Assessments - 2, GPA: 3
(
)
)
|
por este dispositivo também tem outras instruções :
Facilidade de uso
If (camera when lighting is poor. (off) shake) icon appears, care should be taken to avoid blurring. Flash fires whenever Use to “fill-in” (illuminate) shad- Anytime Flash picture is taken. ows and back-lit subjects. (fill flash) Use to capture both subject and Auto flash combined background at night or under with slow shutter dim light. If (camera shake) Slow sync speeds. icon appears, care should be taken to avoid blurring. Flash Range Flash range varies with zoom position. When the camera is zoomed all the way out, the flash has a range of approx. 0.3 - 4.5 m (1' - 14'8"). When the camera is zoomed all the way in, the flash has a range of approx. 0.3 - 3.5 m (1' - 11'5") with Auto in Sensitivity. Close-Ups The flash may not be able to light the entire subject at distances of less than 30 cm (1'). When taking close-ups, play each picture back after shooting to check the results. 42 To select the flash mode: Display flash-mode menu. Highlight desired mode and press or . Flash mode is displayed in monitor (to exit without changing mode, wait two seconds without pressing any buttons). Selecting Flash Mode While Using Manual Option When AF area mode ( 91) is set to Manual ( 93) and focus area selection guide is displayed in the monitor, press to hide focus area selection guide and press ( ) to select the flash mode. The (Camera Shake) Icon When lighting is poor and the flash is off ( ), shutter speeds will slow and pictures may be blurred. If the shutter speed required for exposure is very slow, a (camera shake) warning will appear in the monitor. Use of a tripod or support is recommended. More on Photography Flash Mode Selection Flash mode is not available in the following cases: • Continuous is set to Continuous, 5 shot buffer or Multi-shot 16. • BSS is set to On. • Auto bracketing is set to On. • Taking a picture in some assist modes ( 28 - 33) or scene modes ( 34 - 39). Auto with Red-eye Reduction The “Auto with red-eye reduction” flash function of the COOLPIX5200 uses an advanced red-eye reduction method. Several pre-flashes are fired before the main flash fires to reduce “red-eye.” In addition to this function, if “red-eye” is detected the camera will automatically correct it when storing the picture. Using this function there is slight delay before you can press the shutter release again for the next shot. Depending on the situation, red-eye reduction may not always produce the desired results. In some rare cases, other picture areas may be affected as well as the “red-eye” area. In this case, choose another flash mode and try again. 43 Taking a Self-Portrait: Using the Self-Timer Taking a Self-Portrait: Using the Self-Timer When the self-timer is on, pictures are taken ten or three seconds after the shutter-release button is pressed. This can be used to allow you to appear in your own pictures or to prevent close-up or low-light shots from being blurred by the camera movement that occurs when the shutter-release button is pressed. When using the self-timer, you should either mount the camera on a tripod (recommended) or rest it on a flat, level surface. More on Photography Display self-timer menu. Highlight ON. Exit menu. Self-timer icon is displayed in monitor (to exit without setting the self- timer, wait two seconds without pressing any buttons). Frame picture and press shutter-release button halfway to set focus and exposure. Start timer. Press once for delay of about ten seconds, twice for delay of about three seconds. • Countdown timer in monitor shows number of seconds remaining until shutter is released. 44 The self-timer lamp on the front of the camera will blink until one second before the picture is taken, staying lit during the final second to warn that the shutter is about to be released. Press once for 10s delay Press twice for 3s delay Start 1s remaining Shutter released Stays lit Blinks More on Photography Selecting Self-Timer While Using Manual Option When AF area mode ( 91) is set to Manual ( 93) and focus area selection guide is displayed in the monitor, press to hide focus area selection guide and press ( ) to use the self-timer. Stopping the Self-Timer To stop the self-timer before picture is taken, press the shutter-release button twice for a ten-seconds delay, or once for a three-seconds delay. The Self-Timer • When using the self-timer, mount the camera on a tripod (recommended) or rest it on a flat, level surface. • The self-timer is not available in some assist modes ( 27 - 33) or scene modes ( 34 -39). • When shooting pictures using the self-timer, Continuous, 5 shot buffer, Multi- shot 16, BSS and Auto bracketing are not available. Continuous, 5 shot buffer or Multi-shot 16 is automatically set to Single. • When BSS or Auto bracketing is set, the setting will be automatically OFF while the self-timer is ON. 45 Easy Close-Ups: Macro Close-Up Mode Ma -up mode is used for taking close-up shots of small objects at very Easy Close-Ups: Macro Close-Up Mode Ma -up mode is used for...