Assessments - 0, GPA: 0
(
)
)
|
Facilidade de uso
The shaver has a special compartment for cartridges containing Nivea for Men moisturising shaving emulsion. This emulsion is applied to the skin during shaving. The Nivea for Men shaving emulsion prepares the skin and beard for the shave, ensuring that the shaver moves smoothly over your face and makes perfect contact with the skin. You will enjoy an unexpectedly close and comfortable shave and your skin will feel soft and fresh afterwards. After shaving, you can clean the appliance by simply rinsing it under a hot tap. Important Allow your skin at least two weeks to become accustomed to the Philishave shaving system. Do not press the shaver too hard against the skin while shaving! With this shaving system, you can shave when your skin is either wet or dry. The Nivea for Men shaving emulsion has an immediately moisturising effect on the skin. Remove the cartridge and clean the shaver if you are not going to use the appliance for more than one week. To obtain the best shaving results, it is necessary to follow the instructions in the ‘Cleaning and maintenance’ section. Charging the shaver Important: only leave the shaver to charge in a dry place! First put the plug in the appliance and then put the Powerplug in the socket. The Powerplug has an automatic voltage selector and is suitable for mains voltages ranging from 100 to 240 Volts. The pilot light near the ON/OFF button will go on. It will take the appliance approximately 8 hours to recharge completely. A fully recharged shaver has a shaving time of approximately 30 minutes. The shaver has been equipped with a ‘battery low’ indication: the pilot light will light up when the battery is running low. About the built-in battery The shaver has been equipped with a built-in rechargeable battery. To prolong the life of the battery, recharge and store the appliance at a temperature between +5°C and +35°C. Also make sure that you disconnect the shaver from the mains when you are not recharging it. 1 2 Inserting the cartridge The cartridges with moisturising Nivea for Men shaving emulsion are available in boxes containing five cartridges and one plastic connector. Do not throw the connector away; you will need it for all five cartridges! Use only Philishave Nivea for Men Cool Skin cartridges (HQ 150). Inserting the first cartridge ¦ Take one cartridge from the box. Take the connector (supplied in the same box) out of its bag and push it into the cartridge until it seats with a click. ¦ Push the release slide downwards and remove the cover from the cartridge compartment. ¦ Slide the cartridge with inserted connector into the shaver. Replace the cover and close it. Replacing an empty cartridge ¦ Push the release slide downwards and remove the cover from the cartridge compartment. Remove the empty cartridge and pull out the connector. Note: do not throw the connector away! ¦ Insert the connector into a new cartridge. It has been properly inserted when it seats with a click. ¦ Slide the new cartridge with the connector into the shaver. Replace the cover and close it. About the cartridge The Nivea for Men shaving emulsion in this cartridge will keep when it is stored at a temperature between 0°C and +40°C. 4222 001 83073 Shaving Switch on the shaver by pressing the ON/OFF button. Hold the shaver against the skin. Press the yellow pump button to apply Nivea for Men shaving emulsion to the skin. When sufficient shaving emulsion has been released, start moving the shaving heads rapidly over your skin, making both straight and circular movements. The shaver is suitable for use in the shower. Grooming sideburns and moustaches Trimmer The shaver has a separate trimmer for grooming sideburns and moustaches. Fitting the trimmer onto the shaver Switch off the shaver. Clean the shaver before you assemble the trimmer. Press the release button and pull the shaving unit off the shaver. Fit the trimmer onto the shaver. Removing the trimmer Press the release button and remove the trimmer. 3 3 Cleaning and maintenance If you were charging the appliance, pull the Powerplug out of the wall socket and remove the appliance plug from the shaver . Clean the shaving unit with very hot water after every shave. The shaver is fully water resistant and therefore allows easy and quick cleaning. Important: the Powerplug is not waterproof. Prevent it from getting wet and do not immerse it in wate...
Este manual também é adequado para os modelos :Eléctrico - HQ563/18 (121.08 kb)