Assessments - 0, GPA: 0 ( )

Fabricante : Philips Arquivo Tamanho: 518.94 kb Arquivo Nome : Língua de Ensino:

. Only use the HQ8000 powerplug and the charging stand supplied to charge the shaver. . The powerplug is suitable for mains voltages ranging from 100 to 240 volts. . The powerplug contains a transformer. Do not cut off the powerplug to replace it with another plug, as this will cause a hazardous situation. . The powerplug transforms 100-240 volts to 12 volts. C . Make sure the HQ8000 powerplug and the charging stand do not get wet. C . The shaver runs at a safe low voltage of 12 volts. It is watertight and can be cleaned under the tap. Do not rinse the shaver with water hotter than 80cC. . For the best shaving results, shaving emulsion should be pumped up frequently. . If the mains cord of this appliance is damaged, it must always be replaced by Philips or a service centre authorised by Philips in order to avoid hazardous situations. . Noise level: -Shaver + shaving unit: Lc = 61-65 dB(A) -Shaver + trimmer : Lc = 60-64 dB(A) C C ENGLISH Charge indications C . As soon as you start charging the empty shaver, the green pilot light goes on. . When the batteries have been fully charged, the green pilot light starts blinking. . The red pilot light blinks when the batteries are almost empty. . When the batteries are almost empty, the red pilot light blinks a few times after the shaver has been switched off. Charging Insert the small plug into the charging stand and put the powerplug in the wall socket. Place the shaver in the charging stand. Press until you hear a click. Recharge, store and use the appliance at a temperature between 5cC and 35cC. 1 2 3 The shaver automatically switches off when placed in the charging stand. 4 When charging for the first time or after a long period of disuse: leave the shaver to charge continuously for 4 hours. Charging normally takes approx. 1 hour. A fully charged shaver has a cordless shaving time of up to approx. 55 minutes. 6 ENGLISH Inserting cartridges C C C 1 2 The car tridges with moisturising NIVEA FOR MEN shaving emulsion are available in boxes containing five car tridges and one small plastic pump. Do not throw the pump away: you will need it for all five car tridges! Use only Philishave NIVEA FOR MEN Cool Skin (HQ160 or HQ161) car tridges. For hygienic reasons, we advise you to inser t a new pump when you star t using a new set of five car tridges. Inserting the first cartridge 1 2 3 Take one cartridge from the box.Take the pump (supplied in the same box) out of its bag and push it into the cartridge until it locks into position with a click. Move the release slide downwards and open the cover of the cartridge compartment. Slide the cartridge with the pump into the shaver. It only fits properly if the white side of the pump is pointing upwards. Close the cover. C ENGLISH 4 Press the yellow pump button a few times until the NIVEA FOR MEN shaving emulsion appears.The shaver is now ready for use. Do not throw the pump away when you replace an empty car tridge.You will need it for the other car tridges. The NIVEA FOR MEN shaving emulsion in this car tridge will keep when stored at temperatures between...

Baixe o seu

Para fazer o download, introduza 2 dígitos :