Assessments - 0, GPA: 0
(
)
)
|
por este dispositivo também tem outras instruções :
Facilidade de uso
Sound effect This product supports the sound output by EQ and P.BASS. Compatible iPod/iPhone models The product supports the following iPod and iPhone models. • iPod touch (1st, 2nd, 3rd, and 4th generation) •iPod classic • iPod nano (3rd, 4th, 5th, and 6th generation) •iPhone 4 • iPhone 3GS • iPhone 3G • iPhone 4S Some of the functions may be restricted for some models. • This product has been developed and tested for the software version of iPod/iPhone indicated on the website of Pioneer. (• Installing software versions other than the ones indicated on the website of Pioneer to your iPod/iPhone may result in incompatibility with this product. What’s in the box Check and identify the contents of your package: • Micro music system • Remote control • Video cables (yellow connectors) •AC power cord • Warranty Card • Operating Instructions (this document) Battery installation of the remote control • Remove the insulation insert before the first time use. Open Replacing the battery (CR2025, 3 V) 1 Open the battery drawer indirection. 2 Gently press the edge of the battery (the dotted section on the diagram below) and remove the battery. English En Before you start 01 Before you start 01 Turn the battery case upside-down, set the new battery with the . side facing down, insert it diagonally then gently press it down. Close the battery drawer indirection. Close WARNING • Do not pull the battery in the direction shown on the diagram below. Doing so may damage the battery case. • Do not use or store batteries in direct sunlight or other excessively hot place, such as inside a car or near a heater. This can cause batteries to leak, overheat, explode or catch fire. It can also reduce the life or performance of batteries. CAUTION • Do not use any batteries other than the ones specified. • When loading the batteries into the remote control, set them in the proper direction, as indicated by the polarity marks (. and .). • Do not heat batteries, disassemble them, or throw them into flames or water. • Batteries may have different voltages, even if they look similar. • To prevent leakage of battery fluid, remove the batteries if you do not plan to use the remote control for a long period of time (1 month or more). If the fluid should leak, wipe it carefully off the inside of the case, then insert new batteries. If a battery should leak and the fluid should get on your skin, flush it off with large quantities of water. • When disposing of used batteries, please comply with governmental regulations or environmental public institution’s rules that apply in your country/area. •Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. • Dispose of used battery cells immediately after replacement. Keep away from children. • If swallowed, please contact a doctor immediately. • Lithium batteries may present a fire or chemical burn hazard if misused. Do not disassemble, heat above 100 °C, or incinerate. En Part names and functions 02 Part names and functions 02 Chapter 2: Part names and functions English Overview of the main unit 11 17 12 13 14 15 16 1 2 9 3 4 5 6 7 8 10 1 Dock for iPod/iPhone • Connect to the iPod/iPhone. 2 .STANDBY/ON • Switch between standby and on. 3 STANDBY indicator • Red lights up during standby. 4 INPUT • Press repeatedly to select the input source. 5 . • Use to play, pause, or resume playback. • In the standby mode, press and hold to switch between APS on and off. 6 .. • Skip to the previous track. • Press and hold to play reverse quickly within a track. • Tune to the previous radio station. • Press and hold to search the previous radio station automatically. 7 AUX IN • Connect to the audio output socket (usually the headphones socket) of an external device. 8 PHONES • Connect to headphones with a 3.5 mm connector. En Part names and functions 02 Part names and functions 02 Remote control sensor • Point the remote control to this, and then operate it within approximately 7 m. The product may have trouble capturing remote control signals if there is a fluorescent light nearby. If this happens, move the product away from the fluorescent light. 10 . • Open or close the disc tray. 11 Main display 12 Disc tray • Place the disc with the label side up. 13 P.BASS • Switch P.BASS between on and off. 14 . •Use to stop playback. • In standby mode, press and hold to enable or disable the feature demonstration. 15 .. • Skip to the next track. • Press and hold to play forward quickly within a track. • Tune to the next radio station. • Press and hold to search the next radio station automatically. 16 • Connect to a USB storage device. 17 VOLUME • Rotate to increase or decrease the volume level. Overview of the remote control 16 19 21 24 1 2 4 3 8 9 15 5 13 14 17 10 11 12 20 22 25 26 27 28 23 6 7 6 18 7 1 .STANDBY/ON • Switch between standby and on. 2 Input function buttons • Use to select the input source...