Assessments - 4, GPA: 4.3
(
)
)
|
Facilidade de uso
Do not let water run down through openings in the top of the door. To help prevent water from getting in these slots when cleaning, open the door as far as it will go. 4. Close the oven door and make sure the oven light is off. If the oven light is not turned off, the life of the bulb will be shortened or it may burn out immediately. The door latches automatically after the clean cycle is set. Do not use commercial oven cleaners or oven protectors in or near the self-cleaning oven. A combination of any of these products plus the high clean-cycle temperature may damage the porcelain finish of the oven. Important: The oven door must be closed and all controls must be set correctly for the cycle to work properly. • You can set a clean cycle in both ovens at the same time. The last oven set will automatically delay its start until the end of the first oven’s clean cycle. • You can use Timed Baking in one oven and Self- Clean the other at the same time. (continued next page) OPERATING THE SELF-CLEANING OVEN (continued) How to Set Oven for Cleaning Easy Steps: 1. Press SELF CLEAN. 2. Press the number pads to set the clean time. 3. Press START. SELF CLEAN 1. Follow the steps in the Before a Clean Cycle section. 2. Press SELF CLEAN. 3. Press the number pads to set the clean time, if a time other than 4 hours is needed. Clean time is normally 4 hours. You can change the clean time to any time between 3 to 5 hours, depending on the amount of soil in your oven. START 4. Press START. The door locks automatically. The display will show the clean time remaining. It will not be possible to open the oven door until the temperature drops below the lock temperature and the LOCKED DOOR light goes off. 5. When the LOCKED DOOR light is off, open the door. NOTE: DELAY START • You can find out when the clean cycle will start by pressing DELAY START. • The display will flash and the control will beep if you set the clean cycle and forget to close the oven door. To Stop a Clean Cycle 1. Press CLEAR/OFF. 2. When the oven has cooled below the locking CLEAR temperature and the LOCKED DOOR light goes OFF off, open the door. How to Set Delay Start of Cleaning Easy Steps: 1. Press SELF CLEAN. 2. Press the number pads to set the clean time. 3. Press DELAY START. 4. Press the number pads to set the start time. 5. Press START. Delay Start is setting the oven to start the clean cycle automatically at a later time than the present time of day. NOTE: Before beginning, make sure the oven clock shows the correct time of day. 1. Follow the steps in the Before a Clean Cycle section. 2. Press SELF CLEAN. SELF. CLEAN 3. Press the number pads to set the clean time. 4. Press DELAY START. DELAY START 5. Press the number pads to set the time of day you want the clean cycle to start. 6. Press START. START The door locks automatically. The display will show the start time. It will not be possible to open the oven door until the temperature drops below the lock temperature and the LOCKED DOOR light goes off. 7. When the LOCKED DOOR light is off, the door. NOTE: You can set a delay clean in both ovens at the same time. The second oven set will automatically delay the start of cleaning until the end of the first oven’s clean cycle. After Self-Cleaning You may notice some white ash in the oven. Just wipe it up with a damp cloth after the oven cools. If white spots remain, remove them with a soap-filled steel wool pad. Be sure to rinse thoroughly with a vinegar and water mixture. These deposits are usually a salt residue that cannot be removed by the clean cycle. If the oven is not clean after one clean cycle, repeat the cycle. NOTE: • No functions can be programmed before the door automatically unlocks. • If the shelves have become hard to slide, wipe the shelf supports with cooking oil. (continued next page) OPERATING THE SELF-CLEANING OVEN (continued) Questions and Answers Q. If my oven clock is not set to the correct time of day, can I still self-clean my oven? A. If the clock is not set to the correct time of day you will not be able to set a delay clean to end at a specific time. Q. Can I use commercial oven cleaners on any part of my self-cleaning oven? A. No cleaners or coatings should be used around any part of this oven. If you do use them and do not thoroughly rinse the oven with water, wiping it absolutely clean afterwards, the residue can scar the oven surface and damage metal parts the next time the oven is automatically cleaned. Q. Can I clean both ovens at the same time? A. No. There is too much heat. The control only allows one oven to clean at a time. Q. What should I do if excessive smoking occurs during cleaning? A. This is caused by excessive soil. Turn the oven off. Open the windows to rid the room of smoke. Wait until the oven has cooled and the words “LOCKED DOOR” are off in the display. Wipe up the excess soil and reset the clean cycle. Q. Is the “crackling” or “popping” sound I hear during cleaning normal? A. Yes. This is the sound of...