Assessments - 2, GPA: 3.5
(
)
)
|
Facilidade de uso
have to be plugged into an electrical out- Contact with a “live” wire will also make let. exposed metal parts of the tool “live” and 3. Always be sure you have a firm footing. shock the operator. 4. Be sure no one is below when using the tool in high locations. 5. Hold the tool firmly. 6. Keep hands away from rotating parts. 7. Do not leave the tool running. Operate the tool only when hand-held. 8. Do not touch the drill bit or the workpiece immediately after operation; they may be extremely hot and could burn your skin. 9. Some material contains chemicals which may be toxic. Take caution to prevent working dust inhalation and skin contact. Follow material supplier safety data. SAVE THESE INSTRUCTIONS WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. SYMBOLS USD301-1 The followings show the symbols used for tool. V .......................volts n....................no load speed ° ................... direct current .../min................revolutions or reciprocation per minute IMPORTANT SAFETY INSTRUCTIONS FOR CHARGER & BATTERY CARTRIDGE USC001-3 1. SAVE THESE INSTRUCTIONS - This man-3. CAUTION - To reduce risk of injury, charge ual contains important safety and operat-only MAKITA rechargeable batteries ing instructions for battery charger. marked on the charger label. Other types of batteries may burst causing personal 2. Before using battery charger, read all injury and damage. instructions and cautionary markings on (1) battery charger, (2) battery, and (3) 4. Do not expose charger to rain or snow. product using battery. 5. Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock, or injury to persons. 6. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting charger. 7. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress. 8. An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock. If extension cord must be used, make sure: a. That pins on plug of extension cord are the same number, size, and shape as those of plug on charger; b. That extension cord is properly wired and in good electrical condition; c. That wire size is at least as large as the one specified in the table below. Table 1: RECOMMENDED MINIMUM AWG SIZE FOR EXTENSION CORDS FOR BATTERY CHARGERS Length of Cord (Feet) 25 50 100 150 AWG Size of Cord 18 18 18 16 9. Do not operate charger with damaged cord or plug - replace them immediately. 10. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman. 11. Do not disassemble charger or battery cartridge; take it to a qualified serviceman when service or repair is required, Incorrect reassembly may result in a risk of electric shock or fire. 12. To reduce risk of electric shock, unplug charger from outlet before attempting any maintenance or cleaning. Turning off controls will not reduce this risk. 13. The battery charger is not intended for use by young children or infirm persons without supervision. 14. Young children should be supervised to ensure that they do not play with the battery charger. 15. If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion. 16. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. It may result in loss of your eyesight. ADDITIONAL SAFETY RULES FOR CHARGER & BATTERY CARTRIDGE 1. Do not charge Battery Cartridge when 2. Do not attempt to use a step-up trans- temperature is BELOW 10°C (50°F) or former, an engine generator or DC power ABOVE 40°C (104°F). receptacle. 3. Do not allow anything to cover or clog the A battery short can cause a large current charger vents. flow, overheating, possible burns and even a breakdown. 4. Always cover the battery terminals with the battery cover when the battery car-6. Do not store the tool and Battery Cartridge is not used. tridge in locations where the temperature may reach or exceed 50°C (122°F). 5. Do not short the battery cartridge: 7. Do not incinerate the Battery Cartridge (1) Do not touch the terminals with any even if it is severely damaged or is com conductive material. pletely worn out. The battery cartridge can (2) Avoid storing battery cartridge in a explode in a fire. container with other metal objects 8. Be careful not to drop, shake or strike bat- such as nails, coins, etc. tery. (3) Do not expose battery cartridge to 9. Do not charge inside a box or container of water or rain. any kind. The battery must be placed in a well ventilated area during charging. SAVE THESE INSTRUCTIONS FUNCTIONAL CAUTION: DESCRIPTION • Always be sure that the tool is switched...
Este manual também é adequado para os modelos :Brocas e shuropopverty - 6217D (167.17 kb)
Brocas e shuropopverty - 6237D (167.17 kb)
Brocas e shuropopverty - 6317D (167.17 kb)
Brocas e shuropopverty - 6347D (167.17 kb)