Assessments - 5, GPA: 4.2
(
)
)
|
Facilidade de uso
Supplied with food probes to constantly monitor and control internal food temperature throughout the cooking and holding stages. • Slow convected air system promotes natural browning for flavor and seals in natural juices. • Moist heat, dry heat or a combination of both allows for a • variety of food preparation and holding. • Full 8200 Watts of power allows for reheating of prepared • meals or bulk items. Maximum temperature 350°F. (176.5°C.). • 1850 Watt water heater with separate control and low water indicator. • Energy Management Logic system electronically directs power to where it’s needed most during different operating cycles. • Pre-setting automatic controls for roasting and holding cycles allows for unattended operation 24 hours a day. • Roast and hold over 300 lbs. (136 kg.) of meat in just • 7 sq. ft. of floor space. • Non-venting oven, permitted by most local codes, provides • easy, inexpensive installation. • 304 stainless steel construction throughout for ease of cleaning. • Smooth interior coved corners prevent food particle/grease buildup. CO-151-FPW-UA-12B-Q1 • Pass-thru design allows easy access from preparation and serving areas. • Field reversible insulated Dutch doors prevent temperature • • loss. Silicone door gaskets for proper seal. High temperature ceramic magnetic latches for “easy open” and security during • transport. Latches and hinges mounted inboard. • Standard with right hand hinging; left hand hinging available NSF4 upon request. ACCESSORIES and OPTIONS • Recessed push/pull handles on both sides prevent damage (Available at extra cost): • to walls; allows easy maneuvering. Security Panel for Controls • Non-corrosive stainless steel wire universal angles accommodate a Tempered Glass Door Windows large variety of pan sizes on adjustable 1-1/2" spacing. Supplied with 12 sets of angles and six raised wire grids. Key Lock Latches • Heavy duty 5" swivel casters, two with brakes. Provides mobility Extra Wire Grids when fully loaded. Extra Universal Angles Side Bumpers POWER UNIT OPTIONS: Set of 5 preset menu item switches • 8200 Watts, 208 Volts, 1 Phase, 60 Hz. (up to 10 presets allowed) • 8200 Watts, 240 Volts, 1 Phase, 60 Hz. 50 Cycle Service • 8200 Watts, 208 Volts, 3 Phase, 60 Hz. • 8200 Watts, 240 Volts, 3 Phase, 60 Hz. o See page E-10 for accessory details. ®®® CSANITATION CLASSIFIED CLASSIFIED TO ® 5925 Heisley Road • Mentor, OH 44060-1833 Page E-1.2 Phone: 877/CRESCOR • Fax: 440/350-7267 Sept., 2004 CO-151-FPW-UA-12B-Q1 DETAIL OF PAN SLIDE CRES COR PAN DIM “A” DIM “B” DIM “C” INSIDE DIMENSIONS WEIGHT ACT.MODEL NO. CAP/ANGLES SIZE WIDTH DEPTH HEIGHT WIDTH DEPTH HEIGHT CO-151-FPW-UA-12B-Q1 12 SETS SEE NOTE BELOW IN 28-3/4 37-3/4 73-1/2 21-1/4 26-1/2 58 LBS 403 MM 740 960 1870 540 675 1475 KG 183 NOTE: Refer to pan size chart at end of section. ALL CONSTRUCTION IS RIVETED, WELDED AND FINISHED. CABINET: • Body: 22 ga. 304 stainless steel. • Reinforcement: Internal framework of 16 ga. stainless steel. • Insulation: Fiberglass, thermal conductivity (K factor) is .23 at 75°F. 1-1/2" in back wall, doors, base; 2" in side walls. • Water pan: 4 Gallons; 16 ga. stainless steel with 1850 Watt heater and with petcock drain; mounted to base. • Drip trough: Formed 18 ga. stainless steel; mounted to lower front and rear of cabinet; removable drip pan. • Air tunnels (2): 20 ga. stainless steel, lift-out type, mounted on side walls. • Push/pull handles (4): 7" vertical; recessed. BASE: • One piece construction, .125 aluminum. • Casters: 5" dia., swivel, modulus tires, 1-1/4 wide, load cap. 250 lbs. each, temp. range -45°/+180°F. Delrin bearings. Front casters equipped with brakes. DUTCH DOORS: • Field reversible. • Formed 22 ga. 304 stainless steel. • Latches: Chrome plated zinc with composite handle, ceramic magnetic type; mounted inboard. • Hinges: Heavy duty chrome plated zinc, mounted inboard. • Gaskets: Perimeter type, silicone. • Pan stops: Embossed. PAN SLIDES: • Stainless steel wire universal angles (.306 dia.) mounted on lift-out posts. • 12 sets of angles adjustable on 1-1/2" centers. • Grids (6): Nickel chrome plated steel, raised wire 17" x 25". POWER REQUIREMENTS AVAILABLE: • 8200 Watts, 208 Volts, 60 Hz., 1 phase, 39 Amps., 50 Amp. service. • 8200 Watts, 240 Volts, 60 Hz., 1 phase, 34 Amps., 50 Amp. service. • 8200 Watts, 208 Volts, 60 Hz., 3 phase, 23 Amps., 30 Amp. service. • 8200 Watts, 240 Volts, 60 Hz., 3 phase, 20 Amps., 30 Amp. service. ® 5925 Heisley Road • Mentor, OH 44060-1833 Phone: 877/CRESCOR • Fax: 440/350-7267 © Crescent Metal Products, Inc. 1998 All rights reserved. POWER UNIT COMPONENTS: (refer to above drawing) • Body:Formed 304 stainless steel with black control panel, recessed and tilted 7°. A) Thermostat (microprocessor) • Holding up to 250°F (121°C) • Cook/Retherm up to 350°F(176.5°C) • Thermometer B) Thermostat (humidity): Solid state C) Switch: Lighted ON-OFF rocker type. D) Pilot light for low water level. • Power cord...