Log:
Assessments - 1, GPA: 5 ( )

Instruções de Operação Hitachi, Modelo GD-2000

Fabricante : Hitachi
Arquivo Tamanho: 135.89 kb
Arquivo Nome : 00b3274b-0f7e-b7f4-81a2-fd2d22e2319f.pdf
Língua de Ensino: en
Ir para baixar



Facilidade de uso


4) Install the DVD-ROM drive into the host computer and mount tightly with screws. 5) Check the settings of the interface card. 6) Install the interface card in the slot. 7) Firmly attach the interface cable from the interface card to the DVD-ROM drive. 8) Firmly attach audio connecting cable as required. 9) Finally, firmly attach a spare DC power supply cable from the computer power supply to the DVD-ROM drive. 10) Install the host computer cover. GD-2000 DVD-ROM Manual -Page GD-2000 Manual 6/18/98 5:25 PM Page 11 Power supply cable Interface cableAudio connecting cable Software Installation To install DVD-ROM device driver in the host computer to operate this DVD-ROM drive, refer to the instruction manual of each DVD-ROM device driver. Drive Operation 1) Turn on the SYSTEM, including the DVD-ROM drive. 2) Press the OPEN/CLOSE button of the DVD-ROM drive to open the disc tray. 3) Place the disc in the center of the disc tray, label side up as shown on the following page. 4) To close the disc tray, press the OPEN/CLOSE button on the DVD-ROM drive or push lightly on the center of the front of the disc tray as shown below. The disc tray will automatically close the rest of the way. 5) Operate referring to the instruction manual of DVD-ROM device driver. GD-2000 DVD-ROM Manual -Page GD-2000 Manual 6/18/98 5:26 PM Page 12 120 mm Disc Label side Disc tray Push IMPORTANT: • Do not press the OPEN/CLOSE button while the host computer is accessing the disc. It may cause an error. • When not using the DVD-ROM drive, keep the disc tray closed. It will prevent the entry of dust and dirt, and reduce the requirements for disc and lens cleaning. CAUTION: If you do not observe the following items, you may have problems opening and/or closing the disc tray, and damage may be caused to the mechanism of the DVD-ROM drive. • Never use a damaged, broken or deformed disc. • Do not press down hard on the disc tray when opening and closing it. Emergency Eject Procedure Only in case of emergency: If the disc tray does not open when the OPEN/CLOSE button is pressed, make sure that the power of the DVD-ROM drive is turned on and that the lock function has not been activated. If the disc tray still will not open, the DVD-ROM drive’s Manual Emergency Eject Mechanism may still be activated. This should be used only in case of an emergency. GD-2000 DVD-ROM Manual -Page 12 GD-2000 Manual 6/18/98 5:26 PM Page 13 Removal Procedure 1. Turn off the DVD-ROM drive and wait at least 15 seconds until the disc stops rotating. 2. Insert the Eject Bar (for example, a straightened paper clip) into the Manual Emergency Eject Hole about 25 mm (1 inch). 3. Pull the disc tray. NOTE: If it is necessary to use the emergency eject procedure to open the drive, the tray should be closed by turning on the power and pressing the OPEN/CLOSE button. Transporting the drive before it has been properly closed may cause damage to the mechanism. Lens Cleaning A commercially available “Laser Lens Cleaning Disc” may be used to clean up the pick-up lens of the DVD-ROM drive. Use the Compact Disc Laser Lens Cleaner LLC-1. (by AUDIO SOURCE in U.S.A., by AKUSTIK SISTEME VERTRIEBS GHBH in GERMANY and by SAEC COMMERCE CO., LTD. in JAPAN.) 1) Turn on the DVD-ROM drive. 2) Using the small brush supplied with the cleaning disc case, straighten up the disc cleaning brushes on the back of the cleaning disc. 3) Place the cleaning disc in the disc tray with its arrow marked on the disc at front. 4) Press the OPEN/CLOSE button or push the center of the disc tray lightly and close the disc tray. 5) After about 20 seconds, the pick-up lens is cleaned by the cleaning disc. 6) Press the OPEN/CLOSE button and remove the cleaning disc. 7) Set the cleaning disc in its case with the disc cleaning brushes in the pad hole. 8) Restart the SYSTEM. GD 2000 DVD ROM Manual Page GD-2000 Manual 6/18/98 5:26 PM Page 14 Trouble Shooting • If your DVD-ROM drive does not operate properly, check the following table. • You may have to check the other devices included in your SYSTEM. • If you cannot locate the cause, turn off the power of the SYSTEM, including the DVD-ROM drive, immediately unplug the power supply cable of the SYSTEM from the wall outlet, and contact your dealer. • When calling for service, provide the following information: 1. Model name 2. Detailed symptoms Symptoms Possible causes Remedy The DVD-ROM 1. You place the 1. Place the disc Drive does not disc upside down right side up in the operate even when in the Disc Tray. Disc Tray, then load a disc is loaded. 2. The disc is dirty. 3. The pick-up lens is dirty. 4. The disc is scratched or warped. 5. Cable connection is incorrect. 6. The program is incorrect. It is it. 2. Clean the disc surface. 3. Clean up the pick-up lens. (see page 13) 4. Change the disc. 5. Turn off your SYSTEM and reconnect cables correctly. The Disc Tray cannot be opened. Communications between the host computer and the devices on the interface cable are not successf...


Escreva a sua própria avaliação do dispositivo



Mensagem
Seu nome :
Introduza os dois dígitos :
capcha





categorias