Assessments - 0, GPA: 0
(
)
)
|
Facilidade de uso
Optimising the lifetime of the rechargeable
Note: If the battery is completely empty, wait a few minutes
EnGlIsH
battery
before you switch on the appliance.
Introduction
When you have charged the appliance for the first time,
Cleaning
Congratulations on your purchase and welcome to
we advise you to use it until the battery is completely
Never use scouring pads, abrasive cleaning agents or
Philips! To fully benefit from the support that Philips offers, empty.
aggressive liquids such as alcohol, petrol or acetone to
register your product at www.philips.com/welcome.
Do not recharge the appliance in between the trimming
sessions.
clean the appliance.
General description (Fig. 1)
Continue to use the appliance until the motor almost
1 Make sure the appliance is switched off and
A Beard trimming comb
stops running during a session. Then recharge the battery.
disconnected from the mains.
B Cutting unit
Follow this procedure at least twice a year.
2 Remove the beard trimming comb.
C Precision Zoom Lock ` adjustment ring
Trimming
D Charging light
3 Open the cutting unit (Fig. 10).
E Socket for appliance plug
Always comb the beard and/or moustache with a fine
4 Clean the cutting unit and the inside of the
F On/off slide
comb before you start trimming.
appliance with the cleaning brush supplied (Fig. 11).
G Adapter
When you trim for the first time, be careful. Do not
H Appliance plug
move the trimmer too fast. Make smooth and gentle
5 Push the cutting unit back onto the appliance to
I Cleaning brush
movements.
close it (‘click’) (Fig. 12).
Note: The appliance does not need any lubrication.
Important
Trimming with beard trimming comb
Read this user manual carefully before you use the
1 Turn the Precision Zoom Lock ` adjustment ring
Replacement
appliance and save it for future reference.
to the desired setting. (Fig. 4)
Only replace a worn or damaged cutting unit with an
Danger
See the table below for an overview of the settings and
original Philips cutting unit, available from authorised
- Make sure the adapter does not get wet.
the resulting hair lengths.
Philips service centres.
Warning
1 Open the cutting unit.
- The adapter contains a transformer. Do not cut
Setting
Resulting hair length
2 Pull the old cutting unit upwards to remove
off the adapter to replace it with another plug, as
it (Fig. 13).
this causes a hazardous situation.
1
1mm
- This appliance is not intended for use by persons
3 Insert the two lugs of the new cutting unit into the
(including children) with reduced physical, sensory
2
2mm
guiding slots (Fig. 14).
or mental capabilities, or lack of experience and
4 Push the cutting unit back onto the appliance
knowledge, unless they have been given supervision
3
3.5mm
(‘click’) (Fig. 12).
or instruction concerning use of the appliance by a
person responsible for their safety.
4
5mm
Environment
- Children should be supervised to ensure that they
- Do not throw away the appliance with the normal
do not play with the appliance.
5
7mm
household waste at the end of its life, but hand it in
Caution
at an official collection point for recycling. By doing
- Use, charge and store the appliance at a temperature
6
9mm
this, you help to preserve the environment (Fig. 15).
between 5°C and 35°C.
- The built-in rechargeable battery contains substances
- Only use the adapter supplied.
7
11.5mm
that may pollute the environment. Always remove
- Never immerse the appliance in water or rinse it
the battery before you discard and hand in the
under the tap.
8
14.5mm
appliance at an official collection point. Dispose of
- If the adapter is damaged, always have it replaced
the battery at an official collection point for batteries.
with one of the original type in order to avoid a
9
18mm
If you have trouble removing the battery, you can
hazard.
also take the appliance to a Philips service centre.
- This appliance is only intended for trimming the
The setting appears in the window below the Precision
The staff of this centre will remove the battery for
human beard. Do not use it for any other purpose.
Zoom Lock ` adjustment ring.
you and will dispose of it in an environmentally safe
- Do not use the appliance if the cutting unit or the
way. (Fig. 16)
beard trimming comb is damaged or broken, as this
Note: When you trim for the first time, start at the highest
Removing the rechargeable battery
may cause injury.
setting (9) to familiarise yourself with the appliance.
- Noise level: Lc = 64 dB(A).
2 Switch on the appliance.
Only remove the rechargeable battery if it is completely
Electromagnetic fields
3 To trim most effectively, move the trimmer against
empty.
This Philips appliance complies with all standards
the hair growth direction. Make sure the surface
1 Disconnect the appliance from the mains and let
regarding electromagnetic fields (EMF). If handled
of the comb always stays in contact with the
the appliance run until the motor stops.
properly and according to the instructions in this user
skin (Fig. 5).
manual, the appliance is safe to use based on scientific
2 Undo the screw in the housing of the
evidence available today.
4 If a lot of hair has accumulated in the beard
trimmer (Fig. 17).
trimming comb, remove the comb and blow and/or
General
shake the hair out of it. The selected setting does
3 Separate the 2 housing parts with a
- The appliance is equipped with an automatic voltage
not change when you do this (Fig. 6).
screwdriver (Fig. 18).
selector and is suitable for mains voltages from 100
4 Cut the wires close to the battery holder with a
to 240 volts.
Never pull at the flexible top of the beard trimming
pair of household scissors (Fig. 19).
- The adapter transforms 100-240 volts to a safe low
comb. Always pull at the bottom part.
voltage of less than 24 volts.
Trimming at the unique ‘stubble look’ setting 5 Remove the battery holder with the rechargeable
battery (Fig. 20).
Charging
1 To create a ‘stubble look’, trim with the beard
6 Use a screwdriver to pry the battery off the
Charge the appliance fully before you use it for the first
trimming comb set to setting 1 (Fig. 7).
printed circuit board (Fig. 21).
time.
Trimming without beard trimming comb
It takes approximately 10 hours to fully charge the
Use the trimmer without beard trimming comb to trim
Do not connect the appliance to the mains again after
appliance.
full beards and single hairs.
you have opened it.
When it is fully charged, the appliance has a cordless
Guarantee & service
operating time of up to 35 minutes.
1 Pull the beard trimming comb off the
appliance (Fig. 8).
If you need service or information or if you have a
Note: You can use the appliance cordless as well as
problem, please visit the Philips website at
connected to the mains.
Never pull at the flexible top of the beard
trimming comb. Always pull at the bottom part.
www.philips.com or contact the Philips Consumer Care
1 Make sure the appliance is switched off (Fig. 2).
Centre in your country (you find its phone number in
2 Switch on the appliance.
the worldwide guarantee leaflet). If there is no Consumer
2 Insert the appliance plug into the appliance (Fig. 3).
3 Make well-controlled movements. Touch the hair
Care Centre in your country, go to your local Philips
3 Put the adapter in the wall socket.
lightly with the trimmer (Fig. 9).
dealer.
, The charging light on the appliance goes on to
indicate that the appliance is charging.
Corded trimming
If the battery is low, you can also use the appliance from
Note: The charging light does not change colour and does
the mains:
not go out when the appliance is fully charged.
1 Switch off the appliance, insert the adapter in the
4 After charging, remove the adapter from the
wall socket and wait a few seconds before you
wall socket and pull the appliance plug out of the
switch on the appliance.
appliance.
2
4222.002.8021.3
... Este manual também é adequado para os modelos :
Eléctrico - QT4021 (652.84 kb)