Assessments - 3, GPA: 3.7 ( )

Fabricante : Shoprider Arquivo Tamanho: 652.14 kb Arquivo Nome : PHFW-111820.pdf Língua de Ensino:

2. Ensure the wheels are in drive mode. 3. Fold up footplates and/or remove the entire leg rest assemblies (see Figures 8, 10 and 11). 4. Disconnect the black and red connectors situated under the seat (Figure 7). 5. Carefully pull out the first rear battery out of the basket by using the lifting strap (battery is heavy). Then pull out the battery basket by lifting up. 6. Slide second battery forward and follow the same steps as 5. to pull out the second battery and basket 7. Remove seat cushion, carefully place hands under the seat bottom and give a sharp pull upward. This will pull the entire frame together (Figure 8). Connectors Lifting Straps Battery Basket Figure 7 Pull Seat Bottom Upward Figure 8 6/25/2004 12 Armrests The armrests are height adjustable and can flip up out of the way for side transfers. To adjust the height, simply pull the knob outward and lift armrest up or down to your comfort. The adjustments are in 1 .” increments. Lift or lower by handle Pull knob outward Pull tab to fold backrest for transport Figure 9 Swing-Away, Detachable Leg Rests The swing away leg rests are detachable. To remove the leg rest, remove the Velcro strap, push silver lever inward, swing leg rest outward and lift up. Figure 10 Figure 11 6/25/2004 13 Negotiating Obstacles Ramps, Slopes and Cambers The FPC-11 indoor/outdoor power chair has the ability to negotiate ramps, slopes and cambers of a low to medium gradient. It is of the utmost importance that the following points are observed: 1. Never attempt to go up or down an incline which has a rough, wet or slippery surface (loose gravel, tree roots, wet grass, polished floor, etc.) 2. Always approach an incline head on, not at an angle 3. Always travel at a speed that you are comfortable with and that you feel in complete control 4. Avoid sudden or erratic action with the joystick 5. When riding along in a straight line you may experience “veering to one side”. This is due to the natural camber in the construction of the pavement. To correct this you simply have to steer slightly against it, as you continue to move forward. 6/25/2004 14 Looking After Your Power Chair Tires Since your tires are flat frees, there is no need to ever worry about tire pressure. Upholstery All upholstery can be washed with warm water and mild soap. Some car upholstery cleaners produce excellent results as well. Occasionally check the seat and back for sagging, cuts and tears. Replace if necessary. To avoid mildew and rapid deterioration of upholstery parts, do not store your chair in damp conditions. Lubrication and General Maintenance All moving mechanisms will benefit from simple lubrication and inspection. Lubricate using petroleum jelly or light oil. Do not use too much oil, drips may stain or damage carpets, furnishing, etc. Always carry out a general inspection of all nuts and bolts for location and tightness. 6/25/2004 15 Batteries & Battery Charging The Shoprider folding power chair is designed to operate on two U1 (2 x 33/34/36 Ah) gel, or sealed lead acid, maintenance free batteries. For easy handling, Velcro or plastic carrying straps are provided to assist in fitting or removal. The duration of the batteries can be affected by temperature, terrain and weight of the user. The battery gauge is a guide on the remaining charge in the batteries. The active user will need to charge the batteries after using approximately more than 30% of battery capacity. As an inactive user, only using from once a week to every other day, the recharge point would be at 50% of discharge. In only using for short distance each day, it is advisable to charge at the end of each week. Batteries should be kept fully charged at all times. They must not be left in a discharged state if not using the unit for some time. The batteries should be checked once a month and recharged as needed. Battery Charging Procedure To recharge the folding power chair, connect the charger to the Charging Port at the front of the VSI referred to as (8) in Figure 2. Switch on the charger. Do not leave the charger plugged into the Charging Port if the charger is not charging. This charger is for indoor use only. Do not expose it to rain or water spray. Do not cover the battery charging vent. One example of indicator light on the charger gives advice as follows: Red -Power on Amber -Battery charging Green -Charging complete Please refer to the LED indicator description based on charging status of the charger. 6/25/2004 16 Troubleshooting The Self-Help Guide (Table 1) is intended to assist in the location of a fault that may occur in a certain part of the power chair. If after checking out the fault from the table below and the fault is still showing, do not use the power chair. Turn off the power and consult your provider immediately. Table 1 BATTERY GAUGE POSSIBLE FAULT 10 Bars flash Battery voltage is too high, Check the battery connections. 9 Bars flash Solenoid brake fault 8 Bars flash Possible joystick controller fault 7 ...

Baixe o seu

Para fazer o download, introduza 2 dígitos :