For details about setting up the projector, see the Setup Guide. ..Be sure to keep all user documentation handy for future reference. * USB Port Models • DLP is a registered trademark of Texas Instruments of the United States. • Microsoft, Windows, and Windows Vista are registered trademarks or trademarks of Microsoft Corporation in the United States and other countries. • HDMI, the HDMI Logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing, LLC.

Pointers can be used during a presentation to indicate or highlight a specific part of the image. Note Depending on the pointer style you are using, the pointer may not display properly when you are using keystone correction. If this happens, use the [KEYSTONE +] and [KEYSTONE –] keys to change the keystone correction value to zero. To display a pointer in the image 1. Press the [POINTER] key. • This will cause a pointer to appear in the image. • You also can use the setup menu to specify the po

When this happens, use this setting to adjust the frequency manually. Important! If, for some reason, your manual frequency settings cause the image input from the computer to disappear from the projection, you can press the [AUTO] key to perform an auto adjust operation, which should cause the image to appear. Phase R Signal Specific When there is flickering in the projected image while RGB is selected as the input source, it means that the phase setting is not correct. When this happens, use t

Confirm LIGHT : – that the POWER/STANDBY indicator is lit red (without flashing). After checking the POWER/STANDBY indicator, disconnect the power cord TEMP : Red steady from the projector and wait for all of the projector’s indicators to go out. Message : – Next, reconnect the power cord and turn projector power back on. If the error occurs again when you turn power back on, contact your retailer or nearest authorized CASIO Service Center. POWER : Amber flashing • The projector was turned off a

2. Adjust digital piano tuning, or turn the digital piano off and then back on again. 3. Change the octave shift setting to 0. 4. Change the temperament setting to “00:Equal”, which is the standard modern tuning. .. E-22 .. E-22 .. E-22 .. E-22 Nothing happens when I press a pedal. The pedal cord is not connected. Connect the pedal cord correctly. .. E-30 Tones and/or effects sound strange. Turning power off and then back on again does not eliminate the problem. Example: Note intensity does not