Assessments - 4, GPA: 4.5
(
)
)
|
Facilidade de uso
Hold the tool only by insulated grasping surfaces to prevent electric shock if you drill or drive into a live wire. English 1 GRB/386312-02 8/11/00 1:56 PM Page 2 English WARNING: Some dust created by power sanding, FIG. 1 BIT drilling, and other construction activities cause cancer, birth defects or other reproductive harm. examples of these chemicals are: • lead from lead-based paints, • crystalline silica from bricks and cement and other products, and • arsenic and chromium from chemically-treated lumber (Your risk from these exposures varies, depending on how often this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, as those dust masks that are specially designed to filter out microscopic particles. The label on your tool may include the following symbols. V ....................................volts A ....................................amperes Hz ..................................hertz W ....................................watts min ..................................minutes ..................................alternating current ................................direct current no....................................no load speed COLLAR TIP CLUTCH HOUSING SPRINGS .................................... Class II Construction …/min ..............................revolutions or reciprocation per minute .................................... earthing terminal FIG. 4 ADJUSTING COLLAR ....................................safety alert symbol NUTSETTER Switch To start tool, depress the trigger switch, shown in Figure 1. To stop tool, release the switch. The variable speed trigger switch permits speed control. The farther the trigger switch is depressed, the higher the speed of the tool. FIG. 2 BALL GROOVE 1/4" HEX DRIVE BALL RETAINER REVERSING LEVER TRIGGER SWITCH LOCKING BUTTON FIG. 3 DEPTH LOCATOR ADJUSTMENT BIT TIP HOLDER RETAINING BIT LOCATOR CLUTCH HOUSING NUTSETTER 2 GRB/386312-02 8/11/00 1:56 PM Page 3 To lock the switch in the on position for the trigger switch and push up the locking button. The tool will continue to run. To turn the tool off, from a locked on condition, squeeze and release the trigger once. Before time), be sure that the locking button release freely. Be sure to release the locking mechanism before the plug from the power supply. Failure to do so will cause the tool to start immediately the next time it is plugged in. Damage result.The reversing lever is used to reverse the tool for backing out screws. It is located above the trigger, shown in Figure 1. To reverse the screwdriver, turn it off and push the reversing lever to the right (when viewed from the back of the tool). To position the lever for forward operation, turn the tool off and push the lever to the left. Dead Spindle Action All GRABBER screwdrivers provide a dead output spindle to permit fasteners to be located easily in the driving accessory. Clutches are held apart by light spring pressure permitting the dri...
Este manual também é adequado para os modelos :Brocas e shuropopverty - Scrudrivers 386312-02 (149.25 kb)
Brocas e shuropopverty - Scrudrivers 4060 (149.25 kb)
Brocas e shuropopverty - Scrudrivers 4063 (149.25 kb)
Brocas e shuropopverty - Scrudrivers 4063SD (149.25 kb)