repeat basic operations previously outlined, except turn the switch marked HOT “OFF” to avoid leaving residues in hot water tank. ATTENTION: If you do not plan to use the water heating function for more than three days, we recommend that you turn the HOT switch to the “OFF” position. ATTENTION: If you do not plan to use the water heating function for more than three days, we recommend that you turn the HOT switch to the “OFF” position. ?WARNING? IMPROPER USE OF THE GROUNDED PLUG CAN RESULT IN THE RISK OF ELECTRICAL SHOCK. IF THE POWER CORD IS DAMAGED, HAVE IT REPLACED BY AN AUTHORIZED AVANTI PRODUCTS SERVICE CENTER. 9 OPERATING YOUR WATER DISPENSER • Steps to replace water bottles ? Use a clean cloth to wipe off neck of bottle. ? Remove cap. ? Carefully lift bottle (approx. 40 lbs.) using your legs and not your back. Do not place hands on opening of bottle while placing in reservoir. ? Insert the water bottle on the water intake over reservoir opening so it settles properly on it. ? Wipe off any water which may have splashed on dispenser top. ? When a new bottle is installed you must open the hot water faucet and remove no less than 4 full cups of water to insure the water flows properly and the water reservoir is at the proper level. • Electrical Connection This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electrical shock. Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord. Any questions concerning power and or grounding should be directed toward a certified electrician or an authorized Avanti Products service center. This appliance requires a standard 115/120-volt. 60Hz electrical outlet with three-prong ground. The cord should be secured behind the appliance and not left exposed or dangling to prevent accidental injury. Do not use an adapter plug with this appliance. Do not use an exten...