Assessments - 0, GPA: 0
(
)
)
|
por este dispositivo também tem outras instruções :
Facilidade de uso
Do not use a glass scraper. Oven carriage base Hot water with a little soap or water and vinegar: Clean with a dishcloth. Glass cover for the oven Hot water and a little soap: light Clean with a dishcloth. Seal (do not remove) Hot water and a little soap: Clean with a dishcloth. Do not rub. Accessories Hot water and a little soap: Soak and clean using a dishcloth or brush. Cleaning the self cleaning surfaces in the oven interior The inside rear and side walls and ceiling of some ovens may comprise a highly porous ceramic lining. This lining absorbs splashes produced during baking and roasting, dissolving them while the oven is on. This cleaning will be most effective at higher temperatures and during longer cooking times. Slight discolouration of the lining does not affect its self- cleaning performance. Caution! ¦ Do not use abrasive cleaning products. These would scratch and impair the highly porous lining. ¦ Never use oven cleaning products on ceramics. If oven cleaner is spilled on this accidentally, immediately remove it using lots of water and a sponge. Cleaning the oven's enamelled bottom and walls Use a cleaning cloth and hot water with a little soap or vinegar. If very dirty, use a fine steel scourer or a special oven cleaning product. These must only be used when the oven interior is cold. Do not use metal scourers or special oven cleaning products on self-cleaning surfaces. Aqualisis The appliance is equipped with the Aqualisis cleaning aid to facilitate cleaning the inside of the oven. The controlled spraying of detergent softens the dirt making it easier to remove. In case of stubborn dirt: ¦ Allow the detergent to act for some time before activating the cleaning aid. ¦ Rub the dirty areas with a cleaning product before activating the cleaning aid. ¦ Repeat the Aqualisis operating mode once the oven interior has cooled down. Preparation and connection The Aqualisis cleaning system should only be started when the oven interior is cold. : Danger of burns and damage to the surface! Do not pour water into a hot oven. This produces steam and can damage the enamel due to the change in temperature. 1. Remove the accessories from inside the oven. 2. Carefully pour 250 ml water (non- distilled) with a little washing up liquid on the bottom of the oven interior (Figure A) . 3. Close the oven door. 4. Set the Aqualisis OE function to 270 . C. 5. Press the 0 button twice and a set a time of 4 minutes. The cleaning system is activated. 6. After 4 minutes, a beep sounds and the oven stops heating. Set the function control knob to the zero setting. 7. Wait for approximately 17 minutes for the oven interior to cool down. Cleaning up and switching off Do not leave traces of water inside the oven for a long time (e.g. overnight) . 1. Open the oven door and mop up the water using the sponge supplied ( depending on the model) or an absorbent dishcloth (Figure B). If your oven does not have this sponge, it can be purchased from the Technical Assistance Service or over the Internet by quoting part number 659774. 2. Clean the oven interior with products that will not damage the enamel: a dishcloth, soft brush, plastic scouring pad or with the sponge supplied. Note: Stubborn dirt can be removed using a glass scraper. 3. Remove limescale with a cloth soaked in vinegar, then wipe using another cloth with clean water and dry using a soft cloth. Also clean under the door seal. 4. After cleaning, leave the oven door open for 1 hour in the locked position (approx. 30° ) so that the enamel surfaces inside the oven can dry. Rapid drying 1. After cleaning, leave the oven door open in the locked position ( approx. 30°) . 2. Set the hot air function " to 50 ° C. 3. After 5 minutes, switch off the oven and close the door. Light The oven light can be turned on manually to facilitate cleaning. Connecting the oven light Turn the function control knob to the N setting. The light will come on. The temperature control knob must be turned off. Turning the oven light off Turn the function control knob to the Uposition. Removing the oven carriage The oven carriage can be easily removed to make cleaning the oven easier. Pull out the oven carriage its full limit. Hold the carriage on both sides, lift it slightly and remove it. Place it carefully on a flat surface. The base of the oven contains delicate components. After cleaning, the oven door can be refitted by repeating the procedure in reverse. Fitting and removing the glass panels To make cleaning easier, the glass from the oven carriage can be removed. Dismantling 1. Removing the oven carriage. 2. Remove the top cover of the oven carriage. To do this, unscrew the right and left-hand side screws (figure A) . 3. Hold the glass in your hands ( left and right) and remove upwards ( figure B) . Place these on a cloth with the handle facing downwards. The inside glass with the hooks should not be removed from the oven carriage. . . In doors with three glass panels, the following step will al...
Este manual também é adequado para os modelos :Fornos - 3HB516XM/01 (437.74 kb)