Assessments - 4, GPA: 4.3
(
)
)
|
Facilidade de uso
Recommended Minimum AWG Size for Extension Cords Total Extension Cord Length (feet) 25 50 75 100 125 150 175 Wire Gauge 18 18 16 16 14 14 12 •The charger is ventilated through slots in the top and the bottom of the housing. Do not place any object on top of charger or place the charger on a soft surface that might block the ventilation slots and result in excessive internal heat. Place the charger in a position away from any heat source. •Do not operate charger with damaged cord or plug — have them replaced immediately. • Do not operate charger been dropped, or otherwise service center. •Do not disassemble charger; when service or repair is required. in a risk of electric shock, electrocution •To reduce risk of electric shock, unplug attempting any cleaning. Removing this risk. • NEVER attempt to connect 2 chargers together. • DO NOT store or use the tool and battery pack in locations the temperature may reach or exceed 105°F (sheds or metal buildings in summer). • The charger is designed to operate on standard electrical (120 volts). Do not attempt to use it on any other voltage! • WARNING: Don’t allow any liquid to get inside charger. Electric shock may result. To facilitate the cooling of the battery pack after use, avoid placing the charger or battery pack in a warm environment such as in a metal shed, or an uninsulated trailer. • CAUTION: Never attempt to open the battery pack for any reason. If the plastic housing of the battery pack breaks or cracks, return to a service center for recycling. SAVE THESE INSTRUCTIONS Important Safety Instructions for Battery Packs THE BATTERY PACK IS NOT FULLY CHARGED OUT OF THE CARTON! READ THE SAFETY INSTRUCTIONS BELOW AND FOLLOW CHARGING NOTES AND PROCEDURES. READ ALL INSTRUCTIONS • Do not incinerate the battery pack even if it is severely damaged or is completely worn out. The battery pack can explode in a fire. 2 DW900,5/8/2:59 Page 3 English • A small leakage of under extreme usage indicate a failure. However, if the outer seal is broken leakage gets on your skin: a. Wash quickly with soap and water. b. Neutralize with a mild acid such c. If battery liquid gets into your eyes, for a minimum of 10 minutes and seek attention. (MEDICAL NOTE: The liquid is 25-35% solution of potassium hydroxide.) • Never attempt to open the battery pack for housing of the battery pack breaks or cracks, discontinue use and do not recharge. • Do not carry extra battery packs in aprons, pockets, along with other metal objects. Battery pack could be causing damage to the battery pack and possibly causing burns or fire. • Charge the battery packs only in DEWALT chargers. NOTE: The batteries in your battery pack are the nickel-cadmium type. Cadmium is considered to be a toxic material by the Environmental Protection Agency. Before disposing of damaged or worn out nickel-cadmium battery packs, check with your state Environmental Protection Agency to find out about special restrictions on the disposal of these battery packs or return them to a DEWALT certified service center for recycling. NOTE: Battery storage and carrying caps are provided for use whenever the battery is out of the tool or charger. Remove cap before placing battery in charger or tool. WARNING: Do not store or carry battery so that metal objects can contact exposed battery terminals. For example, do not place battery in aprons, pockets, tool boxes, product kit boxes, drawers, etc. with loose nails, screws, keys, etc. without battery cap. Without cap in place, battery could short circuit causing fire or burns or damage to battery. Product Specifications TOOL DW900 DW901 RPM: 850 1400 Dimensions: 8-3/4" x 8-3/4" 8-3/4" x 8-3/4" Weight: (Tool Only) 2.6 lbs. 2.6 lbs. Weight: (With Battery) 3.8 lbs. 3.8 lbs. BATTERY PACKS DW9072 12.0V 4/5 Cell, Standard Capacity....................1.2 lbs DW9074 12.0V 4/5 Cell, Standard Capacity with State of Charge Indicator..........................................1.3 lbs DW9070 12.0V High Capacity XR™ Pack ......................1.4 lbs Operation REMOVING AND INSTALLING THE BATTERY PACK To install the battery pack, align the base of the battery with the inside the tool’s handle and slide the battery firmly into the handle. The battery will snap into place. To remove the battery pack, press the release buttons and firmly pull the battery pack of the tool handle. QUICK RELEASE CHUCK NOTE: The chuck accepts 1/4" hex accessories only. To install an accessory, pull the chuck collar toward the front of the tool, insert the accessory, and release the collar (Figure 1) . The accessory will lock into place. To remove an accessory, pull the chuck collar toward the front of the tool. Remove the accessory and release the collar. FORWARD/REVERSE BAR For forward operation, push the bar from right to left. For reverse operation, push the bar FIG. 1 3 DW900,5/8/2:59 Page 4 English from left to right. the tool. Be sure to release the FIG. 2 forward/reverse bar. SWITCH To turn the tool on, squeeze the its set t...
Este manual também é adequado para os modelos :Brocas e shuropopverty - DW900 (278.45 kb)
Brocas e shuropopverty - DW901 (278.45 kb)