.. . Easy to replace water filter integrated in pullout spout HELPLINE: 1-800-BUY-MOEN INS115D plate or single hole deck ring WELCOME TO MOEN® Congratulations! You’ve purchased the revolutionary PureTouch® Filtering Faucet System. This faucet is the first of its kind and is designed to provide great tasting, cleaner water with just one touch. To get the most enjoyment from your Moen PureTouch Filtering System, please read all installation and operating instructions carefully. With simple care an

10.Pull pullout spout in and out to check for free movement of hose. If needed, adjust the placement of weight to aid the clearance of the hose. 11.Faucet flushing is required before installation is complete. (See below) LINE FLUSHING INSTRUCTIONS IMPORTANT: Pipe chips, sand, stones and other solids found in new and renovated plumbing can damage the sealing surfaces of the filter cartridge and cause a leak. To avoid damage, DO NOT TURN ON SUPPLY VALVES until instructed below. 1. Pull hose out of

For the dealer nearest you, call 1-800-BUY-MOEN. Use only MicroTech filter cartridges with the PureTouch® Filtering Faucet System. Do not remove the filter until it is to be replaced. 1. Remove pullout spout (19) from receptor (15) and tie a dish towel around the hose to keep it from slipping back into the spout receptor. 2. Disconnect the quarter turn connector (18) from pullout spout by turning it counterclockwise one quarter turn. Quarter turn connector will remain on the hose. 3. Remove the

Insert the u-clip into the two square holes at the bottom rear of the manifold and push up to release the filter housings. Remove the housings with a downward twisting pull. 6. Remove the particle filter cartridge and the activated carbon cartridge and discard. If the RO membrane filter will be reused, clean the outside with a wet paper towel and place the membrane filter in a clean, unused plastic bag. 7. Wet some paper towels with the diluted bleach solution. Clean the inside of the housings a

Trust Culligan for the best water you can get, anytime you want it. Our goal is to provide you with the highest quality water, and the best possible service. For your home. For your health. For your family. Operating Specifications Pressure Range: 30–125 psi (2.1–8.6 bar) Temperature Range: 40–100°F (4.4–38°C) Rated Service Flow: 0.5 gpm @ 60 psi (1.9 Lpm @ 4.1 bar) Filter Capacity: CT-2: 400 gal. (1514 L)* *Filter cartridge life varies depending on usage and water conditions. Estimated filter l

It is recommended that, before installing a water treatment system, you have your water supply tested to determine your actual water treatment needs. This system has been tested according to NSF/ANSI 42 and 53 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42/53. Model FM-15 Substance Influe

For installations in Massachusetts, Massachusetts Plumbing Code 248 CMR shall be adhered to. Consult your licensed plumber for installation of this system. The use of piercing valves is not permitted in Massachusetts. Check with your public works department for applicable local plumbing and sanitation codes. Follow your local codes if they differ from the standards used in this manual. Operational, maintenance and replacement requirements are essential for this product to perform properly. The G

This simple test can be done quickly by your dealer. The Good Water SentryTM Water Quality Monitor is another way to keep track of your system’s performance. This optional accessory checks your drinking water each time you use the special faucet, and signals when the membrane filter may need to be replaced. If the water quality of your system seems to have declined, drain the storage tank and allow the system to refill. If the problem persists, call your Culligan Man for service. INSTALLATION Th

• Single, Duplex, Triplex, or Quad Configurations • Regeneration initiation by choice of time clock, meter or differential pressure switch. • Carbon Filters – For reduction of organics (flow rates up to 39gpm), or chlorine (flow rates up to 77gpm). • Depth Filters – Flow rates up to 193gpm. • Top-Mounted Control Valve – Keeps plumbing connections simple and adaptable. Full flow porting with rounded orifices and wide-open cartridges promote good flow characteristics and low pressure fluctuations.

Service is available through independently operated Culligan dealerships. Commercial Systems ©2000 Culligan 1-800-CULLIGAN Printed in USA Rev. 4/00 DCO 992587 SL-0071 Softeners • Hi-Flo® 2E • CSM • Hi-Flo® 55E • Hi-Flo® 50 Filters • Hi-Flo® 2E • Hi-Flo® 42 • CSM • Hi-Flo® 55E • Hi-Flo® 50 Trust The Water Experts® (More on next page) More Introducing the Culligan® MVP Electronic Controller Multifunctional M V P Versatile Programmable Sequences the regeneration process of water softeners or filtra