Assessments - 4, GPA: 4
(
)
)
|
Facilidade de uso
Determine pivot location using dimensions on reverse side. Be sure to properly locate base plate. The finish plate of pivot base assembly should be removed until installation is complete. 2. Prepare bottom of door. If bottom of door has not been prepared prior to pivot installation, mortise per dimensions on reverse side. The bottom of the door must have a removable heel section (Figure 1). 3. Remove pivot clamp from door pivot leaf with 5/16” Allen wrench. Locate, drill, and tap mounting holes for door leaf. Mount door leaf in bottom of door with screws provided. 4. Locate and prepare cutout in floor for pivot base. The pivot base assembly must be located so that the center line of top pivot point is plumb with center line of base pivot point. Secure pivot base: A. Prepare compound that will be used to fill around pivot base (concrete, cement, grout, etc.). B. Fill cutout with compound, leaving room for concrete channel base to fit flush with floor. C. Set pivot base into cutout. Align base assembly so pivot point is in proper position. D. Use a level to be sure pivot base assembly is level on all sides. E. Secure in proper position until compound sets up completely. Once compound has set up, mounting screws can be removed, allowing removal or replacement of pivot base assembly. F. Re-attach finish plate. 5. Maneuver door into position, about 90° to frame. Position door so door pivot leaf mates with pivot pin as shown in Figure 2. Re-attach pivot clamp as shown in Figure 3. Do not tighten clamp screws completely. Engage pivot leafs at top of door. Now tighten clamp screws securely. 6. If height adjustment is necessary for proper clearance, use shims between door bottom and pivot leaf to increase clearance. To decrease clearance, mortise in door must be made deeper. A CAUTION Improper pivot set installation can lead to personal injury or property damage. Follow all instructions carefully. For questions contact Technical Support at 1-888-371-7331. C"»7 Ingersoll Rand 26633 Rev. 4 © 2006 Ingersoll-Rand Company Limited Security Technologies NOTE It is very important for installer to verify that center line of top pivot point lines up with center line of bottom pivot point before final installation. * Pivot center may be varied as needed; standard distance is 2-3/4” as shown. Removable door section to allow access to pivot leaf bracket screws $ Radius of heel edge of door must not exceed pivot point to jamb distance 1-5/8” —, 41 mm pivot 1-7/8” to 2-5/16”—, 48 mm 59 mm i o 1/16” ^ 3/8” 2 mm 10 mm C pivot and door 13/16” 21 mm <§> Top View 5-1/16”, 129 mm**- 5-1/8”, 130 mm — —2-1/2” 64 mm Dimensions for cement case cutout. Depth is 3/8” without threshold, 5/16” with threshold. L5”, 127 mm — 4-13/16”, 122 mm** X m X X m X End View without Threshold End View with Threshold 26633-00 26633 Rev. 4 26633-00...