Removal of guarding could expose elec= trically charged components and result in electrocution. HOW TO PRI:VENT iT Operate generator in a clean, dry, well ventilated area. Make sure hands are dry before touching unit. Inspect extension cords before use and replace with new if required. Use proper size (wire gauge) cordset for application. Always use electrically grounded cordset. Place generator on low conductivity surface such as a concrete slab. Read the load rating chart and instructions on p

Keep this manual with the equipment. If the equipment is traded or sold, give the manual to the new owner. You are now the owner of a Armstrong Power generator powered by CUMMINS engine. All our components keep the highest standards in quality, efficiency and durability. Each unit pass thru a complete test and inspection to guarantee the quality of your unit. We provide warranty on every component subject to the warranty coverage and limitations. To get the best results from your new generator p

Box 1097 AOC@Vermontel.net Norwich, VT 05055 Table of Contents WARNING........................................................................................... iv DISCLAIMER...................................................................................... v Part I....................................................................................................... 1 1.0 Introduction........................................................................................ 3 1.1 Manual Use...

The unit will run on natural gas or LP gas, but it has been factory set to run on natural gas. Section 1 — General Information Bryant Air-cooled 7 kW, 12 kW and 15 kW Generators Should the primary fuel need to be changed to LP gas, the fuel system needs to be reconfigured. See Section 1.9 for instructions on reconfiguration of the fuel system. Recommended fuels should have a Btu content of at least 1,000 Btus per cubic foot for natural gas; or at least 2,520 Btus per cubic foot for LP gas. Ask t

CB TERMINAL COVERS IS SUPPLIED WITH CIRCUIT BREAKERS. (2) 2/3 QTY. 2 POLE & 3 POLE CB. 1 0G0056 0G1155 0F9677 0G0959 2 0G0057 0F9664 0G0058 0G0184 0G0059 0G0183 3 0C9708 4 SEE ENGINE EV 5 SEE ENGINE EV 6 0F5767B 7 0E5706 8 0F7874 9 0G0587 10 038150 11 023454 12 077043F 13 04576100BU 14 052646 15 043123 16 051779 17 0A2601 18 0A2602 19 0F8408 20 046526 21 0C3993 22 022264 23 * 047248 24 * 070892 25 0G0588 1 RTR-2390--35KD1 CPL 1 RTR-2390--35KD1 CPL (G2) 1 RTR-2390--45KD1 CPL 1 RTR-2390--45KD1 CPL

Table of Contents Section 1 Product Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 Safety Notice . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 Responsibility . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

The 1 st and 2nd square are PAL coded. This section indicates the proper functioning of the color demodulator part. The third section consists of four squares which are color coded but should not show any color at a well aligned color television or monitor: all four squares should be grey. Both R-Y squares are NTSC coded: the R-Y signal does not change direction 180° each line. The burst signal is PAL coded and ensures normal operation of the PAL switch in a color receiver. The third and fourt

No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose, without the express written permission of Fujitsu Limited. © 1996-2005 Fujitsu Limited. All Rights Reserved. Preface The "NetCOBOL J Adapter Class Generator" is a tool that generates a COBOL class (adapter class) used to call a Java class. Using the adapter class thus generated makes the Java class library available from COBOL. A Java runtime environment must be insta

Keep children, pets and others away from area of operating RISK OF UNSAFE OPERATION HAZARD WHAT COULD HAPPEN HOW TO PREVENT IT Operation of generator in careless man-All sources of energy include the po• Review and understand all of the ner. tential for injury. Unsafe operation or operating instructions and warn- maintenance of your generator could ings in this manual. lead to serious injury or death to you or • Become familar with the operation others. and controls of the generator. Know how to