Assessments - 1, GPA: 4 ( )

Fabricante : Lennox Hearth Arquivo Tamanho: 57.33 kb Arquivo Nome : Língua de Ensino:

Back these screws out about an 1/8 of an inch. Step 3. Position the Estate 48 attachment bracket within the fireplace opening with their black faces forward and their slots engaged around the screws backed out in the previous step. Snug up two (2) screws on each side, DO NOT TIGHTEN. The attachment brackets must be allowed to move in the following step. Step 4. Remove the Phillips screw from the Tinnerman nuts in the door frame assembly. Position the frame within the opening and align the Tinnerman nuts with the four round holes of the attachment brackets, two (2) on each side. Secure the frame to the brackets with the four (4) screws, DO NOT TIGHTEN. Step 5. Center the door frame within the opening, left to right and push door frame up to the top of the opening as far as it will go. Carefully tighten all screws, making sure they are not overtightened. Do Not obstruct the gaps to the left and right of the frame. These spaces are designed for inlet air to enter the fire box. Installing the Doors Install all doors as follows: Fold panes of right door back to back with handle down as shown in Figure 3. Tilt door so that it fits inside frame as shown. Next, insert Bottom Pin into Bottom Retainer Slot. Then tilt top of door toward vertical position making sure that all Pins and Door Guides are inside Track. Finally, slide Top Pin along Top Retainer Clip until Top Pin snaps into Top Retainer Slot. Repeat procedure for left door. Top (Narrow) Door Guide (Wide) Door Guide Retainer Clip Bottom BottomRetainer Handle Clip Pin Figure 3 Figure 2 NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE ADJUSTMENT FOR DOOR ALIGNMENT ADJUSTMENT FOR DOOR ALIGNMENT If doors appear to close in correct position but do not latch (both doors do not stay closed), then there is a misalignment between the doors and the Center Wedge Clip. The Center Wedge Clip is located in the center of the bottom Track. In order to stay closed, the left and right doors must meet in the Middle of the Center Wedge Clip. To adjust doors, first loosen, but DO NOT remove the Phillips Screw that holds the Retainer Clip to the frame. Move door to desired position then tighten screw. Repeat procedure for other Retainer Clips as needed. Operate doors to check alignment and repeat procedure if necessary. GENERAL OPERATING PRECAUTIONS AND INSTRUCTIONS CAUTION: THESE GLASS DOORS ARE LISTED ONLY FOR USE WITH THE LENNOX FIREPLACE OR APPLIANCE MODELS SHOWN. USE ON ANY OTHER FIREPLACE OR APPLIANCE MAY CONSTITUTE A POTENTIAL FIRE HAZARD. • Avoid building extremely large fires as the tempered glass could become damaged. • Use fireplace tools carefully to avoid striking the glass. • Keep wire mesh screens closed during fireplace use. • The fireplace flue damper must remain open until fire is completely out. • Assure wood and embers are well within the confines of the grate area and well away from the glass doors. • Keep wire mesh screens closed during fireplace use. • Keep glass doors closed at night when retiring to ...

Baixe o seu

Para fazer o download, introduza 2 dígitos :