Assessments - 4, GPA: 4.3
(
)
)
|
Facilidade de uso
Hold the spindle with a wrench (Fig. 1). 4. Insert the drill chuck key inside chuck and loosen clockwise by tapping lightly with a rubber hammer. NOTE: To mount the chuck, reverse the instructions above. Installing Bits into Keyed Chucks (Fig. 2) Be sure that the shank of the bit and the chuck jaws are clean. Dirt particles may cause the bit to line up improperly. Do not use bits larger than the maximum recommended capacity of the drill because gear damage or motor overloading may result. For best performance, be sure that the bits are properly sharpened before use. Fig. 2 Loosen Tighten 1. Unplug the tool. 2. Open the chuck jaws wide enough to insert a bit. Allow the bit to strike the bottom of the chuck. Center the bit in the chuck jaws and tighten the jaws by hand to align the bit. 3. Place the chuck key into each of the three holes in the chuck, turning it clockwise to tighten the chuck securely. NOTE: Never use a wrench or means other than a chuck key to tighten or loosen the chuck. 4. To remove the bit, insert the chuck key into one of the holes in the chuck and turn it counterclockwise. Adjusting the Side Handle Position (Fig. 3) WARNING To reduce the risk of injury, always use a side handle when using thistool. Always brace or hold securely. Fig. 3 Side handle grip 1. Loosen the side handle by unscrewing the side handle grip until the side handle rotates freely. 2. Rotate the side handle to the desired position. 3. Tighten the side handle grip securely. Setting the Depth Gauge (Fig. 4) Fig. 4 Drilling Depth 1. Press in the clamping lever. 2. Slide the depth gauge rod backward or forward until it is set for the desired depth. NOTE: The drilling depth is the distance between the tip of the bit and the tip of the depth gauge rod. 3. Release the clamping lever. Fig. 1 WARNING To prevent personal injury, always remove the chuck thechuck after each 6 7 OPERATION WARNING To reduce the risk of injury, wear safety goggles or glasses with sideshields. Unplug the tool beforechanging accessories or makingadjustments. Selecting Action (Fig. 5) MILWAUKEE Hammer-Drills have two settings: drilling and hammer-drilling. Selector LeverFig. 5 1. For drilling, turn the hammer-drill lever towards the drill symbol . 2. For hammer-drilling, turn the hammer-drill lever towards the hammer symbol . NOTE: To engage the hammering mechanism, maintain pressure on the bit. When pressure on the bit is released, the hammering action will stop. Using Forward/Reverse Lever (Fig. 6) The forward/reverse lever can only be adjusted when the trigger is not pressed. Always allow the motor to come to a complete stop before using the forward/reverse lever. Fig. 6 Forward Reverse 1. For forward (clockwise) rotation, push the forward/reverse lever to the left (when viewed from the back of the tool) as shown. 2. For reverse (counterclockwise) rotation, push the forward/reverse lever to the right (when viewed from the back of the tool) as shown. Allow the motor to come to a full stop b...
Este manual também é adequado para os modelos :Brocas e shuropopverty - 5378-20 (1.38 mb)
Brocas e shuropopverty - 5378-20 (1.38 mb)
Brocas e shuropopverty - 5378-21 (1.38 mb)
Brocas e shuropopverty - 5378-20 (1.38 mb)