If a spark arrester is used, it should be maintained in effective working order by the operator. In the State of California the above is required by law (Section 4442 of the California Public Resources Code). Other states may have similar laws. Federal laws apply on federal lands. A spark arrester for the muffler is available through your nearest engine authorized service dealer or contact the service department, P.O. Box 368022, Cleveland, Ohio 44136-9722. FORM NO. 770-8161H SAFETY RULES A WARNING: TO REDUCE THE POTENTIAL FOR ANY INJURY, COMPLY WITH THE FOLLOWING SAFETY INSTRUCTIONS. FAILURE TO COMPLY WITH THE INSTRUCTIONS MAY RESULT IN PERSONAL INJURY. TRAINING • Read this owner’s manual carefully in its entire y before attempting to assemble or operate this machine. Be completely familiar with the controls and the prope r use of this machine before operating it. Keep this manual in a safe place for future and regular reference and far ordering replacement parts. • Children must never be allowed to operate this equipment. • No one should operate this unit while intoxicated or while taking medication that impairs the senses or reactions. • This equipment should never be operated in tho vicinity of children, pets or other persons. • Never run your machine in an enclosed area as the exhaust from the engine contains carbon monoxice, which is an odorless, tasteless and deadly poisonous ge s. • Never place your hands or any part of your body or clothing inside the feeding chamber, discharge chute or near any moving part while the machine or engine is running. • If it is necessary for any reason to inspect or r< ipair the feeding chamber or any part of the machine wher 5 a moving part can come in contact with your body or clothing, stop the machine, allow it to cool, disconnect the spark plug wire from the spark plug and move it away from the spark plug before attempting such inspection or repair. PREPARATION • Wear safety glasses provided with your unit while operating the shredder to prevent injury from any mater al which may be ejected out of the openings. • Wear proper apparel. Avoid wearing loose fitting slothing. Wear gloves when handling material. • HANDLE GASOLINE WITH CARE as it is an em heat or open flame, and out of reach of children. • This machine should be operated only upon a lev 3I surface. • Assure that all screws, nuts and bolts and other fasteners are properly secured. OPERATION • When feeding shreddable material into this equipment, be extremely careful that pieces of metal, rocks, bottles, cans or other foreign objects are not included. Personal injury or damage to the machine could result. • If the cutting mechanism strikes any foreign object or if your machine should start making an unusual noise or vibration, immediately stop the engine, disconnect the spark plug wire from the spark plug and move it away from the spark plug. Allow the machine to stop and take the following steps: Inspect for damage. Replace or repair any damaged parts. Check for any loose parts and tighten to assure continued safe operation. • The engine must be kept clean of debris and other accumulations. • Do not allow an accumulation of processed material to build up in the discharge area as this will prevent proper discharge and can result in kick-back from feed opening. • Never place your hands or any other part of your body or clothing inside the feeding chamber, discharge chute or near any moving part while the engine is running. • Keep all guards and deflectors in place and in good working condition to assure continued safe operation. • Always stand clear of the discharge area when operating this machine. • Keep your face and body back from the feed opening to avoid accidental bounce back of any material. • Do not over-reach. Keep proper balance and footing at all times. • The engine governor settings on your machine must not be altered, changed, or tampered with. The governor controls the maximum safe operating speeds and protects the engine and all moving parts from damage caused by overspeed. • Do not transport machine while engine is running. • Do not operate engine if air cleaner or cover directly over carburetor air intake is removed, except for adjustment. Removal of such parts could create a fire hazard. MAINTENANCE AND STORAGE • When this equipment is stopped for servicing, inspection, storage or to change an accessory, make sure the spark plug wire is disconnected ...
)
