Assessments - 3, GPA: 3.7
(
)
)
|
Facilidade de uso
(Turn the dial in the counter clockwise direction and match the mark to the open position.) (Fig.2A) 2. Insert the two CR123A lithium batteries as shown in the figure.Make sure that their polarity matches that indicated inside battery compartment (Fig.2B). If the batteries are not inserted properly, the shaver will not operate. Do not mix a new battery with an old one. Always replace with 2 new fresh batteries. 3. Replace the battery cover with the dial mark at open. Check for proper sealing of the water-proofing ring. 4. After replacing the battery cover to the main unit, turn the dial mark to close. (Fig. 2C) For a better shave Put a thin layer of shaving foam on your face which works as lubricator. Shaving foam is the most suitable among many other shaving aids (gel, soap, cream, etc). Do not put a thick layer of shaving foam as it may affect shaver’s performance. If the shaving head is clogged with foam, simply rinse it under running water. Depress the switch lock button and slide the On/Off switch upward to turn the shaver on. Hold the shaver at a right angle (90°) to your skin (see fig. 3). Start out shaving by applying gentle pressure to your face. Stretch your skin with your free hand and move the shaver back and forth in the direction of your beard. You may gently increase the amount of pressure as your skin becomes accustomed to this shaver. Applying excessive pressure does not provide a closer shave. 5 System outer foil (see fig. 4) The system outer foil has a slit blade (a) between two foils (b).They move up and down independently to follow the contours of your face. The slit blade catches and cuts longer and lying hairs easily. Cleaning your shaver (see fig. 5) For cleanliness and convenience, we recommend that you clean your shaver with water and a liquid hand soap. Regular cleaning will keep your shaver in good condition while preventing odors or bacteria from developing, and maintain the cutting performance. With the system outer foil in place, apply some hand soap onto the outer foil. Turn the shaver on and pour some water over the outer foil. After about 10-20 seconds, turn the shaver off. Remove the foil frame and clean it with running water. Wipe off any moisture from the shaver with a dry cloth and remove the protective cap to allow the system outer foil to dry completely. Brush cleaning Squeeze the system outer foil release buttons and lift the system outer foil upward to remove it (see fig. 6). Remove the inner blade by grasping it firmly at both ends and pulling it straight away from the shaver (see fig. 7). Clean the outer foil, the shaver body the long side of the brush. Clean the inner blade with the short side of the brush. Do not use the short brush to clean the outer foil (see fig. 8). Replacing shaving head components It is recommended that you replace the outer foil at least every year and the inner blade at least every two years to maintain your shaver’s cutting performance. Replacing the system outer foil (see fig. 6) Squeeze the outer foil release buttons and lift the outer foil upward to remove it. To insert the new outer foil, press down until it snaps into place. Replacing the inner blades (see fig. 7) Squeeze the system outer foil release buttons and lift the system outer foil upward to remove it. Remove the inner blade by grasping it firmly at both ends and pulling straight away from the shaver. To insert the new inner blade, hold the blade at both ends and press downward until it snaps into place. Caution • The outer foil is very thin. If handled improperly, it can be easily damaged.To avoid personal injury, do not use the shaver if it has a damaged foil or inner blade. • Do not take the housing apart as this can affect the watertight construction. • If the shaver is not used for a long time, remove the batteries to prevent possible leakage. • Do not use other batteries than Panasonic. • Do not use new battery with old one as the battery’s life is reduced. 6 • Close supervision is necessary when this shaver is used by, on or near children or invalids. • Never drop or insert any object into any opening. • Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered. Specifications Power source: 6.0 V DC (2 CR123A litium batteries) Weight: 5.5oz (155g) This product is intended for household use only. READ ALL INSTRUCTIONS BEFORE USE. FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED ATOLL-FREE (IN USA ONLY) NATIONAL ACCESSORY PURCHASE HOT LINE AT 1-800-338-0552. 7 Antes de su utilización Esta afeitadora para uso en húmedo/seco puede ser empleada para afeitarse tanto con espuma o jabón de afeitar como en seco. Además, por ser totalmente hermética, puede utilizar esta afeitadora mientras se está duchando y limpiarla con agua. Al principio y durante al menos tres semanas, procure afeitarse con jabón y notará la diferencia. Será necesario un cierto tiempo para que se, acostumbre...